MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name INK UV2005 VER.5
ITW TRANS TECH
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
SOLVENT NAPHTHA(Petroleum) light 64742-95-6 <1 n.av.
aroma
BARIUM SULPHATE 7727-43-7 2.5 - 10 OSHA PELs: 10 mg/m3
ACGIH TLVs: N/A
DIPHENYL(2,4,6-TRIMETHYLBENZOL)PH 75980-60-8 1 - 2.5 OSHA PELs: N/A
ACGIH TLVs: N/A
N-BUTYLACETATE 123-86-4 25 - 50 ACGIH TLV: 713 mg/m3
3 HAZARDS IDENTIFICATION
Potential Health Effects, Skin
Skin contact may lead to degreasing with resultant dry skin, cracking, irritation and dermatitis.
Potential Health Effects, Eye
Eye contact causes irritation, redness, tearing, blurred vision. Vapors may cause severe eye irritation, redness, tearing
and blurred vision.
Potential Health Effects, Inhalation
Excessive vapor concentration in air, especially in confined spaces, may cause asphyxiation. Excessive inhalation of
vapors can cause nasal, throat and respiratory irritation, dizziness, weakness, fatigue, nausea, headache and possible
unconsciousness.
Potential Health Effects, Ingestion
Swallowing may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Signs & Symptoms of Short-Term (Acute) Exposure
Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Reports have associated
repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage.
Effects of Long-Term (Chronic) Exposure
Health studies have shown that many solvents pose potential human health risks which may vary from person to person.
As a precaution, exposure to liquids and vapors should be minimized.
-Prolonged or continuous inhalation of vapors may result in delayed lung damage.
-Repeated or prolonged inhalation of vapor may cause liver and kidney damage.
-Repeated inhalation of vapor in high concentration can change the blood picture.
Printed On 30-Mar-06
ND = No Data NA = Not Applicable NI = Not Indicated
606 INK UV2005 VER.5
Material Id Trade Name 1/ 4
4 FIRST AID MEASURES
Skin
Wash in soap and water, and rinse with water. DO NOT use solvents or thinners.
Eye
Remove contact lenses, keep eyelids open. Flush with plenty of water (10-15 minutes). Call a physician.
Inhalation
Take the casualty into the fresh air and keep warm. Irregular breathing/no breathing: artificial respiration. Call a
physician.
Ingestion
Do not induce vomiting. Call a physician. Keep at rest.
Medical Conditions Aggravated by Exposure
This product is unlikely to harm health, given normal and proper handling and hygienic precautions. Prolonged inhalation of
vapors in high concentrations may lead to headache, giddiness and nausea. In case of contact with the product danger of
resorption through the skin, irritation of skin/mucous membranes.
In all cases of doubt or when symptoms persist, seek medical attention. Never give anything by mouth to an unconscious
person. Unconsciousness: lateral position - call a physician.
5 FIRE FIGHTING MEASURES
Extinguishing Media
Suitable: alcohol resistant foam, CO2, powders, water spray.
Not suitable: water jet
Basic Fire Fighting Procedures
Fire will produce dense black smoke. Exposure to decomposition products may cause a health hazard. Appropriate
breathing apparatus may be required.
Unusual Fire & Explosion Hazards
Cool endangered containers with water in case of fire. Do not allow the quenching water into the sewage system.
25 潞C approx.
Flash Point
1.2
Flammability Limits in Air, Lower, % by Volume
7.5
Flammability Limits in Air, Upper, % by Volume
6 ACCIDENTAL RELEASE MEASURES
Emergency Action
Contain and collect spillage with non-combustible absorbent materials, e.g. sand, earth, vermiculite, diatomaceous earth
and place in container for disposal according to local regulations. Clean preferably with a detergent. Avoid use of solvents.
Environmental Precautions
Do not empty into drains. If the product contaminates lakes, rivers or sewer systems, inform appropriate authorities in
accordance with local regulations.
Spill or Leak Procedure
Remove sources of ignition. Ventilate area.
Printed On 30-Mar-06
ND = No Data NA = Not Applicable NI = Not Indicated
606 INK UV2005 VER.5
Material Id Trade Name 2/ 4
7 HANDLING & STORAGE
Handling
Prevent the creation of flammable or explosive concentrations of vapor in air and avoid vapor concentration higher than the
occupational exposure limits. The product should only be used in areas from which all naked lights and other sources of
ignition have been excluded. Comply with the health and safety at work laws.
Vapors are heavier than air and may spread along floors. Vapors may form explosive mixtures with air. Preparation may
change electrostatically: always use earthing leads when transferring from one container to another. Operators should wear
antistatic footwear and clothing. No sparking tools should be used.
Storage
Containers which are opened must be carefully resealed and kept upright to prevent leakage. Keep container tightly closed.
Never use pressure to empty: container is not a pressure vessel. No smoking. Prevent unauthorized access. Always keep
in containers of same material as the original one. Avoid heating and direct sunlight. Keep away from oxidizing agents, from
strongly alkaline and strongly acid materials.
Ventilation
Provide adequate ventilation. Where reasonably practicable this should be achieved by the use of local exhaust ventilation
and good general extraction. If these are not sufficient in maintaining concentrations of particles and solvent vapor below
the OEL, suitable respiratory protection must be worn.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Safety goggles.
Skin Protection: Personal Protection Equipments (PPE)
Protective gloves. After washing hands replace lost skin fat by bat containing skin creams.
Respiratory Protection: Personal Protection Equipments (PPE)
If workplace limits are exceeded, a gas mask approved for this particular job must be worn.
General
Personal should wear antistatic clothings made of natural fiber or of high temperature resistant synthetics fiber. All parts of
the body should be washed after contact.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Colored paste with odor of organic solvent
> 124 潞C
Boiling Point
1.24 (H20=1)
Specific Gravity
n.a.
Melting Point
26.7
Percent Volatile
12.5 approx.
Vapor Pressure
n.a. (Butyl Acetate =1)
Evaporation Rate
<1
Vapor Density
no
Solubility In Water
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable under recommended storage and handling conditions (see section 7)
Incompatability: Keep away from oxidizing agents, strongly alkaline and strongly acid materials in order to avoid
exothermic reactions.
Printed On 30-Mar-06
ND = No Data NA = Not Applicable NI = Not Indicated
606 INK UV2005 VER.5
Material Id Trade Name 3/ 4
Hazardous Reactions/Decomposition Products
When exposed to high temperatures may produce hazardous decomposition products such as carbon monoxide and
dioxide, smoke, oxides of nitrogen.
Hazardous Polymerization
none.
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Inhalation, skin contact, eye contact, ingestion
12 ECOLOGICAL INFORMATION
13 DISPOSAL CONSIDERATIONS
Waste Disposal
According to state and local regulations.
14 TRANSPORT INFORMATION
Department of Transportation (DOT) Requirements:
General Transportation Information for Bulk Shipments
Proper Shipping Name Paint Related Material
UN/NA Code 1263
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 2 Flammability 3 Reactivity 1 Personal Prot. Equip. C
16 OTHER INFORMATION
Disclaimer
The details in this material safety data sheet satisfy national legislation. However, we have no knowledge or control over
the individual user's working conditions. The product may not be used for any purpose other than that specified in the
product data sheet unless written consent has been obtained. The user is responsible for the observance of all required
statutory provisions.
3/30/2006 Replaces Sheet Dated
Completed On
Completed By
Printed On 30-Mar-06
ND = No Data NA = Not Applicable NI = Not Indicated
606 INK UV2005 VER.5
Material Id Trade Name 4/ 4
|