MATERIAL SAFETY DATA SHEET
1 CHEMICAL PRODUCT & COMPANY IDENTIFICATION
Trade Name SILICONE RUBBER QUALITY 3 - PART 1 OF 2
253
MSDS Number
- -0
CAS Number
TRANS TECH AMERICA, INC.
Supplier
475 N. GARY AVENUE
CAROL STREAM, IL 60188 USA
Telephone Numbers - 24 Hour Emergency Assistance
Emergency (352)323-3500
Telephone Numbers - General Assistance
Information (630)752-4000
2 COMPOSITION / INFORMATION ON INGREDIENTS
Concentration
Ingredient Name CAS Number Exposure Limits / Health Hazards
FUNCTIONAL
POLYDIMETHYLSILOXANE
HYDROGEN FUNCTIONAL
POLYDIMETHYLSILOXANES
QUARTZ 14808-60-7 OSHA PEL: 0.1 mg/m3 ACGIH
TLV: 0.1 mg/m3
3 HAZARDS IDENTIFICATION
4 FIRST AID MEASURES
Skin
If contact with skin, remove material from the skin with a waterless skin cleaner, wash skin with water and soap. Get
medical attention if irritation occurs.
Eye
If contact with eyes, immediately flush eyes with plenty of water. Get medical attention if irritation occurs.
Inhalation
If inhaled, remove to fresh air. Get medical attention if irritation occurs or breathing becomes difficult.
Ingestion
If swallowed, allow affected person to vomit naturally. Get medical attention.
Medical Conditions Aggravated by Exposure
There are no data available which address medical conditions which are generally recognized as being aggravated by
exposure to this product.
5 FIRE FIGHTING MEASURES
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
253 SILICONE RUBBER QUALITY 3 - P
Material Id Trade Name 1/ 3
2
Extinguishing Media
Sand, carbon dioxide, dry chemical or foam types extinguishing media.
Basic Fire Fighting Procedures
Fire fighters should wear full protective clothing including a self-contained breathing apparatus.
Unusual Fire & Explosion Hazards
This material reacts with water or alcohol in the presence of acids or bases to release hydrogen gas.
200 C />392F
Flash Point
6 ACCIDENTAL RELEASE MEASURES
Spill or Leak Procedure
Take up by mechanical means and place in an appropriate chemical waste container. Do not close collecting container
gas-proof. Absorb with inert material (e.g. Kieslgehr, sand) and dispose. Observe all local, state and federal laws and
regulations regarding disposal, spill, clean up, removal or discharge.
7 HANDLING & STORAGE
Handling
Do not smoke or use lighters during use and until all vapors are gone. Take care when opening container due to possible
w2 evaluation. Be aware that the product is slippery.
Storage
Store cool and dry. Store only in the original container. Keep container tightly closed. Store in a well ventilated area. Keep
away from heat, sparks and flame. Take precautionary measures against static discharge.
Ventilation
Use only with adequate ventilation. Local exhaust: yes mechanical (general): yes
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Eye Protection: Personal Protection Equipments (PPE)
Chemical safety goggles recommended.
Skin Protection: Personal Protection Equipments (PPE)
Pvc or rubber gloves recommended.
General
Not necessary.
9 PHYSICAL & CHEMICAL PROPERTIES
Odor and Appearance
Whites liquid without odor
NI
Boiling Point
1.13
Specific Gravity
NI
Melting Point
Not applicable
Percent Volatile
NI
Vapor Pressure
NI
Evaporation Rate
NI
Vapor Density
Negligible
Solubility In Water
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
253 SILICONE RUBBER QUALITY 3 - P
Material Id Trade Name 2/ 3
2
10 STABILITY & REACTIVITY
Stability/Incompatibility
Stable Alkalies, amines, acids, metal salts especially in combination with water and alcohols. Strong oxidizing agents.
Hazardous Reactions/Decomposition Products
Decomposition will occur at high temperatures releasing flammable gases. Hydrogen gas at hydrolysis and traces of
incompletely burned hydrocarbons at combustion. At temperatures of approximately 150c/302f a small amount of
formaldehyde can be released by oxidative degradation.
Hazardous Polymerization
Will not occur
11 TOXICOLOGICAL INFORMATION
Routes of Exposure
Eye contact, skin contact, inhalation, ingestion.
12 ECOLOGICAL INFORMATION
13 DISPOSAL CONSIDERATIONS
Waste Disposal
According to local, state and federal regulations (incinaration).
14 TRANSPORT INFORMATION
15 REGULATORY INFORMATION
NFPA Ratings
Health Flammability Reactivity Special Hazards
HMIS Ratings
Health 1 Flammability 1 Reactivity 1 Personal Prot. Equip. B
16 OTHER INFORMATION
Disclaimer
This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of
Trans Tech America, Inc. The data on this sheet applies only to the specific material designated herein. Trans Tech
America, Inc. assumes no legal responsibility for use of reliance upon this data.
5/11/1998 Replaces Sheet Dated
Completed On
TRANS TECH AMERICA, INC.
Completed By
Printed On 31-Mar-03
ND = No Data NA = Not Applicable NI = Not Indicated
253 SILICONE RUBBER QUALITY 3 - P
Material Id Trade Name 3/ 3
2
|