NuGenTec
AutoDishWash, Liquid Page 1
PRD Number: XXC108 May 29, 2007
MATERIAL SAFETY DATA SHEET
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Identification
----------------------
Product Name: AutoDishWash Liquid
Product Number: XXC108
CAS Number: Blend
Company Identification
----------------------
NuGeneration Technologies, LLC www.nugentec.com
100 Professional Center Dr., Suite 101, Rohnert Park, CA 94928 USA
(707) 820-4080(For product information)
1-800-424-9300 or 1-202-483-7616 (CHEMTREC)
2. COMPOSITION/INFORMATION ON INGREDIENTS
100.0% AutoDishWash Liquid
CONTAINING:
HAZARDOUS AND/OR REGULATED COMPONENTS
Chemical Name Amount CAS Number
------------- -------- ----------
Sodium HYDROXIDE < 15.0 % 1310-73-2
NON-HAZARDOUS COMPONENTS
Chemical Name Amount CAS Number
------------- -------- ----------
NONIONIC SURFACTANT BLEND < 2.0 % TRADESECRET
BALANCE NON-HAZARDOUS INGREDIENTS > 83.0 % N/A
(See Section 8 for exposure guidelines)
(See Section 15 for regulatory information)
HAZARDS DISCLOSURE
This product contains hazardous materials as defined by the OSHA Hazard
Communication Standard 29 CFR 1910.1200.
As defined under Sara 311 and 312, this product contains no known
hazardous materials.
3. HAZARDS IDENTIFICATION
***************** EMERGENCY OVERVIEW *****************
* *
* CAUTION *
* *
* Corrosive material. Avoid eye contact. Can cause *
* skin/eye irritation and or burns. *
* *
**********************************************************
NuGenTec
AutoDishWash, Liquid Page 2
PRD Number: XXC108 May 29, 2007
HMIS Rating - Health: 2
Flammability: 0
Reactivity: 0
Personal Protection Index: C
NFPA Rating - Health: 2
Flammability: 0
Reactivity: 0
Special Hazard: Corrosive
NFPA/HMIS Definitions: (0-Least, 1-Slight, 2-Moderate, 3-High,
4-Extreme). These values are obtained using the guidelines or published
evaluations prepared by the National Fire Protection Association (NFPA) or
the National Paint and Coating Association (for HMIS ratings).
POTENTIAL HEALTH EFFECTS
EYE:
Severely irritating to the eyes. May cause eye burns and permanent tissue
damage.
SKIN:
Contact causes severe skin irritation and possible burns.
INHALATION:
Avoid breathing vapors or mists. May cause irritation of the upper
respiratory passages.
INGESTION:
May be harmful if swallowed.
SIGNS AND SYMPTOMS OF EXPOSURE:
If exposed areas are flushed promptly and thoroughly with water, there
should be little or no harm.
CARCINOGENICITY INFORMATION:
No known cancer hazards.
MISCELLANEOUS:
Slippery, can cause falls if walked on.
4. FIRST AID MEASURES
EYE CONTACT FIRST AID:
Hold eyelids apart and flush eyes with plenty of water for at least 15
minutes. Get immediate medical attention.
SKIN CONTACT FIRST AID:
Immediately wash skin with plenty of soap and water while removing
contaminated clothing and shoes. Get medical attention if irritation
develops or persists.
INHALATION FIRST AID:
Not an expected route of exposure.
NuGenTec
AutoDishWash, Liquid Page 3
PRD Number: XXC108 May 29, 2007
Remove from area of exposure. Seek immediate medical attention if
respiratory irritation or distress continues.
INGESTION FIRST AID:
Get medical attention immediately. Do not induce vomiting.
STATEMENT OF PRACTICAL TREATMENT:
Always have plenty of water available for first aid.
NOTES TO PHYSICIAN:
Treat patient symptomatically.
5. FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES
COC Flash Point: None
TCC Flash Point: None
Autoignition Temperature: None
FLAMMABLE LIMITS IN AIR
LEL: None
UEL: None
EXTINGUISHING MEDIA:
Will not burn.
FIRE & EXPLOSION HAZARDS:
Material will not burn.
FIRE FIGHTING INSTRUCTIONS:
As in any fire, wear self-contained breathing apparatus pressure-demand
MSHA/NIOSH (approved or equivalent) and full protective gear. Contain
runoff water. Contaminated extinguishing water must be disposed of in
accordance with applicable regulations.
6. ACCIDENTAL RELEASE MEASURES
SAFEGUARDS (PERSONNEL):
Protect skin and eyes from exposure.
INITIAL CONTAINMENT:
Contain spilled material. Absorb spills with inert material. Floor may
become slippery. Take up and place in secure closed containers. Wash
area to prevent slipping.
LARGE SPILLS PROCEDURE:
Absorb spill with inert material (e g, dry sand or earth), then place in a
chemical waste container. Clean up spills immediately, observing
precautions in Protective Equipment section. Treat or dispose of waste
material in accordance with all local, state/provincial, and national
requirements.
SMALL SPILLS PROCEDURE:
Wash with water or absorb spills with inert material. Treat or dispose of
waste material in accordance with all local, state/provincial, and
NuGenTec
AutoDishWash, Liquid Page 4
PRD Number: XXC108 May 29, 2007
national requirements.
7. HANDLING AND STORAGE
RECOMMENDED STORAGE TEMPERATURE
Minimum: 4.4 C (39.9 F)
Maximum: 48.9 C (120.0 F)
HANDLING (PERSONNEL):
Avoid contact with eyes, skin, and clothing.
HANDLING (PHYSICAL ASPECTS):
Keep container closed to avoid contamination.
STORAGE PRECAUTIONS:
Avoid extreme temperatures.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS:
No special ventilation requirements.
EYE / FACE PROTECTION REQUIREMENTS:
When splashing of the material may occur, chemical goggles and a face
shield are recommended. Use chemical splash goggles and face shield (ANSI
Z87-1 or approved equivalent).
SKIN PROTECTION REQUIREMENTS:
Wear protective gloves to minimize skin contact. Wash hands thoroughly
after handling.
RESPIRATORY PROTECTION REQUIREMENTS:
Under normal use conditions, with adequate ventilation, no special
handling equipment is required.
MISCELLANEOUS:
Where an apron and protective clothing.
EXPOSURE GUIDELINES:
No Information Available.
9. PHYSICAL AND CHEMICAL PROPERTIES
FORM ...............................: Liquid
COLOR ..............................: Clear to Pale Yellow
ODOR ...............................: Mild
BOILING POINT ......................: >212 F
SOLUBILITY IN WATER ................: Complete
SPECIFIC GRAVITY ...................: 1.105 (Water = 1)
BULK DENSITY .......................: 9.22
MELTING/FREEZING POINT .............: 35 F
PH .................................: 13.3
% VOLATILES ........................: 0%
VOLATILE ORGANIC COMPOUNDS (VOC) ...: 0
PH (5% B.V.) .......................: 12.2
NuGenTec
AutoDishWash, Liquid Page 5
PRD Number: XXC108 May 29, 2007
10. STABILITY AND REACTIVITY
STABILITY:
Stable.
POLYMERIZATION:
Hazardous polymerization will not occur.
INCOMPATIBILITY WITH OTHER MATERIALS:
Will react with acidic materials.
DECOMPOSITION:
Decomposition will not occur if handled and stored properly.
CONDITIONS TO AVOID:
This material is safe under normal storage and handling conditions.
11. TOXICOLOGICAL INFORMATION
EYE EFFECTS:
Can cause severe eye irritation including burns.
SKIN EFFECTS:
Contact may cause skin irritation, rash or burns.
ACUTE ORAL EFFECTS:
May cause diarrhea and or vomiting along with tissue burns.
ACUTE INHALATION EFFECTS:
May be irritating if inhaled.
12. ECOLOGICAL INFORMATION
No information available.
13. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL:
Dilute or neutralize with acid and discharge to an industrial sewage
treatment facility. Treat or dispose of waste material in accordance
with all local, state/provincial, and national requirements. For
additional waste disposal information contact your local NuGenTec
representative at (888) 99-NuGen or (209) 234-5930.
CONTAMINATED MATERIALS:
Wash contaminated clothing before reuse.
CONTAINER DISPOSAL:
Clean out containers prior to disposal.
NuGenTec
AutoDishWash, Liquid Page 6
PRD Number: XXC108 May 29, 2007
14. TRANSPORTATION INFORMATION
PRODUCT LABEL .............: AutoDishWash Liquid
D.O.T. SHIPPING NAME ......: Corrosive
TECHNICAL SHIPPING NAME ...: Sodium Hydroxide based Alkaline Cleaner,
Liquid
D.O.T. HAZARD CLASS .......: Corrosive
UN NUMBER .................: 1760 Corrosive Liquid, NOS
PRODUCT RQ (LBS) ..........: 20,000
D.O.T. LABEL ..............: Corrosive Liquid
D.O.T. PLACARD ............: #8
BULK CLASS ................: N/A
PACKAGE CLASS .............: 55
15. REGULATORY INFORMATION
EEC Symbols and Indications of Danger: Corrosive (C)
R-Phrases: R36/38 - Irritating to eyes and skin.
S-Phrases: S24/25 - Avoid contact with skin and eyes.
WHMIS Hazard Symbols: Class E - Corrosive Material
Canadian Disclosure List: Potassium Hydroxide (1310-58-3)
CERCLA Hazardous Substances: Potassium Hydroxide (1310-58-3) -- RQ 1000 lb
MISCELLANEOUS INFORMATION:
This material or all of its components are listed on the Inventory of
Existing Chemical Substances under the Toxic Substance Control Act (TSCA).
16. OTHER INFORMATION
PREPARED BY .......: Donato Polignone
APPROVAL DATE .....: May 29, 2007
SUPERCEDES DATE ...: July 30, 2002
PRD NUMBER ........: XXC108 (Official Copy)
**********************************************************************
This information is furnished without warranty, expressed or implied,
except that it is accurate to the best knowledge of NuGeneration
Technologies, LLC. The data on this sheet are related only to the
specific material designated herein. NuGeneration Technologies, LLC
assumes no legal responsibility for use or reliance upon these data.
**********************************************************************
END OF MSDS
**********************************************************************
|