NuGenTec
NuBrite Plasti-Prep Page 1 of 4
PRD Number: SCB320 May 31, 2007
MATERIAL SAFETY DATA SHEET
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Identification
----------------------
Product Name: NuBrite PLASTI-PREP Product Number: SCB320
Synonyms: -- CAS Number: Blend
Company Identification
NuGeneration Technologies, LLC WWW.NUGENTEC.COM
100 Professional Center Drive Suite 101
Rohnert Park, CA 94928 USA
(707) 820-4080 (For product information)
1-800-424-9300 or 1-202-483-7616 (CHEMTREC) (For emergencies)
2. COMPOSITION/INFORMATION ON INGREDIENTS
100.0% NuBrite PLASTI-PREP CONTAINING: HAZARDOUS AND/OR REGULATED
COMPONENTS
Chemical Name Amount CAS Number
------------- -------- ----------
Confidential Ingredient A < 10.0 % Trade Secret
MONOETHANOLAMINE < 5.0 % 141-43-5
NON-HAZARDOUS COMPONENTS
Chemical Name Amount CAS Number
------------- -------- ----------
BALANCE NON-HAZARDOUS INGREDIENTS > 85.0 % N/A
(See Section 8 for exposure guidelines)
(See Section 15 for regulatory information)
HAZARDS DISCLOSURE
This product contains hazardous materials as defined by the OSHA Hazard
Communication Standard 29 CFR 1910.1200.
As defined under Sara 311 and 312, this product contains materials that
are hazards.
3. HAZARDS IDENTIFICATION
***************** EMERGENCY OVERVIEW *****************
* CAUTION *
* Can cause skin/eye irritation. Avoid eye contact. *
* Avoid inhalation. *
**********************************************************
HMIS Rating - Health: 1
Flammability: 0
Reactivity: 0
Personal Protection Index: C
NFPA Rating - Health: 1
Flammability: 0
Reactivity: 0
Special Hazard: N/A
NuGenTec
NuBrite Plasti-Prep Page 2 of 4
PRD Number: SCB320 May 31, 2007
POTENTIAL HEALTH EFFECTS
EYE: Can cause severe eye irritation.
SKIN: Contact may cause skin irritation.
INHALATION: Not expected to be a problem under normal use. Vapors and/or
aerosols which may be formed at elevated temperatures may be irritating to
eyes and respiratory tract.
INGESTION: Ingestion is not considered a potential route of exposure. May
cause diarrhea, nausea, abdominal cramps.
SIGNS AND SYMPTOMS OF EXPOSURE:
If exposed areas are flushed promptly and thoroughly with water, there
should be little or no harm. Long-term exposure may lead to rash or burn.
CARCINOGENICITY INFORMATION: No known cancer hazards.
MISCELLANEOUS: Slippery, can cause falls if walked on.
4. FIRST AID MEASURES
EYE CONTACT FIRST AID:
After initial flushing, remove any contact lenses and continue flushing
for at least 15 minutes. Get medical attention if irritation develops or
persists.
SKIN CONTACT FIRST AID:
Immediately flush skin with plenty of water. Remove contaminated clothing
and shoes. Get medical attention if irritation develops or persists.
INHALATION FIRST AID:
Although this product is not known to cause respiratory problems, if
breathing is difficult, remove to fresh air and provide oxygen.
INGESTION FIRST AID: Get medical attention immediately. Do not induce
vomiting.
STATEMENT OF PRACTICAL TREATMENT: Always have plenty of water available for
first aid.
NOTES TO PHYSICIAN: Treat patient symptomatically.
5. FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES COC Flash Point: N/A Autoignition Temperature: N/A
FLAMMABLE LIMITS IN AIR LEL: N/A UEL: N/A
EXTINGUISHING MEDIA: Carbon dioxide, foam, or dry powder.
FIRE & EXPLOSION HAZARDS: Heating above 200掳C or in fire conditions toxic
decomposition products may be formed.
FIRE FIGHTING INSTRUCTIONS: Contain runoff water. Contaminated extinguishing
water must be disposed of in accordance with applicable regulations.
6. ACCIDENTAL RELEASE MEASURES
SAFEGUARDS (PERSONNEL): Protect skin and eyes from exposure. Wear
appropriate personal protective equipment.
INITIAL CONTAINMENT:
Floor may become slippery. Contain spilled material. Absorb spills with
inert material. Allow material to solidify, and scrape up. Wash area to
prevent slipping. Treat or dispose of waste material in accordance with
all local, state/provincial, and national requirements.
LARGE SPILLS PROCEDURE:
Clean up spills immediately, observing precautions in Protective Equipment
section. Neutralize spill with a weak acid such as vinegar or acetic
acid. Forms smooth, slippery surfaces on floors, posing an accident risk.
Treat or dispose of waste material in accordance with all local,
state/provincial, and national requirements.
SMALL SPILLS PROCEDURE:
Treat or dispose of waste material in accordance with all local,
state/provincial, and national requirements. Floor may become slippery.
NuGenTec
NuBrite Plasti-Prep Page 3 of 4
PRD Number: SCB320 May 31, 2007
Absorb spills with inert material.
7. HANDLING AND STORAGE
RECOMMENDED STORAGE TEMPERATURE
Minimum: 4.4 C (39.9 F) Maximum: 48.9 C (120.0 F)
HANDLING (PERSONNEL): Wash hands thoroughly after handling. Remove
contaminated clothing and wash before reuse. Avoid contact with eyes, skin,
and clothing.
HANDLING (PHYSICAL ASPECTS): Avoid mixing with strongly acidic solutions.
Keep container closed to avoid contamination.
STORAGE PRECAUTIONS: Do not stack drums more than two pallets high. Keep
from freezing. Keep container closed when not in use.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS:
Good general ventilation should be sufficient to control airborne levels.
EYE / FACE PROTECTION REQUIREMENTS:
When splashing of the material may occur, chemical goggles and a face
shield are recommended.
SKIN PROTECTION REQUIREMENTS:
Wash hands thoroughly after handling. Wear protective gloves to minimize
skin contamination.
RESPIRATORY PROTECTION REQUIREMENTS:
Under normal use conditions, with adequate ventilation, no special
handling equipment is required.
MISCELLANEOUS:
Where an apron and protective clothing.
EXPOSURE GUIDELINES:
Monoethanolamine
OSHA TWA: 3 ppm
OSHA STEL: 6 ppm
9. PHYSICAL AND CHEMICAL PROPERTIES
FORM ...............................: Liquid
COLOR ..............................: colorless (no dye)
ODOR ...............................: Mild odor
BOILING POINT ......................: 212 F
SOLUBILITY IN WATER ................: Complete
SPECIFIC GRAVITY ...................: 1.05 (Water = 1)
BULK DENSITY .......................: 8.76
MELTING/FREEZING POINT .............: 32 F
PH .................................: 11.8
% VOLATILES ........................: <20 %
VOLATILE ORGANIC COMPOUNDS (VOC) ...: 20
PH (5% B.V.) .......................: 11
10. STABILITY AND REACTIVITY
STABILITY: Stable.
POLYMERIZATION: Hazardous polymerization will not occur.
INCOMPATIBILITY WITH OTHER MATERIALS: Avoid contact with Acidic conditions.
DECOMPOSITION:
Decomposition will not occur if handled and stored properly.
CONDITIONS TO AVOID:
This material is safe under normal storage and handling conditions.
Avoid contact with this material and Aluminum or galvanized surfaces.
11. TOXICOLOGICAL INFORMATION
EYE EFFECTS: Can cause severe eye irritation including burns.
SKIN EFFECTS: Contact may cause skin irritation, rash or burns.
NuGenTec
NuBrite Plasti-Prep Page 4 of 4
PRD Number: SCB320 May 31, 2007
ACUTE ORAL EFFECTS:
May cause diarrhea and or vomiting along with tissue burns.
ACUTE INHALATION EFFECTS: May be irritating if inhaled.
Monoethanolamine
Test Code: Oral LD50
Species: Rats
Results: > 1090 mg/kg
12. ECOLOGICAL INFORMATION
No information available.
13. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL:
Uncleaned empty containers should be disposed of in the same manner as
the contents. Treat or dispose of waste material in accordance with all
local, state/provincial, and national requirements.
CONTAMINATED MATERIALS:
Wash contaminated clothing before reuse.
CONTAINER DISPOSAL:
Containers should be triple rinsed prior to disposal.
14. TRANSPORTATION INFORMATION
PRODUCT LABEL.............: NuBrite PLASTI-PREP
D.O.T. SHIPPING NAME......: Cleaning compound NOBIN, Non-Regulated material
TECHNICAL SHIPPING NAME...: N/A
D.O.T. HAZARD CLASS.......: N/A
UN NUMBER.................: N/A
D.O.T. LABEL..............: N/A
D.O.T. PLACARD............: N/A
BULK CLASS................: N/A
PACKAGE CLASS.............: 55
15. REGULATORY INFORMATION
SARA Title III - Section 313
Confidential Ingredient A
MISCELLANEOUS INFORMATION:
This material or all of its components are listed on the Inventory of
Existing Chemical Substances under the Toxic Substance Control Act (TSCA).
16. OTHER INFORMATION
Prepared By.......: Donato Polignone
Approval Date.....: May 31, 2007
Supercedes Date...: March 11, 2004
PRD Number........: SCB320 (Official Copy)
**********************************************************************
This information is furnished without warranty, expressed or implied,
except that it is accurate to the best knowledge of NuGeneration
Technologies, LLC. The data on this sheet are related only to the
specific material designated herein. NuGeneration Technologies, LLC
assumes no legal responsibility for use or reliance upon these data.
**********************************************************************
END OF MSDS
**********************************************************************
|