NuGenTec
Neutralizer 1 MATERIAL SAFETY DATA SHEET Page 1 of 4
PRD Number: MCA101 May 30, 2007
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name: Neutralizer 1 Product Number: MCA101
Synonyms: Acidic liquid for neutralizing alkaline solutions. CAS Number: 7664-93-9
NuGeneration Technologies, LLC www.nugentec.com
100 Professional Center Drive Suite 101Rohnert Park, CA 94928 USA
1-800-424-9300 or 1-703-527-3887 (CHEMTREC: emergencies), (707) 820-4080 (product information)
2. COMPOSITION/INFORMATION ON INGREDIENTS
100.0% Neutralizer 1 CONTAINING: HAZARDOUS AND/OR REGULATED COMPONENTS
Chemical Name Amount CAS Number
SULFURIC ACID 50.0 % 7664-93-9
NON-HAZARDOUS COMPONENTS
Chemical Name Amount CAS Number
WATER 50.0 % 7732-18-5
(See Section 8 for exposure guidelines) (See Section 15 for regulatory information)
HAZARDS DISCLOSURE: This product contains hazardous materials as defined by the OSHA Hazard
Communication Standard 29 CFR 1910.1200.
SARA 311 Categories:
Immediate (Acute) Health Effects....: Yes
Delayed (Chronic) Health Effects....: Yes
Fire Hazard.........................: No
Sudden Release Of Pressure Hazard...: No
Reactivity Hazard...................: Yes
MISCELLANEOUS: Contains Sulfuric Acid.
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
DANGER CORROSIVE!
Can cause skin/eye irritation and or burns.
Harmful if absorbed through skin or swallowed. Keep out of waterways.
HMIS Rating - Health: 3
Flammability: 0
Reactivity: 1
Personal Protection Index: G
NFPA Rating - Health: 3
Flammability: 0
Reactivity: 1
Special Hazard: Corrosive
NFPA/HMIS Definitions: (0-Least, 1-Slight, 2-Moderate, 3-High, 4-Extreme). These values are obtained
using the guidelines or published evaluations prepared by the National Fire Protection Association
(NFPA) or the National Paint and Coating Association (for HMIS ratings).
POTENTIAL HEALTH EFFECTS
EYE: Corrosive, contact causes severe eye burns.
SKIN: Contact may cause severe skin irritation and possible burns.
NuGenTec
Neutralizer 1 MATERIAL SAFETY DATA SHEET Page 2 of 4
PRD Number: MCA101 May 30, 2007
INHALATION: Avoid breathing vapors or mists.
INGESTION: Ingestion is not considered a potential route of exposure. Corrosive and may cause severe
and permanent damage to mouth, throat, and stomach. If ingested seek prompt medical attention.
SIGNS AND SYMPTOMS OF EXPOSURE: If exposed areas are flushed promptly and thoroughly with
SOAP & water, there should be little or no harm. Seek medical attention as a preventative measure.
CHRONIC EFFECTS: Prolonged and/or repeated contact may produce mild to moderate skin irritation or
inflammation and in some cases rashes or burns.
REPRODUCTIVE HAZARDS: No known reproductive hazards.
CARCINOGENICITY INFORMATION: Unknown.
MEDICAL CONDITIONS AGRAVATED BY EXPOSURE: Personnel with pre-existing skin disorders and
chronic respiratory diseases should avoid contact with this product.
4. FIRST AID MEASURES
EYE CONTACT FIRST AID: Flush eye with water for 15 minutes. Get medical attention.
SKIN CONTACT FIRST AID: Immediately flush skin with plenty of water. Remove contaminated clothing
and shoes. Get medical attention if irritation develops or persists.
INHALATION FIRST AID: Although this product is not known to cause respiratory problems, if
breathing is difficult, remove to fresh air and provide oxygen.
INGESTION FIRST AID: Get medical attention immediately. Do not induce vomiting. For larger
amounts, do not induce vomiting, but give one or two glasses of water or
milk to drink and get medical attention.
STATEMENT OF PRACTICAL TREATMENT: Always have plenty of water available for first aid.
NOTES TO PHYSICIAN: Treat patient symptomatically.
5. FIRE FIGHTING MEASURES
FLAMMABLE PROPERTIES - COC Flash Point: None TCC Flash Point: None
Autoignition Temperature: None
FLAMMABLE LIMITS IN AIR - LEL: None UEL: None
EXTINGUISHING MEDIA: Will not burn.
FIRE FIGHTING INSTRUCTIONS: Contaminated extinguishing water must be disposed of in accordance
with applicable regulations.
6. ACCIDENTAL RELEASE MEASURES
SAFEGUARDS (PERSONNEL): Protect skin and eyes from exposure.
INITIAL CONTAINMENT: Contain spilled material.
LARGE SPILLS PROCEDURE: Forms smooth, slippery surfaces on floors, posing an accident risk.
Dilute with water and wash to waste water treatment system. Large spills may be neutralized with
dilute alkaline solutions of soda ash, or lime. Treat or dispose of waste material in accordance with all
local, state/provincial, and national requirements.
SMALL SPILLS PROCEDURE: Floor may become slippery. Absorb spills with inert material. After
cleaning spill with absorbent material wash area with soap and water. Treat or dispose of waste
material in accordance with all local, state/provincial, and national requirements.
NuGenTec
Neutralizer 1 MATERIAL SAFETY DATA SHEET Page 3 of 4
PRD Number: MCA101 May 30, 2007
7. HANDLING AND STORAGE
RECOMMENDED STORAGE TEMPERATURE - Minimum: 4.4 C (39.9 F) Maximum: 48.9 C (120.0 F)
SHELF LIFE: (in original, sealed containers) 3 years @ 4.4 C 1 year @ 48.9 C
HANDLING (PERSONNEL): Avoid contact with eyes, skin, and clothing.
HANDLING (PHYSICAL ASPECTS): Keep out of reach of children. Keep from freezing. Keep container
closed to avoid contamination. Store in a cool dry area.
STORAGE PRECAUTIONS: Do not stack pails more than three pallets high. Do not stack drums more
than two pallets high. Keep from freezing. Keep container closed when not in use.
MISCELLANEOUS: Do not stack over two pallets high.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
ENGINEERING CONTROLS: No special ventilation requirements.
EYE / FACE PROTECTION REQUIREMENTS: When splashing of the material may occur, chemical
goggles and a face shield are recommended.
SKIN PROTECTION REQUIREMENTS: Wear protective gloves to minimize skin contamination.
RESPIRATORY PROTECTION REQUIREMENTS: Under normal use conditions, with adequate
ventilation, no special handling equipment is required.
MISCELLANEOUS: Where an apron and protective clothing.
EXPOSURE GUIDELINES:
SULFURIC ACID
Immediate Lethal Dosage: 15 mg/m^3
OSHA PEL: 1 mg/m^3 OSHA TWA: 1 mg/m^3
ACGIH TWA: 1 mg/m^3 ACGIH STEL: 3 mg/m^3
9. PHYSICAL AND CHEMICAL PROPERTIES
FORM ...............................: Liquid
COLOR ..............................: colorless
ODOR ...............................: None
BOILING POINT ......................: >212 F
SOLUBILITY IN WATER ................: Complete
SPECIFIC GRAVITY ...................: 1.6 (Water = 1)
BULK DENSITY .......................: 13.3
MELTING/FREEZING POINT .............: <32 F
PH .................................: <1
% VOLATILES ........................: 0.0 %
VOLATILE ORGANIC COMPOUNDS (VOC) ...: None
10. STABILITY AND REACTIVITY
STABILITY: Stable.
POLYMERIZATION: Hazardous polymerization will not occur.
INCOMPATIBILITY WITH OTHER MATERIALS:
Avoid contact with strong bases. Incompatible with alkaline and alkaline
earth metals. Will react with alkaline materials (use to neutralize).
DECOMPOSITION: Decomposition will not occur if handled and stored properly.
CONDITIONS TO AVOID: Avoid contact with this material and Ferrous metal surfaces. This material is
safe under normal storage and handling conditions.
MISCELLANEOUS: Avoid high heat, sunlight and ultra-violet light.
11. TOXICOLOGICAL INFORMATION
EYE EFFECTS: Can cause severe eye irritation including burns and or permanent damage.
SKIN EFFECTS: Contact may cause skin irritation, rash or burns.
ACUTE ORAL EFFECTS: May cause diarrhea and or vomiting along with tissue burns.
ACUTE INHALATION EFFECTS: No know hazards in normal industrial use.
REPRODUCTION AND BIRTH EFFECTS: There are no known or reported effects on reproductive
function or fetal development.
NuGenTec
Neutralizer 1 MATERIAL SAFETY DATA SHEET Page 4 of 4
PRD Number: MCA101 May 30, 2007
12. ECOLOGICAL INFORMATION - No information available.
13. DISPOSAL CONSIDERATIONS
WASTE DISPOSAL:
Treat or dispose of waste material in accordance with all local, state/provincial, and national requirements.
For additional waste disposal information contact your NuGenTec representative at (888) 99-NuGen.
Uncleaned empty containers should be disposed of in the same manner as the contents. Avoid
disposal into waste water treatment facilities.
CONTAMINATED MATERIALS: Wash contaminated clothing before reuse.
CONTAINER DISPOSAL: Clean out containers prior to disposal.
14. TRANSPORTATION INFORMATION
PRODUCT LABEL .............: Neutralizer 1
D.O.T. SHIPPING NAME ......: Corrosive Liquid
TECHNICAL SHIPPING NAME ...: Corrosive Liquid, NOS (sulfuric acid mixture), PG III
D.O.T. HAZARD CLASS .......: Corrosive
UN NUMBER .................: 1760 Corrosive Liquid, NOS
PRODUCT RQ (LBS) ..........: 2,000
D.O.T. LABEL ..............: Corrosive Liquid
D.O.T. PLACARD ............: #8
BULK CLASS ................: N/A
PACKAGE CLASS .............: 55
15. REGULATORY INFORMATION
EEC Symbols and Indications of Danger: Corrosive (C)
R-Phrases: R34 - Causes burns. S-Phrases: S25 - Avoid contact with eyes.
S26 - In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
WHMIS Hazard Symbols: Class E - Corrosive Material
Canadian Disclosure List SULFURIC ACID (7664-93-9)
SARA Title III - Section 313 SULFURIC ACID (7664-93-9)
CERCLA Hazardous Substances SULFURIC ACID (7664-93-9) -- RQ 1000 lb
Title V SULFURIC ACID (7664-93-9)
SC Toxic Air Pollutants List SULFURIC ACID (7664-93-9)
MISCELLANEOUS INFORMATION: This material or all of its components are listed on the Inventory of
Existing Chemical Substances under the Toxic Substance Control Act (TSCA). This material or all of
its components are listed on the Canadian Domestic Substances List (DSL). This material or all of its
components are listed (or considered as having been notified) on the European Inventory of Existing
Chemical Substances (EINECS).
16. OTHER INFORMATION
PREPARED BY ............: Donato Polignone
PRD NUMBER ..............: MCA101 (Official Copy)
APPROVAL DATE ........: May 30, 2007
SUPERCEDES DATE ...: October 2, 2002
ADDITIONAL INFORMATION:
The data in this Material Safety Data Sheet relates only to the specific material designated herein. It does
not relate to use in combination with any other material or in any process.
This information is furnished without warranty, expressed or implied, except that it is accurate to the best
knowledge of NuGeneration Technologies, LLC. The data on this sheet are related only to the
specific material designated herein. NuGeneration Technologies, LLC assumes no legal responsibility
for use or reliance upon these data.
END OF MSDS
|