GOODSON
Material Safety Data Sheet PFL-200
Complies with OSHA's Hazard Communication
GOODSON
Standard 29 CFR 1910.1200.
DATE OF PREPARATION: Tools and Supplies for Engine Builders
March 4, 1998 156 Galewski Drive 鈥? P.O. Box 847 鈥? Winona, MN 55987-0847
DATE OF REVIEW: November 27, 2002 Toll-Free 1-800-533-8010 鈥? Local 507-452-1830 鈥? www.goodson.com
GOODSON
1. CHEMICAL PRODUCT IDENTIFICATION
Part No. and Description: PFL-200 Press Fit Lubricant 8oz.
2. COMPOSITION / INFORMATION ON INGREDIENTS
Ingredients CAS # OSHA PEL ACGIH TLV % Wt.
GOODSON
Liquefied Petroleum Gas 68476-85-7 1000 ppm 1000 ppm 30-40
n-Heptane 142-82-5 400 ppm 400 ppm 20-30
Acetone 67-64-1 1000 ppm 750 ppm 20-30
Heavy Paraffinic Distillate Solvent Extract 64742-04-7 5 mg/m3 5 mg/m3 10-20
GOODSON
Polymerized Rosin 65997-05-9 n/e n/e
Sulfurized Fatty Acid 68991-70-8 n/e n/e
Polyisobutylene 9003-27-4 n/e n/e
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW: Contents extremely flammable and under pressure. Store below 120掳F, out of sunlight and away
from heat sources. Do not puncture or incinerate. Avoid contact with skin and eye., Vapor harmful. Intentional misuse by deliberately
concentrating and inhaling the contents may be harmful or fatal.
HMIS Ratings: Health 1, Fire 4, Reactivity 0, Protective Equipment B
Eye: Liquid or vapors may cause redness, burning, tearing, swelling and/or pain.
Skin: Frequent or prolonged contact can result in defatting & drying of the skin which may result in skin irritation & dermatitis(rash).
Ingestion: Due to being an aerosol, product does not lend itself to ingestion. Should ingestion occur, it may cause irritation to
membranes of the mouth, throat and gastrointestinal tract, resulting in vomiting and/or cramps.
Inhalation: Prolonged or repeated overexposure is anesthetic. May cause irritation of the respiratory tract, or acute nervous system
depression characterized by headache, dizziness, staggering gait, or confusion.
Medical Conditions Aggravated: Skin contact may aggravate an existing dermatitis. Others unknown.
Carcinogen Data: None of the ingredients in this product are listed with OSHA, IARC or NTP as being carcinogenic.
4. FIRST AID MEASURES
Ingestion: Unlikely due to being in aerosol form. Should actual ingestion occur, do not induce vomiting! Drink a glass of water or
milk to dilute. Call a physician or poison control center immediately. Never give anything by mouth to an unconscious person.
Eye: Immediately flush with plenty of clear water for at least 15 minutes. Make sure to flush under the eyelids. Consult a physi-
cian for definitive treatment.
Skin: Remove with soap and water. Continue flushing with water for several minutes. Use skin cream to counter resulting dryness.
Consult a physician if irritation continues or if large skin area is affected.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Seek medical atten-
tion if symptoms persist or if unconscious.
5. FIRE FIGHTING MEASURES
Flash Point: Propellant <0掳F Flammable Limits: LEL: 1.8% UEL: 9.5%
Extinguishing Media: For warehouse and storage conditions, use NFPA Class B extinguishers (CO2, dry chemical or universal
aqueous film forming foam).
Special Fire Fighting Procedures: Use water spray to cool fire exposed aerosol containers for containers can rupture violently
from heat developed pressure.
Unusual Fire Hazards and Explosion Hazards: Contents extremely flammable and under pressure. In addition, when liquid or
vapor comes into contact with flames or red hot metal, products of combustion will be created. Firemen should wear self-contained
breathing apparatus.
6. ACCIDENTAL RELEASE MEASURES
Containment Procedures: Product is an aerosol, therefore spills and leaks are unlikely. In case of rupture, released content should
be contained as any other solvent spill.
Spill Cleanup: Spills from aerosol cans are unlikely and are generally of small volume. Large spills are therefore not normally con-
sidered a problem. In case of actual rupture, avoid breathing vapors and ventilate are well. Remove all sources of ignition and use
non-sparking equipment. Soak up material with inert absorbent and place in safety containers for proper disposal.
Special Instructions: Aerosol products represent a limited hazard and will not spill or leak unless ruptured. In case of rupture con-
tents are generally evacuated from the can rapidly. Area should be ventilated immediately & continuous ventilation provided until all
漏 1998 Goodson Shop Supplies
fumes & vapors have been removed. Aerosol cans should never be incinerated or burned. See Section 13 for disposal considerations.
Reporting Requirements: Spills due to the rupture of a single aerosol can are generally below any regulatory reporting require-
ments. However, if larger spills somehow result, the reporting requirements of the EPSA and other local, state and federal agencies
should be observed.
7. HANDLING AND STORAGE
Avoid prolonged or repeated skin contact. Avoid breathing vapors. Store in area below 120掳F. Do not incinerate (burn) containers.
Assure can is in a secure place to prevent knocking over and accidental rupture. Always replace overcap when not in use. For storage
of pallet quantities, compliance with ANSI / NFPA 30B is recommended.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Exposure Guideline: Since this product is a mixture, an OSHA or ACGIH exposure value is not available. In determination of any
exposure procedures, protection or testing, use the lowest rated ingredient in Section 2.
Eye Protection: Safety glasses with side shields are recommended as a minimum for any type of industrial chemical handling.
Where eye contact could occur, chemical splash proof goggles are recommended.
Skin Protection: For brief contact, no precautions other than clean body-covering clothing should be needed. When prolonged or re-
peated contact could occur, use protective clothing such as Sol-Vex庐 gloves or other clothing impervious to the ingredients listed in
section 2.
Respiratory Protection: Atmospheric levels should be maintained below the exposure guideline. When respiratory protection is re-
quired an appropriate NIOSH approved respirator for organic vapor should be worn. If respirators are needed, assure compliance with
OSHA standard 29 CFR 1910.134.
Engineering Controls: General ventilation (typically 10 air changes per hour) should be used. Ventilation rates should be matched
to conditions. Local exhaust ventilation or an enclosed handling system may be needed to control air contamination below that of the
lowest TLV / PEL rated ingredient from section 2.
9. PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point: Propellant <0掳F Vapor Pressure: No data Vapor Density (air=1): Above 1.0
Specific Gravity (H2O=1): Below 1.0 Water Solubility: Negligible Percent Volatile: 78.0% Wt Max
Appearance & Odor: Straw colored with an oily-like odor
10. STABILITY AND REACTIVITY
Stability: Stable Hazardous Polymerization: Will not occur
Conditions to Avoid: Heat, sparks, flame, red hot metal Incompatibilities: Strong oxidizing materials
Decomposition Products: Oxides of carbon
11. TOXICOLOGICAL INFORMATION
Acute Oral LD50: Petroleum Distillate >5g/kg (rat), Acetone >9g/kg (rat)
Acute Dermal LD50: Petroleum Distillate >3g/kg (rabbit), Acetone >20g/kg (rabbit)
Acute Inhalation LC50: Acetone 16000 ppm/4h (rat), Liquefied Petroleum Gas 57.42% v/v (mice)
12. ECOLOGICAL INFORMATION
This product has not been tested for environmental effects.
13. DISPOSAL CONSIDERATIONS
An aerosol container that does not contain a significant amount of liquid would meet the definition of scrap metal (40 CFR
261.1(c)(6)), and would be be exempt from RCRA regulation under 40 CFR 261.6(a)(3)(iv) if it is to be recycled. If containers are to
be disposed of (not recycled) it must be managed under all applicable RCRA and state regulations.
14. TRANSPORTATION INFORMATION
DOT HM-181 INFORMATION
Proper Shipping Name: Consumer Commodity Packing Group: - Hazard Class or Division: ORM-D
Label(s) Required: none Identification No.: none
INTERNATIONAL TRANSPORTATION REGULATIONS
Proper Shipping Name: Consumer Commodity Hazard Label(s): Miscellaneous Class or Division: 9
Packing Group: - Subsidiary Risk: - UN or ID Number: ID8000
NATIONAL MOTOR FREIGHT CLASSIFICATION
Item: 50303 Class: 55 Article: Compounds Lubricating
15. REGULATORY INFORMATION
Toxic Substances Control Act: All of the ingredients in this product are on the TSCA inventory.
SARA TITLE III, Section 313: The following ingredients are subject to the reporting requirements of section 313 of Title III of
the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372: None
Clean Air Act (CAA): The following ingredients appear on the List of Hazardous Air Pollutants (HAP - 42 USC 7412, Title I,
Part A, p112): None
California Proposition 65: The following ingredients appear on the Proposition 65 list(s): None
Canadian Workplace Hazardous Materials Information System (WHMIS): The following ingredients are listed: LPG,
Acetone, Heptane, Petroleum Distillate MSDS PFL-200 Page 2
|