Material Safety Data Sheet RPC-2
Complies with OSHA's Hazard Communication
GOODSON
Standard 29 CFR 1910.1200.
Tools and Supplies for Engine Builders
Airport Industrial Park 鈥? P.O. Box 847 鈥? Winona, MN 55987-0847
Toll-Free 1-800-533-8010 鈥? Local 507-452-1830 鈥? www.goodson.com
Date of Preparation: June 17, 1996
1. MATERIAL IDENTITY
Part No.: RPC-2
Description: Cosmoline
2. COMPOSITION/INFORMATION ON INGREDIENTS
The criteria for listing components in the composition section is as follows: Carcinogens are listed when present at 0.1% or greater;
components which are otherwise hazardous according to OSHA are listed when present at 1.0% or greater; Non-Hazardous components
are listed at 3.0% or greater. This is not intended to be a complete compositional disclosure. Refer to section 14 for applicable states'
right to know and other regulatory information.
Product and/or Component(s) Carcinogenic According to: OSHA IARC NTP OTHER NONE
X
COMPOSITION: (SEQUENCE NUMBER AND CHEMICAL NAME)
Seq. Chemical Name CAS # Range in %
01 Complex Mixture of Petroleum Hydrocarbons 8009-03-8 35.00-49.99
02 #Severely hydrotreated heavy naphthenic distillate 64741-95-3 20.00-34.99
03 *Stoddard solvent 8052-41-3 20.00-34.99
04 *Wool grease 8020-84-6 3.00-9.99
05 *Stearic acid.alkyl ester 123-95-5 1.00-2.99
Product is Hazardous According to OSHA (1910.1200)
*Component is Hazardous according to OSHA.
#Component, by definition, is considered hazardous according to OSHA because it carries the permissible exposure limit (PEL) for mineral oil mist.
EXPOSURE LIMITS REFERENCED BY SEQUENCE NUMBER IN THE COMPOSITION SECTION
Seq. Limit
02 5 mg/m3 TWA-OSHA (Mineral Oil Mist)
02 5 mg/m3 TWA-ACGIH (Mineral Oil Mist)
02 10 mg/m3 STEL-ACGIH (Mineral Oil Mist)
03 100 ppm TWA-OSHA
03 525 mg/m3 TWA-ACGIH
3. HEALTH IDENTIFICATION
EMERGENCY OVERVIEW Appearance: Dark brown liquid Odor: Not determined
WARNING STATEMENT Caution: May cause dizziness & drowsiness. Oil mist may cause respiratory irritation.
Combustible Liquid & Vapor. Do Not use to coat interior of portable water tanks.
HMIS: Health 0, Reactivity 0, Flammability 2, Special -
NFPA: Health 0, Reactivity 0, Flammability 2, Special -
POTENTIAL HEALTH EFFECTS Primary Routes of Exposure: Eye, Skin, Inhalation
EFFECTS OF OVEREXPOSURE - ACUTE
Eyes: May cause minimal irritation, experienced as temporary discomfort.
Skin: Brief contact is not irritating. Prolonged contact, as with clothing wetted with material, may cause defatting of skin or irrita-
tion, seen as local redness with possible mild discomfort. Other than the potential skin irritation effects noted above, acute (short
term) adverse effects are not expected from brief skin contact: see other effects, below & section 11 for information regarding poten-
tial long term effects.
Inhalation: Vapors or mist, in excess of permissible concentrations, or in unusually high concentrations generated from spraying,
heating the material or as from exposure in poorly ventilated areas or confined spaces, may cause irritation of the nose & throat,
headache, nausea, & drowsiness.
Ingestion: If more than several mouthfuls are swallowed, abdominal discomfort, nausea, & diarrhea may occur.
漏 1997 Goodson Shop Supplies
3. HEALTH IDENTIFICATION CONT...
Sensitization Properties: Unknown
Chronic: No adverse effects have been documented in humans as a result of chronic exposure. Section 11 may contain applicable
animal data.
Medical conditions aggravated by exposure: Because of its defatting properties, prolonged & repeated skin contact may aggravate
an existing dermatitis (skin condition).
Other Remarks: Material from high pressure equipment, pinhole leaks, or high pressure line failure can penetrate the skin & if not
properly treated can cause sever injury, including disfigurement, loss of function, or even require amputation of the affected area. To
prevent such serious injury, immediate medical attention should be sought even if the injection injury appears to be minor.
4. FIRST AID
Eyes: Flush eyes with plenty of water for several minutes. Get medical attention if eye irritation persists,
Skin: Wash skin with plenty of soap & water for several minutes. Get medical attention if skin irritation develops or persists.
Ingestion: If more than several mouthfuls of this material are swallowed, give two glasses of water (16oz.). Get medical attention.
Inhalation: If irritation, headache, nausea, or drowsiness occurs, remove to fresh air. Get medical attention if breathing becomes dif-
ficult or respiratory irritation persists.
Other Instructions: High pressure injection of material can cause severe injury. Failure to debride the would of all residual material
can result in disfigurement, loss of function, or may require amputation of the affected area. Remove & dry-clean or launder clothing
soaked or soiled with this material before reuse. Dry cleaning of contaminated clothing may be more effective than normal launder-
ing. Inform individuals responsible for cleaning of potential hazards associated with handling contaminated clothing.
5. FIREFIGHTING MEASURES
Ignition Temperature - AIT: not determined
Flash Point(掳F): 125掳F (COC)
Flammable Limits (%): Upper: not determined Lower: not determined
Recommended Fire Extinguishing Agents & Special Procedures: Use water spray, dry chemical, foam, or carbon dioxide to extin-
guish flames. Use water spray to cool fire-exposed containers.
Unusual or Explosive Hazards: None
Extinguishing Media which must NOT be used: not determined
Special Protective Equipment for Firefighters: No special equipment or procedures required.
6. ACCIDENTAL RELEASE MEASURES
Procedures in case of accidental release, breakage or leakage: Ventilate area. Avoid breathing vapor. Wear appropriate personal
protective equipment, including appropriate respiratory protection. Contain spill if possible. Wipe up or absorb on suitable material
and shovel up. Prevent entry into sewers & waterways. Avoid contact with skin, eyes or clothing.
7. HANDLING AND STORAGE
Precautions to be Taken in Handling: Minimum feasible handling temperatures should be maintained.
Precautions to be Taken in Storage: Store away from heat & open flame. Periods of exposure to high temperatures should be
minimized. Water contamination should be avoided.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
PERSONAL PROTECTION
Eye/Face Protection: Safety glasses, chemical type goggles, or face shield recommended to prevent eye contact.
Skin Protection: Workers should wash exposed skin several times daily with soap & water. Soiled work clothing should be
laundered or dry-cleaned.
Respiratory Protection: Airborne concentrations should be kept to lowest levels possible. If vapor, mist or dust is generated & the
occupational exposure limit of the product, or any component of the product, is exceeded. Use appropriate NIOSH or MSHA ap-
proved air purifying or air supplied respirator after determining the airborne concentration of the contaminant. Air supplied respirators
should always be worn when airborne concentration of the contaminant or oxygen content is unknown.
Ventilation: Adequate to meet component occupational exposure limits (see Section 2).
Exposure Limit for Total Product: None established for product: refer to Section 2 for component exposure limits.
MSDS RPC-2 Page 2
9. PHYSICAL PROPERTIES
Appearance: dark brown liquid Odor: not determined
Boiling Point (掳F): not determined Vapor Pressure: not determined
Melting / Freezing Point: not applicable Vapor Density: not determined (air=1)
Specific Gravity: not determined (water=1) Viscosity: not determined
pH of undiluted product: not applicable Solubility in Water(%): not determined
VOC Contact: not determined Other: None
10. STABILITY & REACTIVITY
This Material Reacts Violently with: (If OTHERS is checked below, see comments for details.)
AIR WATER HEAT STRONG OXIDIZERS OTHERS NONE OF THESE
-- -- -- X -- --
Comments: None
Products Evolved when Subjected to Heat or Combustion: Toxic levels of carbon monoxide, carbon dioxide, irritating aldehydes
& ketones.
Hazardous Polymerizations: Do not occur.
11. TOXICOLOGICAL INFORMATION
TOXICOLOGICAL INFORMATION (ANIMAL TOXICITY DATA)
Median Lethal Dose: Oral: LD50 believed to be >5.00g/kg (rat) practically non-toxic Inhalation: not determined
Dermal: LD50 believed to be >2.00g/kg (rabbit) practically non-toxic
Irritation Index, Estimation of Irritation (species): Skin: (Draize) believed to be <.50/8.0 (rabbit) no appreciable effect
Eyes: (Draize) believed to be <15.00/110 (rabbit) no appreciable effect
Sensitization: not determined
Other: none
12. DISPOSAL CONSIDERATIONS
Waste Disposal Methods: This product (as presently constituted) has the RCRA characteristics of ignitability and if discarded in it
present form, would have the hazardous waste number of D001. Under RCRA, it is the responsibility of the user of the product to de-
termine, at the time of disposal, whether the product meets RCRA criteria for hazardous waste. This is because the product uses,
transformations, mixtures, processes, etc. may change the classification to non-hazardous, or hazardous for reasons other than, or in
addition to ignitability.
Remarks: None
13. TRANSPORT INFORMATION
DOT: Proper Shipping Name: Combustible liquid, N.O.S. (petroleum distillate)
Hazard Class: Combustible liquid (LAND TRANSPORT ONLY - 49CFR 173.120 (b) (2))
Identification No.: NA 1993
Packing Group: III
Label Required: None
IMDG: Proper Shipping Name: Petroleum distillates, N.O.S.
Hazard Class: 3.3
Identification No.: UN 1268 (P.G. III)
Label Required: Flammable liquid
ICAD: Proper Shipping Name: Petroleum distillates, N.O.S.
Hazard Class: 3
Identification No.: UN 1268 (P.G. III)
Label Required: Flammable liquid
TDG: Proper Shipping Name: not evaluated
MSDS RPC-2 Page 3
14. REGULATORY INFORMATION
FEDERAL REGULATIONS
SARA TITLE III, Section 302/304 Extremely Hazardous Substances:
Seq. Chemical Name CAS # Range in %
None
Section 311 Hazardous Categorization:
Acute Chronic Fire Pressure Reactive N/A
-- -- X -- -- --
Section 313 Toxic Chemical:
Chemical Name CAS # Concentration
None
CERCLA 102 (a)/DOT Hazardous Substances: (+ indicates DOT Hazardous Substance)
Seq. Chemical Name CAS # Range in %
None
CERCLA/DOT Hazardous Substances (Sequence Numbers & RQ's):
Seq. RQ
None
TSCA Inventory Status: This product, or its components are listed on or are exempt from the Toxic Substance Control Act (TSCA)
Chemical Substance Inventory.
Other: None
STATE REGULATIONS
California Proposition 65: The following detectable components of this product are substances or belong to classes of sub-
stances, known to the State of California to cause cancer and/or reproductive toxicity.
Chemical Name CAS #
None
States Right-to-Know Regulations:
Chemical Name State Right-to-Know
Stoddard solvent Florida, Illinois, Massachusetts, New Jersey, Pennsylvania, Rhode Island
INTERNATIONAL REGULATIONS
WHMIS Classification: Class B, Div 3: Combustible liquid
Canada Inventory Status: This product, or its components, are listed on or are exempt from the Canadian Domestic
Substance List (DSL).
EINECS Inventory Status: not determined
Australia Inventory Status: This product, or its components, are listed on or are exempt from the Australian Inventory of
Chemical Substance (AICS).
Japan Inventory Status: not determined
15. ENVIRONMENTAL INFORMATION
Aquatic Toxicity: not determined
Mobility: not determined
Persistence & Biodegradability: not determined
Potential to Bioaccumulate: not evaluated
Remarks: not evaluated
16. OTHER INFORMATION
This product is not recommended for coating the interior of portable water tanks.
The information contained herein is believed to be accurate. It is provided independently of any sale of the product for purpose of
hazard communication. It is not intended to constitute performance information concerning the product. No express warranty, or im-
plied warranty of merchantability or fitness for a particular purpose is made with respect to the product or the information contained
herein.
MSDS RPC-2 Page 4
|