Material Safety Data Sheet SKC-S
Complies with OSHA's Hazard Communication
Standard 29 CFR 1910.1200.
DATE OF PREPARATION: May 12, 2008
1. PRODUCT IDENTIFICATION
Part No. & Description: SKC-S Spotcheck庐Cleaner/Remover
Product Use: Wipe on solvent cleaner/remover for penetrant inspection
NFPA Rating: Health 1, Flammability 3, Reactivity 0
PIN (Canada): Bulk: UN1268
2. HAZARDOUS INGREDIENTS
Emergency Phone: 800-688-4005 (24 hours)
Ingredient Wt./Wt. % CAS# TLV PEL LD50 LC50
300ppm 5 g/kg 3400 ppm
Light aliphatic solvent naphtha 60-100 64742-89-8 (8 hr. TWA) not avail. (oral/rat) (4 hrs/rat)
3. HAZARDS IDENTIFICATION
Carbon dioxide propellant (Aerosol Only) 3-7 124-38-9 not avail. 5000 ppm not avail. not avail.
Emergency Overview: Flammable liquid and aerosol. Vapor may cause flash fire. Harmful or fatal if swallowed. Mist or vapor may irri-
tate the respiratory tract. Liquid contact may cause eye and skin irritation. Over exposure may cause central nervous systems (CNS) de-
pression and target organ effects. Spills may create a slipping hazard.
POTENTIAL HEALTH EFFECTS & SIGNS & SYMPTOMS OF EXPOSURE:
Skin Contact: Irritating to skin. Repeated exposure may cause skin dryness or cracking.
Eyes: Vapors may be irritating to the eye.
Inhalation: Vapors expected to be slightly irritating. Vapors may cause drowsiness and dizziness.
Ingestion: Harmful: may cause lung damage if swallowed.
Medical conditions known to be aggravated by exposure to product: Pre-existing medical conditions of the following organ(s) or organ
4. FIRST AID
systems(s) may be aggravated by exposure to this material: Eyes, Skin, Respiratory system.
Skin Contact: Wash off with soap and water. Use soothing lotion.
Eyes: Rinse carefully under upper and lower eyelids using plenty of water. Rest eyes for 30 minutes. If redness, burning,
blurred vision, or swelling persist, transport to the nearest medical facility for additional treatment.
Inhalation: Remove to fresh air if dizzy or nauseated. If rapid recovery does not occur, transport to nearest medical facility for
additional treatment.
Ingestion: Do not induce vomiting. Transport to nearest medical facility for additional treatment. If vomiting occurs sponta-
neously, keep head below hips to prevent aspiration.
NOTE: In all severe cases, contact physician immediately. Local telephone operators can furnish number of regional poison control cen-
5. FIRE HAZARD
ter.
Conditions of flammability: Bulk and aerosol: Readily ignited in presence of ignition sources.
Flash point: Min. 57掳F (14掳C) (Pensky-Martens) closed cup.
Flammable limits in air: 1% to 6%.
Extinguishing media: Carbon dioxide, foam.
Special fire fighting procedures: Keep containers cool with water spray. Do not spray water directly on burning SKC-S. It
will float and spread the fire.
Hazardous combustion products: Smoke, soot, oxides of carbon.
Unusual fire hazards: Aerosol cans may burst if heated above 130掳F (54掳C) and spray contents into a fire.
6. ACCIDENTAL RELEASE MEASURES
Mop up or sweep up with absorbent. Avoid contact with spilled or released material. Immediately remove all contaminated clothing.
7. HANDLING AND STORAGE
(For disposal, see Section 13.)
Avoid eye contact. Avoid repeated or prolonged skin contact. Avoid breathing spray mist. Do not spray near arcs or flames. Use only
in well ventialted areas. Wash thoroughly after handling.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Controls: Use where ventilation will carry spray mist away from occupied areas.
Personal protection: Wear safety glasses to protect eyes. Wear nitrile rubber gloves if hand exposure is unavoidable.
漏 2008 Goodson Shop Supplies
Respirator with solvent vapor absorbing cartridge if used in enclosed, unventilated space.
9. PHYSICAL PROPERTIES
Initial boiling point (bulk): Min. 245掳F (118掳C) (ASTM D-86) Vapor pressure: 12 and 16 oz Aerosol: 105 psi @ 75掳F (24掳C)
Bulk: 1.5 - 2.0 kPa at 68.0掳F
VOC Content (EPA Method 24): 750 g/L Vapor density: 4.1
Density/sp. gravity: 0.76 Evaporation rate: Fast
Water Solubility: 0 Appearance: Clear, colorless liquid
10. STABILITY AND REACTIVITY
pH: Neutral Odor: Naphtha odor
Stability: Stable under normal conditions of use
Incompatibility: Avoid heat, sparks, open flames and other ignition sources. Avoid strong oxidizing agents.
Hazardous decomposition products:A complex mixture of airborne solids, liquids, and gases, including carbon monoxide, carbon
dioxide and other organic compounds will be evolved when this material undergoes combustion
or thermal or oxidative degradation.
11. TOXICOLOGICAL INFORMATION
Reactivity: None
Carcinogenicity: Contains no known or suspected carcinogens listed with OSHA, IARC, NTP, or ACGIH.
Threshold limit value: 300 ppm
WHMIS information (Canada): According to available information, the ingredients have not been found to show reproductive
toxicity, teratogenicity, mutagenicity, skin sensitization, or synergistic toxic effects with other ma-
12. ECOLOGICAL INFORMATION
terials.
No data is available on SKC-S. It floats on water and evaporates away. It is 100% VOC.
13. DISPOSAL
As hazardous waste, send to licensed waste handler who can blend it into secondary fuels.
RCRA: Hazardous waste.
14. TRANSPORTATION
U.S. EPA Waste Number: D001
U.S. DOT: 49 CFR 172.101 Hazardous Materials Table
Non-Aerosol Aerosol
Proper shipping name: Petroleum distillates, n.o.s. Consumer Commodity
Hazard class or division: 3 ORM-D
Identification No.: UN1268 None
Packing Group: II None
IATA: List of Dangerous Goods Non-Aerosol Aerosol
Proper shipping name: Petroleum distillates, n.o.s. Aerosols, flammable
Hazard class or division: 3 2.1
Identification No.: UN1268 UN1950
Packing Group: II -
IMDG: General Index Non-Aerosol Aerosol
Proper shipping name: PETROLEUM DISTILLATES, N.O.S. AEROSOL
Hazard class or division: 3.2 2.1
Identification No.: UN1268 UN1950
Packing Group: II -
15. REGULATORY INFORMATION
TSCA: All ingredients are listed in TSCA inventory.
Canadian DSL: All ingredients are listed in the Canadian DSL.
CERCLA: VM&P Naphtha (64742-89-8) Reportable Quantity 66,667 lbs.
SARA Title III, Section 313: Xylene, Mixed Isomer (1330-20-7) <0.13%; meta-Xylene (108-38-3) <0.05%; Ethylbenzene
(100-41-4)<0.03%; Benzene (71-43-2) <0.005%; Toluene (108-88-3) <0.01%
California Proposition 65: Warning: This material may contain trace amounts of chemicals known to the state of California
to cause cancer and/or birth defects and/or reproductive harm.
WHMIS Class (Canada): Non-Aerosol: B-2, D-2B; Aerosol: A, B-5, D-2B
Note: This MSDS has been prepared to meet WHMIS (Canada) requirements with the exception of using 16 headings.
DISCLAIMER: THE INFORMATION AND RECOMMENDATIONS SET FORTH HEREIN ARE TAKEN
FROM SOURCES BELIEVED TO BE ACCURATE AS OF THE DATE HEREOF; HOWEVER, THE COM-
PANY MAKES NO WARRANTY WITH RESPECT TO THE ACCURACY OF THE INFORMATION OR
THE SUITABILITY OF THE RECOMMENDATIONS, AND ASSUMES NO LIABILITY TO ANY USER
THEREOF.
MSDS SKC-S Page 2
|