A-9 ALUMINUM CUTTING FLUID
Page 1
NFPA
Fire HMIS
1 Health 1
MATERIAL SAFETY DATA SHEET
Health 1
1 Reactivity Fire 1
Reactivity 1
Meets requirements of 29 CFR 1910.1200
(Federal Hazard Communication Standard)
SECTION I
PRODUCT NAME OR NUMBER A-9庐 ALUMINUM CUTTING FLUID
MANUFACTURER鈥橲 NAME EMERGENCY TELEPHONE NO
Relton Corporation Chemtrec - (800) 424-9300
ADDRESS (Number, Street, City, State, and Zip Code) Non-Emergency Ph. No.
317 Rolyn Place, Arcadia, CA 91007-2838 (323) 681-2551 (800) 423-1505
HAZARDOUS MATERIALS DESCRIPTION AND PROPER SHIPPING NAME (49 CFR 172 101) HAZARD CLASS (49 CFR 172.101)
NA NA NA
CHEMICAL FAMILY Formula
See Section II
Mixture: predominately hydrocarbon base with bland additives.
SECTION I I - INGREDIENTS TLV PEL STEL C.A.S. NO. %
Mineral Oil NE NE NE 64742-58-1 > 70
Bland Additive NE NE NE Trade secret < 25
Bland Additive NE NE NE Trade secret < 16
Perfume NE NE NE -- -- <1
Green dye, Pharmacy Grade NE NE NE -- -- trace
(See Section V for Health data)
Data is based on testing mixture as a whole. Neither the mixture nor any of its ingredients is on the carcinogen or
suspected-carcinogen list of the NTP, the IARC, or OSHA. Contains no Calif. Prop. 65 substance. Not reportable
under SARA. All components are listed on the TSCA inventory.
SECTION III - PHYSICAL DATA
BOILING POINT ( X潞F ) ( C潞 ) 400潞 F SPECIFIC GRAVITY ( H2O=1 ) @ 25潞 C 0.883 Freezing Point -20潞 F
VAPOR PRESSURE ( mm Hg ) 100潞 F: .1 mm PERCENT VOLATILE BY VOLUME ( % ) NA VOC NA
VAPOR DENSITY ( AIR=1 ) NA EVAPORATION RATE ( WATER=1 ) NA
SOLUBILITY IN WATER Negligible pH= NA
MATERIAL IS LIQUID SOLID
APPEARANCE AND ODOR light green oil with slight,fatty odor. GAS PASTE POWDER
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT ( method used ) FLAMMABLE LIMITS LFL UFL
266潞 F CCC
Non-Flammable NA NA
EXTINGUISHING MEDIA Use CO2, dry chemicals , foam, water as a mist only.
SPECIAL FIRE FIGHTING PROCEDURES Prefer CO2 or sand as with oil fire.
UNUSUAL FIRE AND EXPLOSION HAZARDS No unusual hazards
Exposing containers to intense heat could cause drums to rupture. Cool fire-exposed containers with water spray to prevent rupture.
SECTION V - HEALTH HAZARD DATA
EFFECTS OF OVEREXPOSURE
Eyes and skin: may cause mild irritation. Inhalation: may cause mild upper respiratory irritation. Ingestion: possible nausea.
EMERGENCY AND FIRST AID PROCEDURES
Eyes: flush for 15 min. with water. Skin: wash with soap and water. Inhalation: remove to fresh air.
Ingestion: do not induce vomiting; give lots of water to a conscious person. Call Doctor
NE=not established NF=not found NA=not applicable ND=not determined
A-9 ALUMINUM CUTTING FLUID
Page 2
SECTION VI - REACTIVITY DATA
STABILITY UNSTABLE CONDITIONS TO AVOID:
STABLE X Flame, heat, strong oxidizing agents
INCOMPATIBILITY (materials to avoid): Swells natural rubber and some plastics. Slight etching of light metals on prolonged
exposure may occur.
HAZARDOUS DECOMPOSITION PRODUCTS. CO, CO2, and acrolein when combusted
HAZARDOUS MAY OCCUR CONDITIONS TO AVOID:
POLYMERIZATION WILL NOT OCCUR X NA
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED.
Wear respirator and protective clothing .Treat as oil spill. Soak up on absorbent clay or sand and remove to containers.
WASTE DISPOSAL METHOD Transport in DOT-approved container to EPA-approved treatment, storage, and disposal facility.
Follow local, State & Federal disposal regulations.
SECTION VIII - SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION (specify type) Normally not needed. For oil-type mist, use NIOSH listed respirator.
VENTILATION LOCAL EXHAUST (Specify Rate) SPECIAL Not required normally
Local-mechanical Adequate to avoid fumes and oil mists
to remove oil mist MECHANICAL (General) (Specify Rate) NA OTHER
PROTECTIVE GLOVES Nitrile-type, oil resistant EYE PROTECTION Chemical goggles or full faceshield.
OTHER PROTECTIVE EQUIPMENT Clean clothes. Apron or chemical suit where splashing may occur.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Avoid production of oil mist. Avoid excessive heat. Avoid repeated or prolonged skin or eye contact.
OTHER PRECAUTIONS
While there is no TLV established for this product, airborne mist should be kept below the nuisance TLV for oil mist: 5Mg/meter3.
ADDITIONAL INFORMATION
DOT: No hazardous substance UN or NA#: Not applicable
No hazard class Freight Classification: Petroleum oil, lubricating
No DOT ID# It# 155250 Class 65
SARA: Not considered to be subject to Title III
TSCA: All components required to be listed on the inventory are listed.
IARC-NTP-OSHA: Neither the mixture nor any component is listed as a carcinogen or suspected carcinogen.
California Prop. 65 Material: None.
Prepared: 12-10-93 Updated: 10-23-97
Updated: 12-6-94 Updated: 02-29-00
Updated: 5-7-96 Updated: 03/10/03
317 ROLYN PLACE ARCADIA CALIFORNIA 91007-2838 Updated: 07/22/05
Phone: (323) 681-2551 (800) 423-1505
Emerg: Chemtrec - (800) 424-9300
by Dr. Robert E. Pratt,
consulting chemist
Updated 04/01/08
|