Material Safety Data Sheet
SECTION 1 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
EP HYDRAULIC OIL 68
MOTOR OIL, INC.
1490 Jarvis Avenue
Elk Grove Village, IL 60007
Phone (847) 956-7550 Fax (847) 956-0399
CAS Registry Number Not applicable for mixtures
Chemical Family Petroleum hydrocarbon
Product Type Premium quality anti-wear hydraulic oil
Preparation/Revision Date 04/2008
SECTION 2 COMPOSITION / INFORMATION ON INGREDIENTS
Component Name CAS Number OSHA PEL ACGIH TLV % (Optional)
Petroleum Lubricating Base Stock 64742-54-7 5 mg/m鲁 5 mg/m鲁 >99
Zinc Alkyl Dithophosphate 68649-42-3 NE NE <.05
Alkylated Phenol Trade Secret NE NE <.03
Calcium Phenate Trade Secret NE NE <.01
2-Ethlyhexanol 104-76-7 NE NE <.01
SECTION 3 HAZARDS IDENTIFICATION
Contains petroleum oil.
Principal Hazard(s)
Avoid breathing mists or vapors.
Avoid prolonged or repeated skin contact.
SECTION 4 FIRST AID MEASURES
DO NOT induce vomiting. Get immediate medical attention
Oral
Flush eye(s) with water for at least 15 minutes or until irritation subsides. Get medical attention if eye irritation
Eye
develops or persists
Wash with soap and water. Immediately remove contaminated clothing. Get medical attention if irritation
Skin
develops. Launder contaminated clothing before re-use. If product is injected into or under the skin, or into
any part of the body, regardless of the appearance of the wound or its size, the individual should be evaluated
immediately by a physician as a surgical emergency. Even though initial symptoms from high pressure
injection may be minimal or absent, early surgical treatment within the first few hours may significantly reduce
the ultimate extent of injury.
Vapor pressure is very low. Vapor inhalation under ambient conditions is normally not a problem. If adverse
Inhalation
effects are observed, remove exposed person to fresh air. If breathing is labored, administer oxygen. If
breathing has stopped, apply artificial respiration. If overexposed to oil mist, remove from further exposure
until excessive oil mist subsides.
SECTION 5 FIRE FIGHTING MEASURES
220 潞C COC Typical
Flash Point
Not Determined
Upper Flammable Limit
Not Determined
Lower Flammable Limit
Carbon Dioxide, dry chemical, water spray (fog) and foam. Note: water, water
Extinguishing Media
fog and foam may cause frothing and spattering.
Wear self-contained breathing apparatus. Avoid breathing fumes and vapors.
Special Firefighting Procedures
Use water spray (fog) to cool containers exposed to high heat or open flames.
Empty containers contain residue and/or vapors. DO NOT WELD, CUT,
Unusual Fire and
PRESSURIZE, BRAZE, SOLDER, DRILL, GRIND OR EXPOSE SUCH
Explosion Hazards
CONTAINERS TO HEAT, SPARKS, FLAME, STATIC ELECTRICITY OR
OTHER SUCH SOURCES OF IGNITION. Keep empty containers closed and
dispose of in an environmentally safe manner and in accordance with all
government regulations.
Not Determined
Autoignition Temperature
SECTION 6 ACCIDENTAL RELEASE MEASURES
Evacuate all non-essential personal. Personal Protective Equipment must be worn
Spill Procedures
(see Personal Protection Section for PPE recommendations). Remove sources of
ignition. Ventilate spill area. Prevent entry into sewers and waterways. Pick up free
liquid for recycle and/or disposal. Residual liquid can be absorbed on inert
material. Assure conformity with applicable Federal, state and local regulations.
SECTION 7 HANDLING AND STORAGE
Keep away from potential sources of ignition. Avoid breathing vapors if present.
Handling Procedures
Keep containers closed when not in use. Wash thoroughly after handling. Make
sure that proper warning labels are affixed in accordance with 29 CFR 1910.1200.
Use good personal hygiene around product. Do not smoke or eat around product.
Do not store near potential sources of ignition. Store in a well ventilated area.
Storage Procedures
Store in a dry area. Do not store around food or eating areas.
SECTION 8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Use material in well ventilated areas only. Additional ventilation or exhaust may
Ventilation Procedures
be required to maintain air concentrations below recommended exposure limits.
Use chemical resistant gloves, if needed, to avoid prolonged or repeated skin
Glove Protection
contact.
Safety glasses recommended. Use splash goggles or face shield when eye
Eye Protection
contact may occur.
Under normal conditions, respirator is not usually required. Use NIOSH/MSHA
Respiratory Protection
approved disposable dust/mist mask if the recommended exposure limit is
exceeded.
Use a chemical resistant apron or other impervious clothing, if needed, to avoid
Clothing Recommendation
contaminating regular clothing, which could result in prolonged or repeated skin
contact.
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
Brown colored liquid Not Determined
Appearance Vapor Pressure
0.88 Greater than 5
Specific Gravity Vapor Density (Air = 1)
Approx 68 cSt @ 40 潞C Not Determined
Viscosity Evaporation Rate
Typical oil odor -20 潞F
Odor Pour or Melting Point
Essentially neutral IBP approximately 600 潞F
pH Boiling Point
Not Determined Not Determined
Odor Threshold Percent Volatile
Negligible Not Determined
Water Solubility Molecular Weight
SECTION 10 STABILITY AND REACTIVITY
Material is normally stable at room temperature and pressure. See the Handling
Stability
and Storage Section for further details.
Strong oxidizing agents.
Incompatibility
Will not occur.
Hazardous Polymerization
Fumes, smoke, carbon monoxide, sulfur oxides, aldehydes and other
Thermal Decomposition
decomposition products, in the case of incomplete combustion.
SECTION 11 TOXICOLOGICAL INFORMATION
Not Determined.
Oral Toxicity
Product contacting eyes may cause eye irritation.
Eye Irritation
May cause skin irritation. Prolonged or repeated contact may cause dermatitis.
Skin Irritation
Symptoms may include redness, edema, drying, defatting and cracking of skin.
Not Determined.
Dermal Toxicity
Not Determined.
Inhalation Toxicity
If material is misted or if vapors are generated from heating, exposure may cause
Respiratory Irritation
irritation of mucous membranes and the upper respiratory tract.
No data available to indicate product or components may be skin sensitizer.
Dermal Sensitivity
No data given to indicate product or components may be respiratory sensitizer.
Inhalation Sensitivity
Not Determined.
Chronic Toxicity
The components of this product has not been found to be a carcinogen under either
Carcinogenciity
NTP, IARC Monographs or current OSHA regulations.
Under conditions which may generate mists, observe the OSHA PEL 5 mg/m鲁.
Other
SECTION 12 ECOLOGICAL INFORMATION
No Data Given.
SECTION 13 DISPOSAL CONSIDERATIONS
Not regulated by DOT
U. S. DOT Shipping Name
Not applicable
Hazard Class
Not applicable
DOT Identification Number
Not regulated by DOT
DOT Shipping Label
SECTION 14 WASTE DISPOSAL INFORMATION
This product is not considered a hazardous waste under RCRA regulations. After use, it is the
WASTE DISPOSAL
responsibility of the user to determine the products status for disposal. This product can be
incinerated, if practical, or recycled.
SECTION 15 REGULATORY INFORMATION
All components of this product are listed on the TSCA Inventory.
U. S. TSCA Inventory
No RQ for product or any constituent greater than 1.0% or 0.1% (carcinogen).
SARA 302 Threshold
Planning Quantity
No RQ for product or any constituent greater than 1.0% or 0.1% (carcinogen).
SARA 304 Reportable Qty
SARA 311 Categories EPA Hazard Classification Code
Acute Chronic Fire Pressure Reactivity
No No No No No
This product does not contain greater than 1.0% (greater than 0.1% for carcinogenic
SARA 313 Supplier
substances) of any chemical substances listed under SARA Section 313.
Notification
No chemicals in this product are subject to the reporting requirements of CERCLA.
CERCLA Hazardous
Substances
SECTION 16 OTHER INFORMATION
HAZARDOUS MATERIALS IDENTIFICATION SYSTEM (HMIS)
HEALTH = 1 FIRE = 1 REACTIVITY = 0 PP = B
Rating: 0 = Minimal 1 = Slight 2 = Moderate 3 = Serious 4 = Extreme
Although the information and recommendations set forth herein are presented in good faith and believed to be correct
as of the date hereof, MOTOR OIL, INC. makes no representations as to the completeness or accuracy thereof.
MOTOR OIL, INC. makes no warranty whatsoever, expressed or implied, of MERCHANTABILITY OR FITNESS FOR
THE PARTICULAR PURPOSE since the conditions of use are beyond our control. MOTOR OIL, INC. assumes no
responsibility for injury to recipient or to third persons for any damage to any property and recipient.
|