Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
Material Safety Data Sheet
1. Company and Product Identification
TYTANTM PAINTABLE WINDOW&DOOR CAULK
Product type:
Acrylic Sealant
Product description:
National Fire Protection Association (NFPA) Profile
Health: 1
Flammability: 0
Instability/Reactivity: 0
Personal Protection: D
SELENA USA, Inc.
Manufacturer:
21715 Beck Drive,
Elkhart, IN 46516
USA
(574)-523-0400; (877)-735-3627(toll free)
Phone number:
CHEMTREC +1 (800) 424-9300
Emergency phone number:
www.SelenaUSA.com
Website:
2. Hazards Identification
Effects of Overexposure
Acute Effects:
Direct contact may cause slight to moderate irritation.
Eye:
May cause allergic skin reactions and/or central nervous system depression.
Skin:
May cause slight irritation to respiratory passages 鈥? headache 鈥? dizziness.
Inhalation:
Low ingestion hazard in normal use.
Oral:
Prolonged/Repeated Exposure Effects:
May cause allergic skin reactions, defatting, drying, and dermatitis
Skin:
No known applicable information.
Inhalation:
May cause adverse kidney effects.
Oral:
Some adverse reproduction effects have been reported in animals.
Other:
Page 1/8
Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
3. Composition/ Information on Ingredients
CAS NO %Wt TLV
Ingredient PEL-TWA
2mg/m3 15mg/m3
Limestone 1317-65-3 45-65
Mineral Spirit 8052-41-3 0.05-3 100 ppm 100 ppm
Ethylene Glycol 107-21-1 0.05-3 Not Established Not Established
Acrylic Polymer Proprietary 30-45 Not Established Not Established
5mg/m3 5mg/m3
Butyl Benzyl Phthalate 85-68-7 4-10
Water 7732-18-5 >5 Not Established Not Established
15mg/m3 15mg/m3
Titanium Dioxide 13463-67-7 0.025-5
4. First Aid Measures
Flush with large volumes of water for 15 to 30 minutes. Remove contacts after the
Eye:
first 2 minutes of flushing. Get medical attention.
Wash with soap and water or waterless cleanser. Get medical attention if irritation
Skin:
develops or persists.
Move to fresh air. Get medical attention.
Inhalation:
Do not induce vomiting. Seek medical attention from a physician. Never give
Oral:
anything by mouth to an unconscious person.
No ingredient in this product is an IARC, NTP or OSHA listed carcinogen.
Other:
5. Fire-Fighting Measures
Waterbased product flash point not applicable.
Flash Point:
Waterbased product, not an explosion hazard.
Explosion Hazard:
Not applicable.
LEL:
Carbon dioxide, dry chemical, foam, or water spray.
Extinguishing Media:
Unusual Fire and
Material can splatter above 200潞F.
Explosion Hazards:
Special Fire Fighting
Water can be used to cool fire-exposed containers. Self-contained
Procedures:
breathing apparatus and protective clothing should always be worn when
fighting large fires involving chemicals.
6. Accidental Release Measures
In the case of accidental release or spill: Follow all recommendations regarding Personal
Page 2/8
Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
Protective Equipment. Preferred method would be to
scrape up spilled material and place in secondary
container for disposal. Smaller spills can also be wiped
up. Residual material can be removed with the assistance
of hot water and soap. White water should be captured
and contained for disposal.
All material must be disposed in accordance with
Disposal method:
Federal, State and Local Regulations. This includes any
white water created in the cleaning of the spill.
7. Handling and Storage
Protect from freezing.
Rotate all stock.
Store in a cool, dry place.
Keep away from food, feed, or drinking water.
Keep container closed when not in use.
This formulation contains material which in their raw form are considered dust hazards. When in this
formulation, the dust hazards are essentially eliminated.
8. Exposure Control / Personal Protection
Component exposure limits:
Ethylene Glycol: 100 ppm Ceiling ACGIH
Personal Protection:
Use adequate ventilation. None needed if concentrations are kept
Respiratory protection:
below the listed exposure limits.
Chemical resistant gloves are recommended for prolonged
Skin protection:
exposure. Clothing should be such that it protects skin from direct
contact with sealant.
Safety glasses with side shields (ANSIZ87.1 or approved
Eye protection:
equivalent).
None required.
Other protective equipment:
9. Physical and Chemical Properties
Paste consistency. Can be white or colored.
Appearance:
Sweet acrylic, with a mild ammonia odor
Odor:
Page 3/8
Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
Paste
Physical state:
7.5-9
pH as supplied:
< 32潞F
Freezing Point:
>200潞F
Boiling Point:
25 mm Hg@ 68潞F
Vapor Pressure (mmHg):
>than 1
Vapor density (Air=1):
Slower than Ether
Evaporation rate:
Dispersible
Solubility in Water:
13.0-14.0 Lbs/Gallon
Weight per gallon:
20-40%
% Volatile by Volume:
10. Stability and Reactivity
Stable (keep below 200潞F)
Stability:
Store away from strong oxidizers
Conditions to avoid:
Strong oxidizers
Incompatibility (Materials to avoid):
None known
Hazardous Decomposition or By-Products:
Will not occur
Hazardous Polymerization:
11. Toxicological Information
Acute Data: No toxicity data are available for this material. Section 3 is based on profiles of similar
materials.
12. Ecological Information
Latex dispersions will color water a milky white, but no bioconcentration is expected because of
the high molecular weight.
No other applicable data.
13. Disposal Consideration
Waste Disposal Method: All waste must be disposed in accordance with Federal, State and Local
Regulations (see 40 CFR Part 268).
Page 4/8
Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
14. Transport Information
Not a DOT Regulated Material
DOT Shipping Name:
None
DOT Hazard Class:
None
DOT UN/ NA Number:
None
Packaging Group:
15. Regulatory Information
OSHA Hazard: 29 CFR 1910.1200
Not a hazardous chemical as defined by this
standard.
SARA Title III: Section 313 Information (40 CFR 372)
This product does not contain a chemical which is
listed in Section 313 at or above 鈥渄e minimis鈥?
concentrations.
CERCLA: Information (40 CFR 302.4)
Releases of this material to air, land or water are not
(to the best of our knowledge) reportable to the
National Response Center under the Comprehensive
Environmental Response, Compensation, And
Liability Act (CERCLA) or to state and local
emergency planning committees under the
Superfund Amendments and Reauthorization Act
(SARA Title III Section 304).
When a decision is made to discard this material as
supplied, it is classified as a RCRA non-hazardous
Waste Classification:
waste.
All chemical substances in this product are included
on, or exempted from listing on the TSCA
TSCA Status:
Inventory of Chemical Substances.
This product contains trace amounts of components
known to the state of California to cause cancer.
California Prop 65:
The following components are cited in the
Pennsylvania Hazardous Substances List, and are
Pennsylvania (Worker and Community
present a levels that require reporting.
Right To Know Act):
107-21-1 >2%
Ethylene Glycol
< 50 g/l
Regulatory VOC:
16. Other Information
Keep out of children. Keep container closed when not in use.
Page 5/8
Material Safety Data Sheet
Issued: 2007-11-29
Revised: 2008-04-08
TYTAN鈩? PWD4
PRODUCT:
Warning: When scraping, sanding or removing old paint you may release lead dust. LEAD IS
TOXIC. Exposure to led dust can cause series illness. This can include brain damage, especially in
children. Pregnant women are also particularly at risk and should avoid exposure. Clean up area
with a HEPA vacuum and a wet mop Before starting any project that may exposure individuals to
paint dust, find out how to protect yourself, your workers and your family by contacting the
National Lead Information Hotline at 1-800-424-LEAD.
All information, recommendation or advice contained in this document or given by Selena Co. SA or
any of its subsidiaries, affiliates or authorized representatives, whether written or oral, is given in
good faith, to the best of its knowledge and based on current procedure in effect. Each user of the
product shall convince himself, through all available sources (including finished product testing in its
appropriate environment) of the suitability of the product supplied for its own particular purpose.
Selena Co. SA, its subsidiaries and affiliates cannot be held responsible for any loss incurred through
incorrect or faulty use of the product. The Material Safety Data Sheet related excessively to the
described product. In case of applying it as a component of the other product, the MSDS is no more
valid.
Page 6/8
|