Gel Loading Buffer II
Material Safety Data Sheet
Cat.# 8546G , 8547
This product contains formamide and therefore this MSDS is written to apply to the Formamide component.
(CAS#75-12-7)
PHYSICAL DATA
Appearance and Odor Dark Blue, slightly hygroscopic oily liquid
Boiling Point 210C
Vapor Density (air = 1) 1.55
Solubility in H2O soluble
CAS# 75-12-7
FIRE AND EXPLOSION HAZARD DATA
Flash Point 154C
Flammable Limits in Air(% by Volume) N/A
Extinguishing Media Water, CO2, Foam, Dry Chemical
Special Fire Fighting Wear self-contained breathing apparatus and full protective
equipment.
Unusual Fire/Explosion Hazards Can produce toxic gases such as carbon monoxide and ammonia
in fire conditions.
HEALTH HAZARD DATA
Effects of Overexposure Causes irritation when inhaled or ingested. May be absorbed
through skin. ALWAYS WEAR GLOVES WHEN HANDLING.
Emergency First Aid Procedures Wash affected area with water. Irrigate eyes for at least 15
minutes. Seek medical attention.
REACTIVITY DATA
Incompatibility Strong oxidizing agents, protect from moisture, acids & bases.
Hazardous Decomposition Products Toxic fumes of CO, CO2, & Nitrogen Oxides.
SPILL OR LEAK PROCEDURES
If released or spilled Absorb with inert material. Wash spill area thoroughly.
Waste Disposal Method Dispose according to federal and local regulations.
SPECIAL PROTECTION AND HANDLING INFORMATION
Respiratory Protection Not expected to require personal respirator usage. (Use NIOSH
approved respirator if necessary)
Ventilation Not expected to require any special ventilation (Lab Hood if
needed)
Precautionary Labeling Avoid contact with skin, eyes and clothing.
Handling and Storage Considerations Laboratory aprons and gloves and eye protection .
This bulletin is for your guidance and is based upon information and tests believed to be reliable. Ambion makes no guarantee of the accuracy or completeness of
the data and shall not be liable for any damages thereto. The data are offered solely for your consideration, investigation, and verification. These suggestions
should not be confused with either state, municipal, or insurance requirements, or with national safety codes and constitute no warranty. Any use of these data and
information must be determined by the user to be in accordance with applicable federal, state, and local regulations.042000 msds\gelload.msd
Ambion, Inc. 鈥? 2130 Woodward St. 鈥? Austin, TX USA 78744-1832 鈥? International Tel: +1 512 651 0200
US Toll-free Tel: 800 888 8804 鈥? E-mail: techserv@ambion.com 鈥? www.ambion.com
www.ambion.com/techlib/msds/msds_8547.pdf
|