Formamide
Material Safety Data Sheet
Cat.# 9342 - 9344
PHYSICAL DATA
Formamide is normally at a concentration of 50% to 80% when used in solutions.
Appearance and Odor Colorless, hygroscopic oily liquid
o
Boiling Point 210 C
3
Specific Gravity (H2O = 1) 1.128 cm
Vapor Density (air = 1) 1.6
Evaporation Rate Not Applicable
Vapor Pressure (mm Hg) 0.08
Solubility in H2O Soluble
CAS# 75-12-7
FIRE AND EXPLOSION HAZARD DATA
o
Flash Point 154 C
Flammable Limits in Air(% by Volume) No Data
Extinguishing Media Water, CO2, Foam, Dry Chemical
Special Fire Fighting Wear self-contained breathing apparatus and protective equipment.
Unusual Fire/Explosion Hazards Moderate, when exposed to heat or flames. Can react with oxidizing
materials.
HEALTH HAZARD DATA
Effects of Overexposure Mists & Heated vapors are irritating to the upper respiratory tract & eyes.
May be teratogenic. Danger of serious irreversible effects.
Emergency First Aid Procedures Wash affected area with water. Irrigate eyes for at least 15 minutes. See
physician.
REACTIVITY DATA
Stability Stable
Incompatibility Strong oxidizing agents, protect from moisture, acids & bases.
Hazardous Decomposition Products Toxic fumes of CO, CO2, & Nitrogen Oxides.
Hazardous Polymerization Will not occur.
SPILL OR LEAK PROCEDURES
If released or spilled Absorb on sand and place in open container for disposal. Ventilate area &
wash spill site.
Waste Disposal Method Dispose according to federal, local and state regulations.
SPECIAL PROTECTION INFORMATION
Respiratory Protection Use NIOSH approved respirator as needed
Ventilation Lab Hood as appropriate
Protective Gloves General lab gloves
Eye Protection Use general lab eye protection-goggles
Precautionary Labeling Avoid contact with skin, eyes and clothing.
Handling and Storage Considerations Laboratory aprons and gloves. Cold Storage.
This bulletin is for your guidance and is based upon information and tests believed to be reliable. Ambion makes no guarantee of the accuracy or completeness of
the data and shall not be liable for any damages thereto. The data are offered solely for your consideration, investigation, and verification. These suggestions
should not be confused with either state, municipal, or insurance requirements, or with national safety codes and constitute no warranty. Any use of these data and
information must be determined by the user to be in accordance with applicable federal, state, and local regulations.042000 msds\formamid.msd
Ambion, Inc. 鈥? 2130 Woodward St. 鈥? Austin, TX USA 78744-1832 鈥? International Tel: +1 512 651 0200
US Toll-free Tel: 800 888 8804 鈥? E-mail: techserv@ambion.com 鈥? www.ambion.com
www.ambion.com/techlib/msds/msds_9342.pdf
|