Monday, May 22, 2006
Page 1 of 4
MSDS - Material Safety Data Sheet
Product Name: Thermoplastic Fingerprint Ink Pad, Stain-Free
MSDS No.: PFP600
I. Basic Information:
Manufacturer: Sirchie Finger Print Laboratories
1
Address: 100 Hunter Place
City, ST Zip: Youngsville, NC 27596
1 0
Emergency Contact: CHEMTREC
Emergency Telephone Number: 800-424-9300
Contact: Tech Support
Information Telephone Number: 919-554-2244
1
1
Last Update: 2-25-2008 Expiration Date:
0
X
Liquid Gas Solid
Chemical State:
B
Pure Mixture
Chemical Type: X
II. Ingredients:
Trade Secret
EHS IARC SARA
313 OSHA ACGIH Other
% Range NTP SUB Z PEL TLV Limits
CAS No. Chemical Name
63231-81-2 2-Pyrrolidinone, 23%
1,-Ethenylhexadecyl, Homopolymer
64742525 Heavy naphthenic hydrotreated 69%
distillate
64742467 Hydrotreated petroleum distillate 8%
III. Hazardous Identification:
Hazard Category:
Acute Chronic Fire Pressure Reactive
Hazardous Identification Information:
When used for its intended purpose, there are no hazards associated with this product.
IV. First Aid Measures:
Route(s) of Entry:
Physical contact.
Health Hazards (Acute and Chronic):
None known.
Signs and Symptoms:
May cause slight irritation of the skin and eyes.
Medical Conditions Generally Aggravated by Exposure:
None known.
Monday, May 22, 2006
Page 2 of 4
MSDS - Material Safety Data Sheet
Product Name: Thermoplastic Fingerprint Ink Pad, Stain-Free
MSDS No.: PFP600
Emergency and First Aid Procedures:
Ingestion: DO NOT induce vomitting. Drick several glasses of water or milk. Contact a physician.
Inhalation: None required.
Skin: Wash with soap and water.
Eyes: Wash with large amounts of water, occasionally lifting eyelids..
Other Health Warnings:
When used for its intended purpose, there are no hazards associated with this product.
V. Fire Fighting Measures:
Flash Point: N/E Lower Explosive Limit: N/E Upper Explosive Limit: N/E
F.P. Method:
Fire Extinguishing Media: Use proper media for primary source of fire.
Special Fire Fighting Procedures:
None Known
Unusual Fire and Explosion:
None Known
VI. Accidental Release Measures:
Steps to be Taken in Case Material is Released or Spilled:
Due to the liquid in this product being fully absorbed into the ink pad, spill is unlikely. Should a small amount be spilled, clean up
with absorbent material, soap and water.
VII. Handling and Storage:
Precautions to be Taken:
Store in a cool, dry area.
Other Precautions:
None necessary.
VIII. Exposure Controls/Personal Protection:
Ventilation Requirements:
No special ventilation required.
Personal Protective Equipment:
Safety glasses and gloves.
Monday, May 22, 2006
Page 3 of 4
MSDS - Material Safety Data Sheet
Product Name: Thermoplastic Fingerprint Ink Pad, Stain-Free
MSDS No.: PFP600
IX. Physical and Chemical Properties:
Boiling Point: N/E Melting Point: N/E
Evaporation Rate (Butyl Acetate = 1): N/E Vapor Pressure (mm Hg.): N/E
Specific Gravity (H20 = 1): Vapor Density (AIR = 1): N/E
Solubility In Water: Not soluble Appearance and Odor:
Other Information:
X. Stability and Reactivity:
Stability:
Stable
Incompatibility (Materials to Avoid):
Strong oxidizing agents
Decomposition/By Products:
Oxides of carbon and nitrogen.
Hazardous Polymerization:
Will not occur
XI. Toxicological Information:
ORAL: LD50 Rat > 64,000 MG/KG
DERMAL: No data found
INHALATION: No data found.
IRRITATION: Skin and eyes: slight.
OSHA: Non-carcinogenic
IARC: Non-carcinogenic
XII. Ecological Information:
No data found.
XIII. Disposal Considerations:
Dispose of according to local, state, and federal regulations.
XIV. Transport Information:
IATA: Not regulated
DOT: Not regulated
XV. Regulatory Information:
Not regulated.
Monday, May 22, 2006
Page 4 of 4
MSDS - Material Safety Data Sheet
Product Name: Thermoplastic Fingerprint Ink Pad, Stain-Free
MSDS No.: PFP600
XVI. Other Information:
Using this product under normal, properly instructed procedures should not be hazardous.
The information above is believed to be accurate and represents the best information currently available to us. However, we make
no warranty of merchantability or any other warranty, expressed or implied, with respect to such information, and we assume no
liability resulting from its use. Users should make their own investigation to determine the suitability of the information for their
particular purposes.
Glossary of abbreviations:
N/A: Not Available, Not Ascertained
N/E Not Established
LD50/LC50: Lethal Dose/Lethal Concentration required to kill 50% of a population of test animals by route of administration
indicated.
|