Thursday, January 17, 2008
Page 1 of 4
MSDS - Material Safety Data Sheet
Product Name: UN-STIK Tape Release Agent
MSDS No.: UNSTIK100
I. Basic Information:
Manufacturer: Sirchie Finger Print Labs, Inc. Contact: Tech Support
Address: 100 Hunter Place Information Telephone Number: 919-554-2244
City, ST Zip: Youngsville, NC 27596 Emergency Contact: CHEMTREC
Country: USA Emergency Telephone Number: 800-424-9300
Emergency Restrictions:
Product Name: UN-STIK Tape Release Agent
MSDS No.: UNSTIK100
Issue Date: 01/17/2008
Supersedes Date: Not Available
II. Hazards Identification:
EMERGENCY OVERVIEW
Flammable. Harmful (may cause lung damage) or fatal if swallowed. Respiratory and digestive tract irritant. Skin and eye irritant. Aspiration
hazard. May cause central nervous system depression. May cause cardiac disturbances. May cause adverse reproductive and fetal effects.
This material contains no known ingredients restricted under SARA Title III in amounts greater than 1%.
OSHA Regulatory Status
Not Available
Potential Health Effects
Route(s) of Entry:
Inhalation, ingestion, skin, eyes
Health Hazards (Acute and Chronic):
Acute: Eyes: Redness, tearing, blurred vision
Skin: Defatting, dermatitus
Inhalation: Irritates respiratory tract, vapor harmful.
Ingestion: Harmful or fatal if swallowed.
Chronic: Persons with severe skin, liver, or kidney problems should not use.
Signs and Symptoms:
Inhalation: Headache, nausea, vomiting, dizziness, unconsciousness, coma
Ingestion: Headache, nausea, vomiting, diarrhea, dizziness, unconsciousness. Symptoms (dyspnea) can develop several hours after exposure.
Skin: Burning pain, itching, redness
Eyes: Redness
Medical Conditions Generally Aggravated by Exposure:
Skin, eye, respiratory, kidney, heart, central nervous system, liver, gastrointestinal system, excretory system diseases
Other Health Warnings:
None specified.
Potential Environmental Effects
Not Available
III. Composition/Information on Ingredients:
Chemical Name CAS No. % Range Trade Secret
d-Limonene 5989275 5-15
Solvent 160 64742489 85-90
Thursday, January 17, 2008
Page 2 of 4
MSDS - Material Safety Data Sheet
Product Name: UN-STIK Tape Release Agent
MSDS No.: UNSTIK100
IV. First Aid Measures:
Emergency and First Aid Procedures:
Inhalation: Remove to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen (To be administered by
qualified medical personnel only!) Keep victim at rest. Get medical attention.
Ingestion: DO NOT induce vomiting. If victim is conscious and alert, rinse mouth and drink plenty of water. (Never give anything by mouth to an
unconscious person!) Get medical attention immediately.
Skin: Flush skin with plenty of soap and water for at least 15 minutes. Remove contaminated clothing. Rub skin with hand lotion. Seek medical
attention.
Eyes: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower lids. Do not allow victim to rub or keep eyes
closed. Get medical aid.
Note to Physicians:
Not Available
V. Fire Fighting Measures:
Suitable Extinguishing Media:
Class B extinguishers for Class III liquid fires.
Unsuitable Extinguishing Media:
Wear self-contained breathing apparatus and protective clothing. Water may be ineffective, but may be used to cool fire-exposed containers.
Remove fire-exposed containers if possible.
Products of Combustion:
Vapors may be heavier than air. They may spread along the ground and collect in low or confined areas. Vapors from this product may travel some
distance from original point to an ignition source and flash back.
Protection of Firefighters:
Wear self-contained breathing apparatus and protective clothing.
VI. Accidental Release Measures:
Personal Precautions:
Wear safety goggles, nitrile rubber gloves, vapor respirator, protective clothing
Environmental Precautions:
Use only with adequate ventilation.
Methods for Containment:
Not Available
Methods for Cleanup:
Not Available
Other Information:
Wear vapor respirator, safety goggles, and nitrile rubber gloves. Remove sources of ignition (i.e. open flames, sparks). Soak up with inert absorbent
material (dry sand or earth recommended; do not use flammable substances such as sawdust). Flush spill site with water after collection. Dispose
according to local, state, and federal regulations.
VII. Handling and Storage:
Handling Precautions:
Keep in tightly closed container. Keep cool and dry. Store at room temperature (~75 F). Store with flammable liquids. Avoid direct sunlight. Avoid
all ignition sources (heat, open flame, spark). Avoid incompatible materials. Use only in well-ventilated areas. Avoid inhalation and ingestion. Avoid
contact with skin, eyes, and clothing. Wash thoroughly after handling.
Storage Precautions:
DO NOT smoke while handling this product. Provide access to water while using this product.
Thursday, January 17, 2008
Page 3 of 4
MSDS - Material Safety Data Sheet
Product Name: UN-STIK Tape Release Agent
MSDS No.: UNSTIK100
VIII. Exposure Controls/Personal Protection:
Chemical Name OSHA PEL ACGIH TLV Other Limits
d-Limonene N/E 50 ppm Not Available
Solvent 160 5mg/m3 5mg/m3 Not Available
Engineering Controls:
Use only in well-ventilated areas.
Personal Protective Equipment:
Safety goggles, nitrile rubber gloves, vapor respirator, protective clothing
IX. Physical and Chemical Properties:
Boiling Point: 185F/235C Melting Point: N/A
Boiling Range: N/A Freezing Point: N/A
Solubility In Water: Negligible Evaporation Rate (Butyl Acetate = 1): 1.5
Flash Point: 147 F (TCC) Flash Point Method: TCC
Odor Threshold: N/A Appearance and Odor: Clear liquid; lemon odor
Vapor Density (AIR = 1): 5.9 Vapor Pressure (mm Hg.): 0.5
pH Range: N/A Not Available
Partition Coefficient:
Decomposition Temp: N/A Auto-Ignition Temp: Not Available
Lower Explosive Limit: 0.9% Upper Explosive Limit: N/A
Specific Gravity (H20 = 1): 0.78
Other Information: Appearance & Odor: Clear liquid, lemon odor
X. Stability and Reactivity:
Stability:
Stable at room temperature in closed containers under normal storage and handling conditions.
Conditions to Avoid:
Not Available
Incompatible Materials:
Ignition sources (heat, open flame, spark), strong oxidizers, light, acetone, alkalies, aluminum, disilane, lithium, magnesium, nitrogen oxides, acids,
phosphorus pentoxide, potassium, hydroxides, alcohols, potassium tert-butoxide, sodium, sodium methylate, sodium-potassium alloy,
triisopropylphosphine, fluorine, acetic anhydride + sodium hydrogensulfate, acetyl bromide, ammonia, silver nitrate, dichloromethane, disulfuryl
difluoride, magnesium perchlorate, silver, oxides, platinum, potassium, tetrachlorosilane, steroids, ketones
Hazardous Decomposition Products:
Carbon oxides, hydrogen chloride, chlorine, phosgene gas
Possibility of Hazardous Reactions:
Has not been reported.
XI. Toxicological Information:
This product contains no EPA Hazardous Air Pollutants (HAP) in amounts >0.1%
XII. Ecological Information:
Thursday, January 17, 2008
Page 4 of 4
MSDS - Material Safety Data Sheet
Product Name: UN-STIK Tape Release Agent
MSDS No.: UNSTIK100
MAMMALIAN INFORMATION:
No Mammalian information is available on this product
AQUATIC ANIMAL INFORMATION:
No aquatic environmental information is available on this product
MOBILITY:
This material is a mobile liquid
DEGRADABILITY:
This product is partially biodegradable
ACCUMULATION:
This product does not accumulate or biomagnify in the environment
XIII. Disposal Considerations:
Dispose according to local, state, and federal regulations.
XIV. Transport Information:
Shipping Name: Not Available
DOT Hazard Class: Not Available DOT Subsidiary Hazard Class: Not Available
UN/NA#: Not Available Not Available
Packing Group:
Transportation Information:
Keep in tightly closed container. Keep cool and dry. Store with flammable liquids. Avoid direct sunlight. Avoid all ignition sources (heat, open
flame, spark). Avoid incompatible materials. Avoid inhalation and ingestion. Avoid contact with skin, eyes, and clothing. Wash thoroughly after
handling.
IATA
Shipping Name: Flammable Liquid, n.o.s. (Petroleum distillates, Terpene Hydrocarbons)
Hazard Class: 3
UN No.: 1993
Packing Group III
XV. Regulatory Information:
All components in this product are on the TSCA list.
SARA Section 311/312 Hazards: Acute Health, Fire.
This material contains no known products restricted by SARA Title III, Section 313, in amounts greater or equal to 1%.
XVI. Other Information:
Liquid Gas Solid
Chemical State: X
Pure Mixture
Chemical Type: 2
X
Hazard Category: 1 0
Acute Chronic Fire
X X X
Pressure Reactive
Additional Manufacturer Warnings:
Using this product under normal, properly instructed procedures should not 1
be hazardous.
2
0
H
Additional Product Information:
The information above is believed to be accurate and represents the best information currently available to us. However, we make
no warranty of merchantability or any other warranty, expressed or implied, with respect to such information, and we assume no
liability resulting from its use. Users should make their own investigation to determine the suitability of the information for their
particular purposes.
|