MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 1
HMIS CODES: H F R P
230G
SECTION I : MANUFACTURER'S IDENTIFICATION
MANUFACTURER'S NAME: ADDRESS:
Keystone Automotive Industries 700 East Bonita Ave.
Pomona, CA 91767
EMERGENCY PHONE : (800) 424 - 9300 DATE PRINTED : 8/2/2005
INFORMATION PHONE : (800) 772 - 5557
FAX NUMBER : (909) 624 - 9136
SECTION II : HAZARDOUS INGREDIENTS/SARA III INFORMATION
VAPOR PRESSURE WEIGHT
REPORTABLE COMPONENTS CAS# mm Hg@TEMP PERCENT
* n-butyl Acetate 123-86-4 7.8 20 C 40 - 45
OSHA PEL 150 ppm(TWA)/200ppm(STEL)
ACGIH TLV 200 ppm(STEL)/150 ppm(TWA)
Aromatic Hydrocarbon 64742-95-6 <1 20 C 1-5
OSHA TWA 50ppm
* 1,2,4-Trimethylbenzene 95-63-6 2.1 25 C 1-5
OSHA TWA 25ppm
* Isophorone Diisocyanate 4098-71-9 < .01 20 C <1
ACGIH TWA .005ppm
* Ethylbenzene 100-41-4 7.1 20 C <1
OSHA TWA 100ppm, STEL 125ppm
* Xylene, mixed isomers 1330-20-7 9.5 20 C <1
OSHA TWA 100ppm, STEL 150ppm
* 1,6-Hexamethylene Diisocyanate 822-06-0 < .01 20 C <1
ACGIH TWA .005ppm
* Indicates toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR
372. WARNING: DETECTABLE AMOUNTS OF A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND/OR BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARM MAY BE PRESENT IN THIS PRODUCT.
SECTION III: PHYSICAL/CHEMICAL CHARACTERISTICS
BOILING RANGE: SPECIFIC GRAVITY (H2O=1):
168.89 C - 320 F 1.0004
VAPOR DENSITY: EVAPORATION RATE:
Heavier than air. Faster than n-butyl acetate.
COATING V.O.C.: MATERIAL V.O.C.:
3.95 lb/gl 3.95 lb/gl
SOLUBILITY IN WATER: APPEARANCE AND ODOR:
Non Soluble. Clear liquid, solvent odor.
REV. 1\04
Document#: MS-????
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 2
SECTION IV : FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: METHOD USED:
44 C TCC
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: UPPER:
0.9 7.6
EXTINGUISHING MEDIA:
Foam, alcohol foam, CO2, dry chemical, water fog.
SPECIAL FIREFIGHTING PROCEDURES:
Never use welding or cutting torch on or near containers (even empty)
because product (even just residue) can ignite explosively. Respiratory
equipment should be worn to avoid inhalation of concentrated vapors. Water
should not be used except as a fog to keep nearby containers cold.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
Handle as flammable liquid. Vapors form explosive mixture in air between
upper and lower explosive limits which can be ignited by many sources such
as pilot lights, open flames, electrical motors and switches. Water should
be used to cool containers exposed to fire. Fire fighting personnel should
wear self-contained breathing apparatus.
SECTION V : REACTIVITY DATA
STABILITY:
Stable.
CONDITIONS TO AVOID:
High temperatures, flame, sparks. Excessive heat, poor ventilation,
corrosive atmospheres, excessive age. Poor ventilation, corrosive
atmospheres. Avoid strong acids or bases in bulk and elevated temperatures.
INCOMPATIBILITY (MATERIALS TO AVOID):
Alkaline materials, strong acids, and oxidizing agents.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS:
Oxides of carbon, toxic fumes, peroxides.
HAZARDOUS POLYMERIZATION:
Will not occur.
REV. 1\04
Document#: MS-????
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 3
SECTION VI : HEALTH HAZARD DATA
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Routes of Entry: inhalation, skin contact, ingestion, eyes. Acute: Nose and
throat irritation, lung injury, allergic respiratory reaction, nausea,
cough, shortness of breath, dehydration, dizziness, weakness, headache,
anesthesia, drowsiness, fatigue, chest pain, vomiting, central nervous
system effects, and asphyxiation.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Eye Contact: contact lenses must be removed, flush water for at least 15
minutes, consult a physician immediately.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Skin Contact: acute: extraction of natural oils with resulting dry skin,
irritation, allergic skin reactions, redness and dermatitis. Can be
absorbed through the skin causing drowsiness.
INGESTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE:
Acute: gastrointestinal irritation, nausea, vomiting, diarrhea, weakness,
dizziness, drowsiness, fatigue, lack of coordination, central nervous
system effects, and depression.
HEALTH HAZARDS (ACUTE AND CHRONIC):
Other Health Effects: intentional misuse by deliberately concentrating and
inhaling the contents may be harmful or fatal. Reports have associated
repeated and prolonged occupational overexposure to solvents with permanent
brain and nervous system damage.
CARCINOGENICITY: NTP CARCINOGEN:
No
IARC MONOGRAPHS:
No
OSHA REGULATED:
No
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Pulmonary conditions, liver conditions, kidney conditions, respiratory
conditions, neurological disorders, cardiovascular diseases, pregnancy,
reproductive system disorders.
REV. 1\04
Document#: MS-????
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 4
EMERGENCY AND FIRST AID PROCEDURES:
Inhalation Overexposure: move person to fresh air. If breathing stops apply
artificial respiration and seek immediate medical attention. Eye Contact:
Flush with large quantities of water for 15 minutes. Skin Contact: Wash
thoroughly with soap and water and see a doctor. Ingestion: Do not induce
vomiting, can cause chemical pneumonitis and pulmonary edema. Contact
physician immediately.
SECTION VII : PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Eliminate ignition sources, provide good ventilation, dike spill area and
add absorbent earth or sawdust to spilled liquid.
WASTE DISPOSAL METHOD:
Collect absorbent/spilled liquid mixture into metal container cover and
seal container. Consult local, state, & federal hazardous waste regulations
before disposing into approved hazardous waste landfill. Obey relevant
laws. Dispose of in accordance with federal, state or provincial and local
pollution requirements. In addition, rags spray booth filters, paint suits,
empty cans, etc., contaminated with product may be hazardous waste.
Determine whether contaminated items are hazardous and dispose of as
appropriate. Clean preferably with a detergent, avoid the use of solvents.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
Handing & Storage: Use approved bonding and grounding procedures when
transferring liquid to another container. Do not transfer to unlabeled
containers. No smoking. Store plastic containers of flammable liquids
inside closed, approved boxes or safety cabinets. Store containers out of
sun and away from heat, sparks, and open flames. Close all containers after
each use.
OTHER PRECAUTIONS:
Smoking in area where this material is used should be strictly prohibited.
Tools used with this material should be made from aluminum, brass or
copper. Plastic utensils should not be used. Note: This information is
accurate to the best of our knowledge but is furnished without any
expressed or implied warranties.
SECTION VIII : CONTROL MEASURES
RESPIRATORY PROTECTION:
When spraying this material use NIOSH approved cartridge respirator to keep
REV. 1\04
Document#: MS-????
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 5
airborne mists and vapor concentrations below the time weighted threshold
limit values. When using in poorly ventilated and confined spaces, use a
fresh-air supplying respirator or self-contained breathing apparatus.
Where overspray is present, a positive pressure air supplied respirator
should be worn. If unavailable, a properly fitted organic vapor/particulate
respirator approved by NIOSH/MSHA for protection against materials in
Section 2 may be effective. Follow respirator manufacturer's directions for
use. Wear the respirator for the whole time of spraying and until all
vapors and mists are gone. NO PERSONS SHOULD BE ALLOWED IN THE AREA WHERE
THESE PRODUCTS ARE BEING USED UNLESS EQUIPPED WITH THE SAME RESPIRATOR
PROTECTION RECOMMENDED FOR THE PAINTERS. When sanding or blasting the dried
film, wear a dust/mist respirator approved by NIOSH/MSHA for dust which may
be generated from this product, underlying paint, or the abrasive.
VENTILATION:
General mechanical ventilation or local exhaust should be suitable to keep
vapor concentrations below TLV. Ventilation equipment must be explosion
proof. Ventilation: Provide sufficient ventilation to keep vapor
concentration below the given TLV and/or PEL. For baking finishes, exhaust
vapors emitted during heating. Remove decomposition products formed during
welding or flame cutting of surfaces coated with this product.
PROTECTIVE GLOVES:
Protective Gloves: Required for prolonged or repeated contact. Use solvent
resistant gloves. Barrier creams are not substitutes for full physical
protection. Refer to safety equipment supplier for effective glove
recommendations.
EYE PROTECTION:
Eye Protection: Use safety goggles or face shield designed to protect
against splash of liquids when spraying or when working with open liquids
such as during mixing or pouring.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
In cases where no monitoring for airborne contaminants has been carried
out, assume maximum exposure and use antistatic paint suit, goggles,
gloves, and air supplied respiratory equipment. All personal protective
should meet NIOSH or OSHA requirements.
WORK/HYGIENIC PRACTICES:
Eye washes and safety showers in the workplace are recommended. Hygienic
Practices: Do not eat, drink or smoke in work areas. Wash hands before
eating, smoking, or using the washroom. Launder clothing before reuse.
REV. 1\04
Document#: MS-????
MATERIAL SAFETY DATA SHEET
PRODUCT NAME: KEY EURO CLEAR MEDIUM ACTIVATOR
PRODUCT CODE: KEY747 Page 6
SECTION IX : DISCLAIMER
Do not handle until the manufacturer's safety precautions have been read
and understood. Regulations require that all employees be trained on
Material Safety Data Sheets for all products with which they come in
contact. While we believe that the data contained herein is accurate and
derived from qualified sources, the data are not to be taken as a warranty
or representation for which we assume legal responsibility. They are
offered solely for your consideration, investigation, and verification.
Any use of these data and information must be determined by the user to be
in accordance with applicable federal, state, provincial and local laws and
regulations.
REV. 1\04
Document#: MS-????
|