MATERIAL SAFETY DATA SHEET
Page: 1
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Identi炉er: Low-Hazard Corrosion Inhibitor A300
Product Code: A300
Product Name: Low-Hazard Corrosion Inhibitor A300
Chemical Family: Inhibitor
MANUFACTURER: 24 HR. EMERGENCY TELEPHONE
HydroChem Industrial Services, Inc. NUMBERS:
900 Georgia Ave. Emergency Contact: HydroChem ER
Deer Park, TX 77536 Emergency Phone (800) 569-4889
Customer Service: (800) 934-9376
2. COMPOSITION/INFORMATION ON INGREDIENTS
wt.% CAS Registry #
Proprietary Aqueous Solution of Organic Surfactants (trade secret) 100
3. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
IMMEDIATE CONCERNS:
No hazard in normal industrial use.
COMMENTS:
Exposure limits for this product have not been established.
4. FIRST AID MEASURES
EYES:
Immediately 掳ush eyes with water for 30 minutes while holding eyelids open. Seek medical at-
tention.
SKIN:
Immediately wash with soap and water for 30 minutes. See a doctor at once. Launder contami-
nated clothing before reuse. Dispose of contaminated shoes.
INGESTION:
If swallowed, induce vomiting with ipecac (preferred), or by giving water and sticking 炉nger down
throat. After vomiting give milk (preferred) or water and consult physician.
Page: 2
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
INHALATION:
Remove to fresh air. See a doctor if e庐ects occur.
5. FIRE FIGHTING MEASURES
Flashpoint and Method: >200卤 F 93卤 C Penskey-Martens, CC
Flammable Limits: Not Determined
Autoignition Temperature: Not Determined
EXTINGUISHING MEDIA:
Use alcohol foam, carbon dioxide, dry chemical or water spray when 炉ghting 炉res involving this
material.
HAZARDOUS COMBUSTION PRODUCTS:
Oxides of carbon and harmful organic chemical fumes.
FIRE FIGHTING PROCEDURES:
Use water fog to cool hot containers.
FIRE FIGHTING EQUIPMENT:
As in any 炉re, wear self-contained breathing apparatus pressure-demand, (MSHA/NIOSH ap-
proved or equivalent) and full protective clothing to prevent contact with skin and eyes.
6. ACCIDENTAL RELEASE MEASURES
GENERAL PROCEDURES:
Contain with dikes.
Put in plastic drum.
Soak up residual on inert absorbant (dry sand, vermiculite, earth).
Wash spill site after material pickup is complete.
7. HANDLING AND STORAGE
GENERAL PROCEDURES:
Refer to Section 8.
STORAGE:
No special precautions required.
Store away from oxidizers.
Page: 3
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
ENGINEERING CONTROLS:
Ventilation - General and local ventilation are required.
PERSONAL PROTECTION
EYES AND FACE:
Chemical goggles required and an eye wash in work area.
RESPIRATORY:
None normally needed. Use NIOSH approved respirator with organic vapor/acid gas protection
(color coded yellow) if vapors are generated and for emergencies.
PROTECTIVE CLOTHING:
Clean body covering and chemical resistant gloves.
OTHER USE PRECAUTIONS:
Safety shower and eye wash in the work area.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Odor: Strong Sulfur
Color: Amber
pH: 2.5
Percent Volatile: Not Determined
Vapor Pressure: Not Determined
Vapor Density: Not Determined
Boiling Point: Not Determined
Freezing Point: 12卤 F -6卤 C
Solubility in Water: Completely Miscible in All Proportions
Speci炉c Gravity: 1.010 (water=1)
10. STABILITY AND REACTIVITY
STABLE: Yes
HAZARDOUS POLYMERIZATION: No
HAZARDOUS DECOMPOSITION:
Not Determined
INCOMPATIBLE MATERIALS:
Oxidizing materials.
Page: 4
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
11. TOXICOLOGICAL INFORMATION
ACUTE
Eyes: Severe irritant. Causes pain and redness. Prolonged or repeated contact may cause mild
burn.
Skin: Irritant. May cause pain, redness, dermatitis. May be absorbed in toxic amounts.
Ingestion: Harmful if swallowed. Large amounts may cause illness or death.
LD(50) (rats, oral-acute) = 1.144 g/kg
Inhalation: Not Determined
TARGET ORGANS:
Not Determined
GENERAL COMMENTS:
Carcinogenicity not determined
12. ECOLOGICAL INFORMATION
GENERAL COMMENTS:
Degradability:
5-day BOD - 0.037 p/p
Total COD - 1.45 p/p
TOC - 5,000 mg/L
Fish Toxicity:
LC(50) C. dubia (serial renewal - 24 hr) - 7.1 mg/L
LC(50) P. promelas (serial renewal - 24 hr) - 22.1 mg/L
13. DISPOSAL CONSIDERATIONS
PRODUCT DISPOSAL:
Dispose of in accordance with ALL applicable federal, state and local regulations.
EMPTY CONTAINER:
Leave label on drum and sell drum to an approved drum reconditioner or triple rinse with an
appropriate solvent, crush, and ship to sanitary land炉ll unless prohibited by local regulations.
RCRA/USEPA WASTE INFORMATION:
This material is not a RCRA regulated material.
COMMENTS:
Always follow ALL applicable federal, state and local regulations.
Page: 5
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
14. TRANSPORT INFORMATION
DOT (DEPARTMENT OF TRANSPORTATION)
Proper Shipping Name: Corrosion Inhibitor A300 { NOT REGULATED
Placards: None
Label: None
15. REGULATORY INFORMATION
UNITED STATES
SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT)
Fire: No Pressure Generating: No Reactivity: No Acute: Yes Chronic: No
Title III Notes: This product contains no substances which are de炉ned as toxic chemicals under
the reporting requirements of Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 (40 CFR Part 372).
CERCLA (COMPREHENSIVE RESPONSE, COMPENSATION, AND LIABILITY ACT)
Reportable Spill Quantity: Not established
TSCA (TOXIC SUBSTANCE CONTROL ACT)
TSCA Status: All components of this material are either on the TSCA inventory or are exempt
fro the reporting requirements.
16. OTHER INFORMATION
Approval date: 2/7/2005
REVISION SUMMARY
Revision #: 11
This MSDS replaces the October 07, 1999 MSDS. Any changes in information are as follows:
In Section 15
Fire Pressure Generating Reactivity Accute Chronic SARA Title III Notes
NFPA CODES
Fire: 1 Health: 2 Reactivity: 0
HMIS CODES
Fire: 1 Health: 2 Reactivity: 0
Page: 6
DATE PREPARED: 2/7/2005
MSDS No: A300
Low-Hazard Corrosion Inhibitor A300
MANUFACTURER DISCLAIMER:
[TM ] Indicates a trade or service mark of HydroChem Industrial Services, Inc.
The information herein is believed to be accurate and is presented in good faith; however, no
warranties or representations are made by HydroChem Industrial Services, Inc. regarding the
accuracy or completeness of the information.
HydroChem Industrial Services, Inc. shall not be held liable for any damage resulting from the
handling, or from contact with the above product.
|