06182002 MATERIAL SAFETY DATA SHEET : 00000548 PAGE:1
HENKEL CONSUMER ADHESIVES
50 WEST DRIVE
BRAMPTON, ONTARIO CANADA L6T 2J4
(905) 459-1140
PRODUCT : LEPAGE LT 710 THERMOPLASTIC (GREY,YELLOW,GREEN)
SECTION 01: PRODUCT INFORMATION
MANUFACTURER.....................HENKEL CONSUMER ADHESIVES
50 WEST DRIVE
BRAMPTON, ONTARIO
CANADA ; L6T 2J4
(905) 459-1140
AFTER HOURS - CANUTEC (613) 996-6666
WHMIS CLASSIFICATION.............B4. D2A. D2B. WHEN THIS PRODUCT IS LABELLED AS A CONSUMER PRODUCT IT IS
EXEMPT FROM WHMIS REGULATIONS (SEE SECTION 12(f) OF THE HAZARDOUS PRODUCT
ACT)
T.D.G. CLASSIFICATION............SOLIDS CONTAINING FLAMMABLE LIQUID, N.O.S. (XYLENE). CLASS 4.1, UN 3175,
PKG GP II. WHEN THIS PRODUCT IS LABELLED AS A CONSUMER COMMODITY IT IS
EXEMPT FROM T.D.G. REGULATIONS (SEE SECTION 2.7(1) OF TRANSPORTATION OF
DANGEROUS GOODS REGULATIONS).
PRODUCT NAME.....................LEPAGE LT 710 THERMOPLASTIC (GREY,YELLOW,GREEN)
CHEMICAL FAMILY..................THERMOPLASTIC
MATERIAL USE.....................SEALANT
SECTION 02: HAZARDOUS INGREDIENTS
HAZARDOUS INGREDIENTS % EXPOSURE LEVELS C.A.S. # LD/50, ROUTE, SPECIES LC/50, ROUTE, SPECIES
1,2-Ethanediol 0.1-1 PEL-C:50ppm vapour 107-21-1 5.9g/kg,oral,rat Not available
7.5g/kg,oral,mouse
9.5g/kg,skin,rabbit
Xylene 15-40 100 ppm 1330-20-7 4300mg/kg rat,oral 5000ppm/4hr rat,
inhal.
SECTION 03: PHYSICAL DATA
PHYSICAL STATE...................Paste
APPEARANCE & ODOUR...............High viscosity smooth mastic with moderate solvent odor.
ODOUR THRESHOLD (ppm)............No data available
VAPOUR PRESSURE (mm Hg)..........5.1 mm / 20 deg C
VAPOUR DENSITY (AIR=1)...........Heavier than air
VOLATILES %
BY VOLUME..................30-35 %
BY WEIGHT
EVAPORATION RATE.................Slower than n-butyl acetate
BOILING POINT....................Not available
FREEZING POINT...................Not available
pH...............................Not applicable
SPECIFIC GRAVITY.................1.02
SOLUBILITY IN WATER (% W/W)......Insoluble in water
COEFFICIENT OF WATER/OIL.........Not applicable
DISTRIBUTION
SECTION 04: FIRE & EXPLOSION DATA
FLAMMABILITY.....................FLAMMABLE SOLID
IF YES, UNDER WHICH..............Excessive heat, sparks and open flame
CONDITIONS?
EXTINGUISHING MEDIA..............Foam. Carbon dioxide. Dry chemical
SPECIAL PROCEDURES...............Fire fighters should be equipped with self-contained breathing apparatus
to protect against potentially toxic and irritating fumes. Water stream
directed into fire may cause frothing with subsequent spread of fire.
FLASH POINT (C), METHOD..........19 deg C, PMCC
AUTO IGNITION TEMPERATURE........Not available
UPPER FLAMMABLE LIMIT (% VOL)....7.0 % (in air)
LOWER FLAMMABLE LIMIT (% VOL)....1.0 % (in air)
HAZARDOUS COMBUSTION PRODUCTS....Irritating and/or toxic gases or fumes may be generated by thermal
decomposition or combustion. Closed containers may rupture or explode (due
to pressure build-up) when exposed to extreme heat. Empty containers may
contain explosive vapors or dangerous residues.
EXPLOSION DATA
SENSITIVITY TO STATIC............Not applicable
DISCHARGE
SENSITIVITY TO IMPACT......Not applicable
RATE OF BURNING............Not applicable
EXPLOSIVE POWER............Not applicable
06182002 MATERIAL SAFETY DATA SHEET : 00000548 PAGE:2
PRODUCT : LEPAGE LT 710 THERMOPLASTIC (GREY,YELLOW,GREEN)
SECTION 05: REACTIVITY DATA
CHEMICAL STABILITY:
YES........................Stable under normal temperature and pressure.
NO, WHICH CONDITIONS ?
COMPATIBILITY WITH OTHER
SUBSTANCES:
YES
NO, WHICH ONES?............Strong bases or oxidants. Strong Lewis or mineral acids
REACTIVITY CONDITIONS ?..........Sources of ignition.
HAZARDOUS PRODUCTS OF............Acrid fumes. Oxides of carbon (CO,CO2)
DECOMPOSITION
SECTION 06: TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY:
SKIN CONTACT...............May cause mild irritation. Can cause drying and defatting of skin leading
to irritation and dermatitis. Especially on prolonged contact.
SKIN ABSORPTION............Repeated or prolonged overexposure may cause sensitization.
EYE CONTACT................Moderate irritant. May cause reversible corneal injury.
INHALATION, ACUTE :..............May cause irritation of respiratory tract. Intoxicant. Overexposure shown
by headache, dizziness and confusion to coma. Material aspirated into
lungs may cause chemical pneumonitis.
INGESTION..................May cause irritation of the gastrointestinal tract following ingestion of
large amounts. Symptoms include nausea, abdominal pain and possible
collapse.
EFFECTS OF ACUTE EXPOSURE........Possible skin, eye, and respiratory tract irritation.
EFFECTS OF CHRONIC EXPOSURE......This product contains xylenes. High exposure to xylenes in some animal
studies have been reported to cause health effects on the developing
embryo/fetus. The significance of these findings to humans has not been
determined. Deliberate and repeated inhalation of concentrated solvent
vapors may cause permanent neurological damage. Preexisting pulmonary and
dermatological disorders may be aggravated by exposure to hazardous
components.
LD 50 OF MATERIAL, SPECIES &.....Refer to hazardous ingredients section.
ROUTE
LC 50 OF MATERIAL, SPECIES &.....Refer to hazardous ingredients section.
ROUTE
EXPOSURE LIMIT OF MATERIAL.......Not established
IRRITANCY OF MATERIAL............Moderate
SENSITIZING CAPABILITY OF........Repeated contact may cause allergic skin and/or respiratory reactions
MATERIAL resulting in sensitization of the individual. Respiratory sensitivity
results in asthma-like symptoms on subsequent exposure. See effects of
acute exposure.
CARCINOGENICITY OF MATERIAL......None known
MUTAGENICITY OF MATERIAL.........None known
TERATOGENICITY OF MATERIAL.......Xylenes have produced fetotoxic effects in animals, in the absence of
maternal toxicity. The significance of these effects to humans has not
been determined.
REPRODUCTIVE EFFECTS.............1,2-Ethanediol:. Adverse effects on general reproductive performance in
animals. Xylenes represent an embryotoxic hazard in animals. Effects of
exposure to xylenes on humans have not been confirmed.
SYNERGISTIC MATERIALS............None known
SECTION 07: PREVENTATIVE MEASURES
PROTECTIVE EQUIPMENT
GLOVES/ TYPE...............Wear impervious gloves (in neoprene or rubber).
RESPIRATORY/TYPE...........If the TLV is exceeded, or if used in a poorly ventilated space or area
with limited ventilation, use an approved respirator in accordance with
applicable safety regulations.
EYE/TYPE...................Wear chemical safety goggles.
FOOTWEAR/TYPE..............Work shoes
CLOTHING/TYPE..............Wear adequate protective clothes.
OTHER/TYPE.................Eye bath and safety shower.
ENGINEERING CONTROLS.............Local exhaust as needed to control vapor/dust levels to below recommended
limits.
LEAK/SPILL.......................Ventilate. Eliminate all sources of ignition. Wear appropriate protective
equipment during cleanup. Shut off source of leak if safe to do so.
Contain the spill. Absorb with inert material. Sweep or shovel into
containers with lids. Cover loosely and remove to appropriate well
ventilated area until disposal. Wash spill area with soap and water.
Prevent washings from entering waterways.
WASTE DISPOSAL...................In accordance with municipal, provincial and federal regulations. Since
emptied container retains product residues all labelled hazard precautions
must be observed.
HANDLING PROCEDURES AND..........Do not take internally. Avoid contact with eyes, skin, and clothing. Avoid
EQUIPMENT breathing vapor/dust/mist. Tightly reseal all partially used containers.
Wash thoroughly after handling. Avoid smoking, drinking or eating in use.
Use adequate ventilation.
STORAGE NEEDS....................Store away from all sources of heat and ignition. Store empty containers
away from heat and flame. KEEP AWAY FROM CHILDREN.
SPECIAL SHIPPING INSTRUCTIONS....Ship in accordance with applicable Transportation of Dangerous Goods (TDG)
Regulations.
06182002 MATERIAL SAFETY DATA SHEET : 00000548 PAGE:3
PRODUCT : LEPAGE LT 710 THERMOPLASTIC (GREY,YELLOW,GREEN)
SECTION 08: FIRST AID MEASURES
SKIN CONTACT.....................Remove contaminated clothing. Wash affected area with water and soap. Seek
medical attention if irritation occurs or persists.
EYE CONTACT......................Flush with plenty of water at least 15 minutes. Obtain immediate medical
attention.
INHALATION.......................Remove to fresh air. If breathing is difficult, give oxygen. Administer
artificial respiration if not breathing. Obtain medical attention.
INGESTION........................Do not induce vomiting. Should vomiting occur, be sure to keep victim's
head below hips to avoid aspiration of vomitus into the lungs. Obtain
immediate medical attention.
SECTION 09: PREPARATION INFORMATION
PREPARED BY:.....................Regulatory Affairs
TELEPHONE NUMBER:................(905) 459-1140
DISCLAIMER2:.....................All information, recommendations, and suggestions appearing herein
concerning our product are based upon tests and data believed to be
reliable. However, it is the user's responsibility to determine the
safety, toxicity, and suitability for his own use of the product described
herein. Since the actual use by others is beyond our control, no
guarantee, express or implied, is made by Henkel Consumer Adhesives as to
the effects of such use, the results obtained, or the safety and toxicity
of the product nor does Henkel Consumer Adhesives assume any liability
arising out of use, by others, of the product referred to herein. The
information herein is not to be construed as absolutely complete since
additional information may be necessary or desirable when particular or
exceptional conditions or circumstan ces exist or because of applicable
laws or government regulations.
PREPARATION DATE.................JUN 17/2002
CANUTEC EMERGENCY (613) 996-6666
|