06202002 MATERIAL SAFETY DATA SHEET : 00000700 PAGE:1
HENKEL CONSUMER ADHESIVES
50 WEST DRIVE
BRAMPTON, ONTARIO CANADA L6T 2J4
(905) 459-1140
PRODUCT : LEPAGE POWER GRAB
SECTION 01: PRODUCT INFORMATION
MANUFACTURER.....................HENKEL CONSUMER ADHESIVES
50 WEST DRIVE
BRAMPTON, ONTARIO
CANADA ; L6T 2J4
(905) 459-1140
AFTER HOURS - CANUTEC (613) 996-6666
WHMIS CLASSIFICATION.............D2A. WHEN THIS PRODUCT IS LABELLED AS A CONSUMER PRODUCT IT IS EXEMPT FROM
WHMIS REGULATIONS. (SEE SECTION 12(f) OF THE HAZARDOUS PRODUCTS ACT).
T.D.G. CLASSIFICATION............AEROSOLS, NON-FLAMMABLE, CLASS 2.2, UN 1950. WHEN THIS PRODUCT IS LABELLED
AS A CONSUMER COMMODITY IT IS EXEMPT FROM T.D.G. REGULATIONS (SEE SECTION
2.7(1) OF TRANSPORTATION OF DANGEROUS GOODS REGULATIONS).
PRODUCT NAME.....................LEPAGE POWER GRAB
CHEMICAL FAMILY..................ADHESIVE. ACRYLIC COPOLYMER
MATERIAL USE.....................ADHESIVE
SECTION 02: HAZARDOUS INGREDIENTS
HAZARDOUS INGREDIENTS % EXPOSURE LEVELS C.A.S. # LD/50, ROUTE, SPECIES LC/50, ROUTE, SPECIES
Crystalline silica 0.1-1 0.1 mg/m3 (dust) 14808-60-7 Not available Not available
SECTION 03: PHYSICAL DATA
PHYSICAL STATE...................Paste
APPEARANCE & ODOUR...............White. Smooth paste. Slight odour
ODOUR THRESHOLD (ppm)............Not available
VAPOUR PRESSURE (mm Hg)..........Not available
VAPOUR DENSITY (AIR=1)...........Not available
BY VOLUME
BY WEIGHT
EVAPORATION RATE.................Not available
BOILING POINT (deg C)............Not available
pH...............................8.0-9.0
SPECIFIC GRAVITY.................1.23-1.35
SOLUBILITY IN WATER (% W/W)......Not available
COEFFICIENT OF WATER/OIL.........Not available
DISTRIBUTION
SECTION 04: FIRE & EXPLOSION DATA
FLAMMABILITY
IF YES, UNDER WHICH..............Not applicable
CONDITIONS?
AUTO IGNITION TEMPERATURE........Not available
EXTINGUISHING MEDIA..............Foam. Dry chemical. CO2. Water fog
SPECIAL PROCEDURES...............Firefighters should wear self-contained breathing apparatus. Heating will
cause internal pressure to rise, and could burst the aerosol pack.
Bursting aerosol packs can be forcibly projected from a fire. Use
water-spray to keep containers cool
FLASH POINT (C), METHOD..........> 95 deg C, N/A
LOWER FLAMMABLE LIMIT (% VOL)....Not applicable
UPPER FLAMMABLE LIMIT (% VOL)....Not applicable
HAZARDOUS COMBUSTION PRODUCTS....Combustion will result in the usual decomposition products, including
oxides of carbon. Smoke
SECTION 05: REACTIVITY DATA
CHEMICAL STABILITY:
YES........................Under normal conditions
NO, WHICH CONDITIONS ?
COMPATIBILITY WITH OTHER
SUBSTANCES:
YES
NO, WHICH ONES?............Strong oxidizing agents. Strong bases. Strong acids
REACTIVITY CONDITIONS ?..........None
HAZARDOUS PRODUCTS OF............Oxides of carbon (CO,CO2) at high temperatures.
DECOMPOSITION
06202002 MATERIAL SAFETY DATA SHEET : 00000700 PAGE:2
PRODUCT : LEPAGE POWER GRAB
SECTION 06: TOXICOLOGICAL PROPERTIES
SKIN CONTACT...............May cause irritation, especially on prolonged contact.
SKIN ABSORPTION............No data
EYE CONTACT................Slightly irritating but does not cause eye tissue damage.
INHALATION.................Not considered a hazard under normal conditions of use.
INGESTION..................May cause irritation of the gastrointestinal tract, nausea, vomiting, and
diarrhea.
EFFECTS OF ACUTE EXPOSURE........Possible skin and eye irritation.
EFFECTS OF CHRONIC EXPOSURE......This product contains crystalline silica. Prolonged exposure to respirable
crystalline quartz may cause delayed (chronic) lung injury (silicosis).
LD 50 OF MATERIAL, SPECIES &.....Not available
ROUTE
LC 50 OF MATERIAL, SPECIES &.....Not available
ROUTE
EXPOSURE LIMIT OF MATERIAL.......Not available
IRRITANCY OF MATERIAL............Not available
SENSITIZING CAPABILITY OF........None known
MATERIAL
CARCINOGENICITY OF MATERIAL......Crystalline silica is an IARC-listed known lung carcinogen. The
crystalline silica contained in this product will not typically become
airborne during normal conditions of use.
SYNERGISTIC MATERIALS............Not available
SECTION 07: PREVENTATIVE MEASURES
GLOVES/ TYPE...............Rubber or plastic gloves.
RESPIRATORY/TYPE...........Use approved respirator for dusts and mists when sanding, grinding or
machining cured compound.
EYE/TYPE...................Recommended but not required.
FOOTWEAR/TYPE..............Standard work shoes.
CLOTHING/TYPE..............Standard work clothes.
VENTILATION REQUIREMENTS.........Use adequate local exhaust ventilation.
LEAK/SPILL.......................Wipe up or absorb with sand or other absorbent material. Put in
appropriate labelled container for disposal. Flush area with plenty of
water. Collect waste in sealed containers. Dispose of contaminated water
in accordance with applicable Federal, Provincial and local regulations.
Prevent runoff into drains, sewers, and other waterways.
WASTE DISPOSAL...................In accordance with municipal, provincial and federal regulations.
HANDLING PROCEDURES AND..........Avoid contact with eyes, skin, and clothing. Do not pierce or burn
EQUIPMENT container, even if apparently empty
STORAGE NEEDS....................Store in a frost free place. Store under 30 deg C. Store in a cool, dry
place away from direct heat.
SPECIAL SHIPPING INSTRUCTIONS....Ship in accordance with applicable Transportation of Dangerous Goods (TDG)
regulations.
SECTION 08: FIRST AID MEASURES
EYE CONTACT......................Immediately flush eyes with large amounts of water until irritation
subsides. If irritation persists, get medical attention.
INGESTION........................Have victim rinse mouth thoroughly with water. Have victim drink 240-300
ml of water. Never give anything by mouth if the victim is rapidly losing
consciousness, or is unconscious or convulsing. If vomiting occurs
naturally, keep airway clear. Rinse mouth and repeat administration of
water. Consult a physician immediately
INHALATION.......................If overexposure occurs, remove to fresh air.
SKIN CONTACT.....................Remove contaminated clothing. Wash affected area with water and soap. Seek
medical attention if irritation occurs or persists.
SECTION 09: PREPARATION INFORMATION
PREPARED BY:.....................Regulatory Affairs
TELEPHONE NUMBER:................(905) 459-1140
DISCLAIMER2:.....................All information, recommendations, and suggestions appearing herein
concerning our product are based upon tests and data believed to be
reliable. However, it is the user's responsibility to determine the
safety, toxicity, and suitability for his own use of the product described
herein. Since the actual use by others is beyond our control, no
guarantee, express or implied, is made by Henkel Consumer Adhesives as to
the effects of such use, the results obtained, or the safety and toxicity
of the product nor does Henkel Consumer Adhesives assume any liability
arising out of use, by others, of the product referred to herein. The
information herein is not to be construed as absolutely complete since
additional information may be necessary or desirable when particular or
exceptional conditions or circumstan ces exist or because of applicable
laws or government regulations.
PREPARATION DATE.................JUN 20/2002
CANUTEC EMERGENCY (613) 996-6666
|