MSDS-313A
October 2006
MATERIAL SAFETY DATA SHEET
CIPADOME CONDUCTIVE PART B
SECTION 1 - PRODUCT INFORMATION
Manufacturer: CPD Construction Products
219 Connie Crescent # 13
Concord, Ontario L4K 1L4
Product Identifier: CIPADOME Conductive Part B
Application and Use: Roller applied epoxy floor coating and topping binder.
Product Description: Two component epoxy binder that is black and has electrical conductive properties.
Regulatory Classification:
WHMIS Information: Class D-2B, Class E, corrosive
Transportation of Dangerous Goods Information:
Amines, liquid, corrosive, N.O.S. (Amino Terminated Polyether): Class 8 UN 2735 PG III
EMERGENCY TELEPHONE NUMBERS
CANUTEC: (613) 996-6666
SECTION 2 - HAZARDOUS INGREDIENTS
Ingredients CAS# %(weight) LD/50 Route/Species
Aliphatic Amine/Epoxy Adduct n/a 30-60 LD50 - Not available
Nonyl Phenol 25154-52-3 1-5 LD50-1620mg/kg(Rat-Oral) 2140mg/kg(Rabbit-Skin)
Amino Terminated Polyether 9046-10-0 30-60 LD50-1660mg/kg(Rat-Oral) 760mg/kg (Rabbit Skin)
2,4,6 Trimethyl Aminomethyl Phenol 90-72-2 1-5 LD50-1200mg/kg (Rat-Oral) LC50-not available
SECTION 3 - PHYSICAL DATA
Physical State: Liquid Specific Gravity: 0.98 @ 23掳C (737掳F)
Vapour Pressure: 0.70mm Hg @ 21掳C (70掳F) Solubility in Water: Slight (0.1-1%)
Boiling Point: n/a Freezing/Melting Point: n/a
Viscosity: 42 cps @ 23掳C (73掳F) Vapour Density: n/a
Evaporation Rate: n/a % Volatile: (voc): 0.0gm/l
Odour: Characteristic amine Appearance: Clear amber liquid
SECTION 4 - TOXICOLOGICAL PROPERTIES
NATURE OF HAZARD
INHALATION, ACUTE: Irritating to respiratory tract. Coughing and chest pain may result Inhalation of aerosol, mist or
fog may cause harm.
INHALATION, CHRONIC: Refer to acute inhalation.
EYE CONTACT: Contact with undiluted product with the eyes quickly causes irritation and pain and may cause burns,
necrosis and permanent injury. Burns of the eye may cause blindness. Product vapour in low concentration can cause
lacrimation, conjunctivities and corneal edema when absorbed into the tissue of the eye from the atmosphere. Corneal
edema may give rise to a perception of 鈥淏lue Haze鈥? or 鈥淔og鈥? around lights. The effect is transient and has no known
residual effect.
/...2
MSDS-313A
October 2006
SKIN CONTACT: Contact of undiluted product with skin quickly causes irritation and pain and may cause burns,
necrosis and permanent injury.
INGESTION, ACUTE: May cause bleeding of the gastrointestinal tract and vomiting of blood.
INGESTION, CHRONIC: Refer to acute ingestion.
Toxicological Date: No data.
SECTION 5 - FIRST AID MEASURES
INHALATION: If inhaled, remove victim to fresh air. If breathing is difficult, administer oxygen. If breathing has
stopped, give artificial respiration. Keep person warm, quiet, and get medical attention.
EYE CONTACT: Flush with water for at least 15 minutes while forcibly holding eyelids apart to ensure complete
irrigation of all eye and lid tissue. Get medical attention.
SKIN CONTACT: Wash with soap and water. Launder contaminated clothing before reuse. Contact a physician if
irritation develops.
INGESTION: Get medical attention immediately. Do not induce vomiting. Remove stomach contents by gastric suction
only as directed by medical personnel. Never give anything by mouth to an unconscious person.
SECTION 6 - PREVENTIVE MEASURES
PERSONAL PROTECTION: Avoid smoking, drinking or eating in use. Avoid contact with eyes, skin and clothing.
Discard contaminated leather.
ENGINEERING CONTROLS: General ventilation; local exhaust ventilation as necessary to control any air
contaminants, to within their TLV鈥檚, in the use of this product.
HANDLING, STORAGE AND SHIPPING: Do not use sodium nitrite or other nitrosating agents in formulations
containing this product. Cancer causing nitrosamines could be formed. Store away from heat and ignition sources. Store in
a cool, dry and well ventilated area. Keep away from acids, alkalis and oxidizing agents. Keep containers closed when not
in use. Store in steel containers, preferably outdoors, above ground and surrounded by dikes to contain spills or leaks. Do
not store in iron or other reactive metal containers.
SPILL CONTROL AND DISPOSAL: Consult an expert on the disposal of recovered material. Ensure disposal is in
compliance with government requirements and ensure conformity to local disposal regulations. Notify the appropriate
authorities immediately. Take all additional action necessary to prevent and remedy the adverse effects of the spill.
LAND SPILL: Eliminate source of ignition. Keep public away. Prevent additional discharge of material, if possible to
do so without hazard. Prevent spills from entering sewers, watercourses or low areas. Contain spilled liquid with sand or
earth. Do not use combustible materials such as sawdust. Recover by using a suitable absorbent.
WATER SPILL: Remove from surface by skimming or with suitable absorbents. If allowed by local authorities and
environmental agencies, sinking and/or suitable dispersants may be used in unconfined water.
SECTION 7 - FIRE AND EXPLOSION DATA
Flashpoint and Method: >100掳C (T.C.C.)
Auto ignition Temperature: Not available
Flammable Limits: Not Available
/...3
MSDS-313A
October 2006
FIRE FIGHTING: Personnel in vicinity and downwind should be evacuated. Fire fighters should wear approved self
contained breathing apparatus and full protective clothing.
HAZARDOUS COMBUSTION PRODUCTS: May generate toxic or irritating combustion products. Ammonia, oxides
of carbon (CO, CO2) and oxides of nitrogen.
SECTION 8 - REACTIVITY DATA
GENERAL: This product is stable and hazardous polymerization will not occur under normal conditions.
INCOMPATIBLE MATERIALS: Contact with mineral acids ( such as sulphuric, phosphoric etc.), alkalis, organic
acids (i.e.; acetic acid, citric acid etc.), reducing agents, reactive metals (i.e.; sodium, calcium, zinc etc.), sodium or
calcium hypochlorite, materials reactive with hydroxyl compounds, amines, nitrites, nitrosating agents such as
perchlorates or nitrates.
HAZARDOUS DECOMPOSITION: Irritating and toxic fumes at elevated temperatures. Ammonia when heated.
SECTION 9 - PREPARATION
Prepared By: R.J. Green
Plant Manager
CPD Construction Products
Concord, Ontario L4K 1L4
|