MSDS-281B

                                                    September 2006



                                        MATERIAL SAFETY DATA SHEET

                                       CIPADOME P PART C (AGGREGATE)



SECTION 1 - PRODUCT INFORMATION

Manufacturer: CPD Construction Products

              219 Connie Crescent # 13

              Concord, Ontario L4K 1L4



Product Identifier: CIPADOME P Part C (Aggregate)



Application & Use: Power trowel applied epoxy floor surfacing for industrial floors.



Product Description: Three component power trowel epoxy floor surfacing.



Regulatory Classification:

WHMIS Class D - Division 2, Subdivision A (Quartz)



Transportation of Dangerous Goods: Not regulated



EMERGENCY TELEPHONE NUMBERS

CANUTEC: (613) 996-6666



SECTION 2 - HAZARDOUS INGREDIENTS

The following component data is defined in accordance with sub-paragraph 13(a)(i) to (iv) or paragraph 14(a) of the

Hazardous Products Act.

NAME               (pbw)% CAS

Silica (Quartz) **  100   14808-60-7 LD50 - Not available LC50 - Not available



** The sand used in this product contains Quartz. The Quartz that exists as particles with an Aerodynamic Diameter less

than 5 microns is hazardous. An approved dust mask (for Crystalline Silica) should be worn by workers when handling

this product in the dry state.



SECTION 3 - PHYSICAL DATA

Physical State: Solid                                            Specific Gravity: 2.20

Vapour Pressure: n/a                                             Solubility in Water: Insoluble in water

Boiling Point: n/a                                               Viscosity: n/a

Vapour Density (AIR=1): n/a                                      Evaporation Rate: n/a

% Volatile: n/a                                                  Odour: None

Appearance: neutral color aggregate



SECTION 4 - TOXICOLOGICAL PROPERTIES

NATURE OF HAZARD

INHALATION: Crystalline Silica (Quartz) dust particles below 5 micron in diameter may be present in this product.

Excessive long term inhalation of particles of this size (or smaller) may cause the lung disease (Silicosis). The prolonged

inhalation of dust may result in shortness of breath. May be irritating to mucous membranes and respiratory tract.



EYE CONTACT: No effect except as mechanical irritant.



SKIN CONTACT: No effect.



INGESTION: No known effect.



                                                                                                                       /...2

                                                      MSDS-281B

                                                    September 2006



CHRONIC: Excessive exposure to crystalline silica dust particles (below 5 micron in diameter) could lead to the

development of the irreversible lung disease "Silicosis". IARC Classification - Crystalline silica is classified by IARC as

"2A probably Carcinogenic to humans".



OCCUPATIONAL EXPOSURE LIMIT: Maximum TWA of silica is 0.1mg per M3 of air. For further information on

the designated substance "Silica" contact the Ministry of Labour (Occupational Safety and Health Division) in your

region.



SECTION 5 - FIRST AID MEASURES

INHALATION: Remove victim to fresh air. Consult a physician of adverse effects occur.



EYE CONTACT: Flush eye(s) with lukewarm water for 15 minutes holding eyelids open. If irritation persists see

physician.



SKIN CONTACT: Flush with water.



INGESTION: None.



SECTION 6 - PREVENTIVE MEASURES

An approved dust mask for crystalline silica dust must be worn when mixing the unit. Also instruct workmen to wear

safety glasses with eye shields, full length PVC or neoprene gloves and full work coveralls. Good personal hygiene

practices are a mandatory requirement to prevent accidental ingestion of silica through eating, smoking, etc. No

engineering controls are necessary when product is used in small quantities.



HANDLING, STORAGE AND SHIPPING: Product should be stored under normal warehouse conditions. No water

should be allowed to contaminate aggregate.



SPILL CONTROL AND DISPOSAL: Sweep up with dust retarding floor sweeping compound. Dispose of as normal

waste. No special precautions required.



SECTION 7 - FIRE AND EXPLOSION DATA

None. Non-combustible material.



SECTION 8 - REACTIVITY DATA

Stable. Hazardous Decomposition will not occur.



SECTION 9 - PREPARATION

Prepared By: R.J. Green

             Plant Manager

             CPD Construction Products

             Concord, Ontario L4K 1L4