MSDS-18

                                               September 2006



                            MATERIAL SAFETY DATA SHEET

               CPD NON-SHRINK GROUT PRE-MIX (H.E.S.HIGH EARLY STRENGTH)



SECTION 1 - PRODUCT INFORMATION

Manufacturer: CPD Construction Products

              219 Connie Crescent # 13

              Concord, Ontario L4K 1L4



Product Identifier: CPD Non-Shrink Grout Pre-Mix (H.E.S. High Early Strength)



Application and Use: Grouting Base Plates, Structural Columns,

Anchor Bolts, and Dowels.



Product Description: Hydraulic Cement Grout



Regulatory Classification:

WHMIS - Class E (Portland Cement)

Class D Division 2 Subdivision A (Silica Quartz)



Transportation of Dangerous Goods Information: - Not regulated.



EMERGENCY TELEPHONE NUMBERS

CANUTEC: (613) 996-6666



SECTION 2 - HAZARDOUS INGREDIENTS

The following component data is defined in accordance with sub-paragraph 13(a)(i) to (iv) or paragraph 14 (a) of

the Hazardous Products Act.



NAME                                    (pbw)%            CAS

Sand **(Quartz)                          50 " 1%       14808-60-7

Portland Cement (Hydraulic Cement)       50 " 1%       65997-15-1



NOTE: LD50 (not available for the above)           LC50 (not available for the above)



** The sand used in this product contains quartz. Although the minimum grain size is 150 Microns certain

precautions should still be taken during handling to avoid inhalation of dust.



SECTION 3 - PHYSICAL DATA

Physical State: Powder/Granular Solid           Viscosity: n/a

Specific Gravity: 2.20                          Vapour Density (Air=1): n/a

Vapour Pressure: n/a                            Evaporation Rate: n/a

Solubility in Water: < 1.0%                     % Volatile: n/a

Ph: 12.5 @ 20°C (Aqueous Solution)              Odour: None

Boiling Point: n/a                              Appearance: Medium to Light Grey Powder Containing Fine Sand.





SECTION 4 - TOXICOLOGICAL PROPERTIES

NATURE OF HAZARD

INHALATION: The prolonged inhalation of dust may result in irritation of nasal tissue. Contamination of the

eyes can cause irritation. Certain people may develop allergic dermatitis upon excessive exposure.





                                                                                                                /...2

                                                   MSDS-18

                                                September 2006



EYE CONTACT: May Irritate. No permanent damage likely.



SKIN CONTACT: Will dry skin and cause defatting dermatitis with excessive exposure of skin to dry and wet

product.



INGESTION: Can cause irritation to throat.



CHRONIC: The sand used in this product contains quartz. Quartz (Crystalline Silica) that exists as particles

with an aerodynamic diameter less than 5 Microns is hazardous. Although this product does not contain these fine

particles a dust mask should be worn when handling product in the dry state.



OCCUPATIONAL EXPOSURE LIMIT: Maximum TWA of silica (for particles 5 Micron and smaller) is 0.1 mg.

per M3 of air. For further information of the designated substance "Silica" contact the Ministry of Labour

(Occupational Health and Safety Division) in your region.

SECTION 5 - FIRST AID MEASURES

INHALATION: Remove to fresh air.



EYE CONTACT: Flush eye(s) with lukewarm water for 15 minutes holding eyelids open. If irritation persists

see physician.



INGESTION: Will irritate throat. Give individual water and see physician.



SKIN: Wash hands with soap and water. Apply good quality hand lotion. If irritation persists see physician.



SECTION 6 - PREVENTIVE MEASURES

PERSONAL PROTECTION: Wear safety glasses (with side shields), waterproof PVC or Neoprene gloves and

an approved dust mask when handling the product. Observe good personal hygiene. No engineering controls

necessary.



HANDLING STORAGE AND SHIPPING: Product must be stored under dry conditions. May be stored off the

ground and under waterproof tarp in the field for short periods of time. DO NOT ALLOW product to get wet as it

will harden.



SPILL CONTROL AND DISPOSAL: Sweep area with dust retarding floor sweeping compound. Dispose of as

normal garbage. No special precautions required.



SECTION 7 - FIRE AND EXPLOSION DATA

None. This product will not burn.



SECTION 8 - REACTIVITY DATA

Stable. Hazardous decomposition will not occur.



SECTION 9 - PREPARATION

Prepared By: R.J. Green

             Plant Manager

             CPD Construction Products

             Concord, Ontario L4K 1L4