SECTION 2 - HAZARDOUS INGREDIENTS
The following component data is defined in accordance with sub-paragraph 13(a) (i) to (iv) or paragraph 14(a) of the
Hazardous Products Act.
SECTION 4 - TOXICOLOGICAL PROPERTIES
NATURE OF HAZARD
INHALATION: Inhalation of mist may irritate nose and throat. On normal application this product should not represent a
health hazard through inhalation.
EYE CONTACT: May be irritating to eyes. No permanent damage will result.
SKIN CONTACT: May be Irritating to skin upon repeated or prolonged contact.
INGESTION: May be slight health hazard if ingested in large quantities.
/...2
MSDS-063
September 2006
SECTION 5 - FIRST AID MEASURES
INHALATION: Remove victim to fresh air. If adverse effects are experienced see physician.
EYE CONTACT: Flush with water for at least 15 minutes holding eyelids open. See physician as polymer residue could
remain on the eye if coagulation occurs.
SKIN CONTACT: Flush with water for at least 15 minutes. Use mild soap if available. Remove and launder all
contaminated clothing before reusing. See physician if irritation develops.
INGESTION: If swallowed dilute by giving two glasses of water to drink. Do not induce vomiting. Never give anything
by mouth to an unconscious person.
SECTION 6 - PREVENTIVE MEASURES
PERSONAL PROTECTION: For large jobs the minimum safety equipment should be safety glasses with side shields,
waterproof PVC or neoprene full length gloves and full work coveralls. For applications involving spraying an appropriate
full face chemical respirator should be worn. For applications not involving spraying but the possibility of splashing is
high a full face shield should be worn. Good passive ventilation practices should be used when applying this sealer.
ENGINEERING CONTROLS: Not necessary for most jobs indoors. For very large indoor jobs power ventilation
should be provided.
HANDLING, STORAGE AND SHIPPING: Keep container closed when not in use. Handle and open containers with
care. Store under normal warehouse conditions. DO NOT ALLOW PRODUCT TO FREEZE. Empty product containers
may contain product residue. DO NOT REUSE.
SPILL CONTROL AND DISPOSAL: Area of spill will be slippery; use care to avoid falling. Do not flush product into
store sewers, sanitary sewers, or water courses. Soak up product with sand, earth or some other inert material. Dispose of
in accordance with all Federal, Provincial and Municipal regulation.
SECTION 7 - FIRE AND EXPLOSION DATA
Flashpoint and Method: Non-Combustible
Autoignition Temperature: Not applicable
Flammability Limits: Not applicable
GENERAL HAZARDS: This product is non-combustible but if temperatures are high enough it will boil until all water
is driven off then the remaining resin solids will burn. Toxic gases may be evolved during a fire.
FIRE FIGHTING: Use water to extinguish fire of polymer solids. A self-contained breathing apparatus should be used
for all indoor fires.