MSDS-20

                                                    September 2006



                                     MATERIAL SAFETY DATA SHEET

                                 CPD NON-SHRINK FIBER GROUT (PRE-MIX)



SECTION 1 - PRODUCT INFORMATION

Manufacturer: CPD Construction Products

              219 Connie Crescent # 13

              Concord, Ontario L4K 1L4



Product Identifier: CPD Non- Shrink Fibre Grout (Pre-Mix)



Application and Use: Grouting Base Plates, Structural Columns,

Anchor Bolts, Dowels and for Floor overlays.



Product Description: Hydraulic Cement Grout



Regulatory Classification

WHMIS - Class E (Portland Cement)

Class D Division 2 Subdivision A (Silica Quartz)



Transportation of Dangerous Goods Information: Not regulated.



EMERGENCY TELEPHONE NUMBERS

CANUTEC: (613) 996-6666



SECTION 2 - HAZARDOUS INGREDIENTS

The following component data is defined in accordance with sub-paragraph 13(a)(i) to (iv) or paragraph 14 (a) of the

Hazardous Products Act.



NAME                                    (pbw)%           CAS

Sand **(Quartz)                          40-70          14808-60-7

Portland Cement (Hydraulic Cement)       30-60          65997-15-1



NOTE: LD50 (not available for the above)           LC50 (not available for the above)



** The sand used in this product contains Silica (Quartz). The Quartz that exists as dust particles with an aerodynamic

diameter less than 5 microns is hazardous. An approved dust mask (for crystalline Silica) should be worn by workers

handling this product in the dry state.



SECTION 3 - PHYSICAL DATA

Physical State: Powder/Granular Solid                    Viscosity: n/a

Specific Gravity: 2.20                                   Vapour Density (Air=1): n/a

Vapour Pressure: n/a                                     Evaporation Rate: n/a

Solubility in Water: < 1.0%                              % Volatile: n/a

Ph: 12.5 @ 20°C (Aqueous Solution)                       Odour: None

Boiling Point: n/a                                       Appearance: Dark to Light Grey Powder Containing Fine Sand









                                                                                                                   /...2

                                                       MSDS-20

                                                    September 2006



SECTION 4 - TOXICOLOGICAL PROPERTIES

NATURE OF HAZARD



INHALATION: Crystalline Silica (Quartz) dust particles below 5 Microns in diameter may be present in this product.

Excessive inhalation of particles of this size (or smaller) may cause lung disease (Silicosis).



The prolonged inhalation of dust may result in irritation of nasal tissue and the cornea (white) of the eye. Certain people

may develop allergic dermatitis.



EYE CONTACT: May Irritate. No permanent damage likely.



SKIN CONTACT: Will dry skin and cause dermatitis with excessive exposure of skin to dry and wet product.



INGESTION: Can cause irritation to throat.



CHRONIC: Excessive exposure inhalation could lead to development of the irreversible lung disease "Silicosis".

Crystalline silica is classified by IARC as " 2A-Probably Carcinogenic to humans".



OCCUPATIONAL EXPOSURE LIMIT: Maximum TWA of silica is 0.1 mg. per M3 of air. For further information

of the designated substance "Silica" contact the Ministry of Labour (Occupational Health and Safety Division) in your

region.



SECTION 5 - FIRST AID MEASURES

INHALATION: Remove to fresh air.



EYE CONTACT: Flush eye(s) with lukewarm water for 15 minutes holding eyelids open. If irritation persists see

physician.



INGESTION: Will irritate throat. Give individual water and see physician.



SKIN: Wash hands with soap and water. Apply good quality hand lotion. If irritation persists see physician.



SECTION 6 - PREVENTIVE MEASURES

PERSONAL PROTECTION: Wear safety glasses (with side shields), waterproof PVC or Neoprene gloves and an

approved dust mask when handling the product. Observe good personal hygiene. No engineering controls necessary.



HANDLING STORAGE AND SHIPPING: Product must be stored under dry conditions. May be stored off the

ground and under a waterproof tarp in the field for short periods of time. DO NOT ALLOW product to get wet as it will

harden.



SPILL CONTROL AND DISPOSAL: Sweep area with dust retarding floor sweeping compound. Dispose of as

normal garbage. No special precautions required.



SECTION 7 - FIRE AND EXPLOSION DATA

None. This product will not burn.



SECTION 8 - REACTIVITY DATA

Stable. Hazardous decomposition will not occur.



SECTION 9 - PREPARATION

Prepared By: R.J. Green

             Plant Manager

             CPD Construction Products

             Concord, Ontario L4K 1L4