Crystal Cote
Wood Floor Care
350 For Use On:
Sealed Wood Sealed Concrete
Sealed Cork Parquet Floors
VOC Compliant Polyurethane
Wood Finish DESCRIPTION
A high solids oil modified polyurethane finish designed for use on sports, com-
mercial and residential wood floors. Produces outstanding durability and resis-
tance to scuffs, spills and stains. Leaves surface with an extremely rich high
gloss that dirt and grime can始t possibly penetrate. High solids make this product
able to meet the strict VOC (Volatile Organic Compounds) requirements, which
have been established in many states throughout the country. Easy to apply, it is
compatible over a wide variety of conventional solvent based coatings (provided
these coatings are cured, bonded and the floor is properly prepared).
Manufacturer始s Recommendation: This coating is to be applied without
thinning. VOC Content <350 grams/liter
DIRECTIONS
ON NEW OR NEWLY PREPARED FLOORS: Use a good quality polyurethane
sealer, following the directions for that product. Allow to dry thoroughly.
ON NEWLY SEALED FLOORS: Buff with a #120 abrasive screen. Clean sur-
face thoroughly with a tack rag and waterless cleaner and allow to dry. Apply
finish using a synthetic or lamb始s wool applicator, pressure sprayer or gravity
fed applicator. If more than one coat is desired, allow 6 to 8 hours dry time
between coats. No screening is required if recoating is done within 24 hours.
Allow 72 hours cure time before allowing any foot traffic on floors (no dances
or similar events for at least one week).
NOTE: Best results are obtained with adequate ventilation and floor temperature
above 60掳F and below 95掳F. Avoid direct drafts on floor while finishing.
CAUTION: Do not use on any resilient type flooring.
PRODUCT SPECIFICATIONS
Removability: With conventional ure
Non-volatile solids: 55.0卤0.5%
thane strippers
Gardner Color: (Typical)..................6
Drying Properties: Set to touch - 1-3 hrs.
(Maximum)............12
Recoat - 6-8 hrs.
Odor: Petroleum Distillates
Dry hard - 48 hrs.
Type: Oil modified urethane
Recoatability: Excellent (follow direc-
Solvent Systems: Mineral spirits/Siloxane
tions)
Flash Point: 106 F (TCC)
o
Storage/Stability: 2 years
Viscosity: A-C, Gardner
Freeze/Thaw Stability: Stable
Slip Resistance: Greater than 0.50
Weight per Gallon: 7.58 lbs./gal.
Sward Hardness: Greater than 30
Coverage: 500-700 ft2 per gal.
Chemical Resistance: Excellent
VOC Content: 347 gms/liter
Misco Products Corporation Reading, PA (800) 548-4568 FAX (610) 926-1194
www.miscoprod.com
ULV MATERIAL SAFETY DATA SHEET N/A=Not Applicable
Effective Date: 8/05 Revision: n/a
Prepared by: Regulatory Affairs Dept. (Prepared According to 29 CFR 1910.1200)
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Manufacturer聮s Name: Product Name: Crystal Cote 350 Supplier聮s Name:
Misco Products Corporation Generic Name: Polyurethane Wood Finish
Manufacturer聮s Address: Supplier聮s Address:
Chemical Family: Solvent Urethane Blend
1048 Stinson Drive Reading, PA 19605 Formula: Proprietary
Manufacturer聮s Phone #: (610) 926-4106 Supplier聮s Phone #:
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Petroleum Distillates 8052-41-3 15 to 20 300 ppm 100 ppm N/A
Oil Modified Urethane Resin N/A 55 to 60
Octamethylcyclotetrasiloxane 556-67-2 10 to 15 Not Established Not Established Not Established
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): 104 F. (TCC)
Boiling Point (锟紽): 300 F. Initial Specific Gravity: 0.909
Upper Explosion Limit: 6.0 Lower Explosion Limit: 1.0
Vapor Pressure: <10mm Hg @ 68 F. Vapor Density (Air=1): >1
Extinguishing Media: Foam, CO2, dry chemical.
% Volatile: 45+ pH: N/A
Special Firefighting Procedures: Do Not Use Water.
Solubility in Water: Nil Evaporation Rate (Water=1): <1
Unusual Fire and Explosion Hazards: Drums heated by fire can explode.
Physical Description: Moderately viscous yellow liquid with characteristic odor.
VOC Content (Subpart D 搂59.406) : 347 grams/liter (2.89 lbs/gal)
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: May occur through oxidation, leading to exothermic
reaction. Heat generated by oxidation may lead to spontaneous combustion of materials
such as rags, paper towels, etc., used for clean-up
Hazards Decomposition Products: Carbon monoxide possible if burned. Incompatibility (Materials to Avoid): Strong oxidizers.
SECTION 6-STORAGE AND HANDLING INFORMATION
Combustible liquid. Avoid contact with heat, spark or open flame. Eye irritant. May cause skin irritation. Keep out of reach of children. For use by trained personnel only. Keep
unauthorized personnel away when applying to floor. Keep container closed during storage. For institutional and industrial use only. Avoid contact with eyes, skin and clothing.
Wear rubber gloves when handling. Wear protective boots when applying to floors. Avoid breathing of vapors. Use in well-ventilated area.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure: Respiratory Protection: NIOSH approved hydrocarbon cartridge or self-contained
Skin: Prolonged or repeated contact may cause irritation, defatting, or dermatitis. apparatus when used in enclosed areas.
Eyes: Eye irritant. May cause redness, swelling, or blurred vision. Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-
Inhalation: May be irritating to the nose, throat, and lungs. Prolonged breathing can gredients below acceptable limit. Open doors and windows when handling and during
drying period.
cause headache, nausea, dizziness, weakness, and fatigue. Some reports have associated
Protective Gloves: Solvent proof rubber recommended.
repeated and prolonged occupational overexposure to solvents with permanent brain and
nervous system damage. Eye Protection: Safety glasses recommended.
Ingestion: Can cause irritation of the gastrointestinal tract, nausea, vomiting, and Other Protective Equipment: Eye wash station should be available nearby. Protective
diarrhea. Aspiration of material into the lungs can cause pneumonitis. clothing and footwear (rubber boots) when using on floors.
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Skin: Remove contaminated clothing. Wash with soap and water. Seek medical attention Steps to be taken in Case Material is Released or Spilled: Shut off all ignition
if irritation persists. sources. Ventilate area well. Floors will become slippery. Avoid walking in product.
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical attention. Keep unessential personnel away. Mop up or otherwise absorb and hold disposal.
Avoid discharge to sewer or open waterways.
Inhalation: Get to fresh air. If breathing is difficult, give oxygen. Seek medical attention
Waste Disposal Method: Any method in accordance with local, state and federal laws.
if symptoms persist.
Best method is to recycle or reuse for intended purpose. If discarded, this material and
Ingestion: Do not induce vomiting. Seek medical attention immediately.
containers should be treated as hazardous waste based on the characteristic of ignitability
as defined under federal RCRA regulations (40 CFR 261). Materials used to absorb
product should be soaked in water-filled containers or rinsed with water prior to
discarding in trash receptacles. Do not dispose of into storm drain, stream, river or to
ground. Rinse container thoroughly before discarding in trash.
SECTION 10-REGULATORY INFORMATION
SARA Title III - Section 311/312 -Hazard Categories: Domestic Shipping Information: HMIS Hazardous Materials
Identification System
Yes - Fire Hazard FOR CONTAINERS > 1 Gallon : Cleaning Compound
Health 2
No - Sudden Release of Pressure Hazard
Flammability 2
No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Cleaning Compound
Reactivity 0
Yes - Immediate (acute) Health Hazard
Personal Protection B
No - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Cleaning Compound
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and
of 40 CFR 372.
CAS# Chemical Name Percent by Weight
None
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
None
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the application of this
information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to provide a safe workplace, using the
health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from the improper handling and use of this product
|