MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-4000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1. General Notes
This formulation is a trade secret and considered confidential and proprietary information of Team, Inc.
UND = Undetermined
NA = Not Applicable
2. Product Information
Product Part Number / Name: 900-0062 / S-4000
Chemical Family: Refractory Hybrid Compound
Product Use: Industrial Leak Sealant
Product Description: Fibrous Resin Mixture
3. Hazardous Ingredients OSHA ACGIH OSHA ACGIH
PEL TLV PEL TLV Possible
Compound CAS Number Percent (mg/m3) (mg/m3) (ppm) (ppm) Carcinogen
modified natural resins - trade secret None 10 - 25 10 15
Established
silicon dioxide 7631-86-9 10 - 25 10 10
aluminum oxide 1344-28-1 10 - 25 15 10
aluminum silicate - clay 1332-58-7 10 - 25 5 2
Notes
4. Physical Data
Boiling Point (F): UND. Specific Gravity (H20 = 1): 1.3
Vapor Pressure (mm Hg): UND. Melting Point (F): UND.
Solubility in H20: NIL Evaporation Rate (Butyl Acetate = 1): UND.
Appearance and Odor: Brownish thick fibrous paste.
5. Fire and Explosion Hazard Information
Flash Point (Closed Cup) (F): > 400
Flammability Limits in Air (%): Low: UND. High: UND.
Extinguishing Media: Carbon dioxide or foam.
Page 1 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-4000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Special Fire Fighting Procedures: SCBA
Unusual Fire and Explosion Sealed cans may rupture with high heat or fire.
6. Reactivity Data
Stability: Stable.
Conditions to Avoid: None known.
Materials to Avoid: Strong oxidizers and strong acids.
Hazardous Decomposition Products: CO, CO2, Various hydrocarbon gases and Hydrogen.
Hazardous Polymerization: Will not occur.
7. Health Hazards
Routes of Entry:
Inhalation: Yes
Skin: Yes
Eyes: Yes
Ingestion: Yes
Acute Symtoms:
Inhalation: Breathing excessive vapors may cause dizziness or headache.
Skin: Contact on bare skin can cause dermatitis, redness, itching.
Eyes: May cause irritation and in extreme cases, possibly blindness.
Ingestion: May cause dizziness, unconsciousness, CNS disorder (headache,
nausea, vomiting) and if ingested in large quantities, possibly death.
Carcinogenicity:
National Toxicology None.
IARC Monographs: None.
OSHA Regulated: None.
Page 2 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-4000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Chronic Symptoms: None Known.
Medical Conditions Aggravated: None Known.
1st Aid Procedures:
Inhalation: Immediately remove from contaminated area to fresh air.
Skin: Thoroughly wash affected area with soap and water. Flush area with
water for 15 minutes. If irritation develops, obtain medical attention.
Eyes: Flush with water for at least 15 minutes. If irritation develops, obtain
medical attention.
Ingestion: Do not induce vomiting. Obtain medical attention.
8. Safe Handling / Disposal / Use
Releases or Spills: Sweep or pick up with industrial vacuum. Place in container for disposal.
If needed, clean with alcohol or acetone.
Disposal: Landfill or incinerate in accordance with federal, state, and local
regulations.
Ventilation: Use adequate ventilation.
Other Storage Precautions: Keep away from open flames. Avoid prolonged contact with skin.
9. Control Measures
Respiratory Protection: If ventilation is poor, an acid vapor respirator is recommended.
Ventilation: Local exhaust is usually adequate. If necessary use mechanical exhaust.
Hand Protection: Chemical resistant gloves.
Eye Protection: Safety goggles or glasses.
Page 3 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-4000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Other: Other equipment as necessary.
Hygienic Practices: Wash hands with soap and water.
10. Hazard Ratings
NFPA
Health: 1
Flammability: 1
Reactivity: 0
11. Additional Information
This data is offered in good faith as typical values and not as a product specification. No warranty, is
either expressed or implied. The recommended handling procedures are believed to be generally
applicable. However, each user should review these recommendations in the specific context of the
intended use.
End of Document
Page 4 of 4
|