INVADE 80 鈩?
PREMIUM-LOW FOAM, NONIONIC SPREADER-ACTIVATOR
ACTIVE INGREDIENTS: DIRECTIONS FOR USE
Alkyl Aryl Polyoxyethylene Ether, Free Fatty Acids For use with acaracides, insecticides, fungicides, miticides,
and Isopropanol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 %
(Livestock sprays): Use 1/4 to 1/2 pint (4 to 8 fl. oz.) per 100
Constituents ineffective as a spray adjuvant . . . . . . . . . . . 20 % gallons of water.
TOTAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100%
For use with herbicides (aquatic & terrestrial), defoilants,
All ingredients are exempt from tolerance requirements under dessicants: Use 1/2 to 4 pints per 100 gallons of water. In
40 CFR 180.
difficult wetting situations (such as hard water on mature
waxy foliage) the higher rates may be required.
KEEP OUT OF REACH OF CHILDREN
WARNING TYPE OF APPLICATION PER 100 GALLON
Citrus, Turf 1 to 2 pints
Harmful if swallowed. If taken internally, DO NOT induce vomiting,
call a physician at once. Avoid breathing spray mist. In case of Utility and Highway R.O.W. 1 to 4 pints
contact with eyes, flush thoroughly with water and seek medical Forest Site Preparation 1 to 4 pints
SPECIMEN
attention. Wash skin with soap and water.
Aquatic / Surface 1 to 4 pints
Aquatic / Submerged 1 to 4 pints
FIRST AID Insecticides, Fungicides,
LABEL
Miticides 1 to 2 pints
Call a poison control center or doctor immediately
for treatment advice.
If Swallowed: Have person sip a glass of water if able to swallow.
Do not induce vomiting unless told to do so by a poison control WARRANTY
center or doctor. Do not give anything by mouth to an unconscious
Townsend warrants that this product, when used as directed,
person.
is reasonably fit for use as designated on this label.
If on Skin or Clothing: Take off contaminated clothing. Rinse skin
Townsend makes no warranty of fitness or merchantability.
immediately with plenty of water for 15-20 minutes.
Townsend's maximum liability for breach of this warranty
If Inhaled: Move person to fresh air. If person is not breathing, call shall not exceed the purchase price of this product. In no
911 or an ambulance, then give artificial respiration, preferably
event shall Townsend be liable for indirect or consequential
mouth to mouth if possible.
damages. This warranty shall not be changed by oral or
If in Eyes: Hold eye open and rinse slowly and gently with water written agreement unless signed by a duly authorized
for 15-20 minutes. Remove contact lenses if present, after the first officer of Townsend.
5 minutes, then continue rinsing eye. Have the product container
with you when calling a poison control center or doctor, or going
for treatment.
GENERAL INFORMATION
FOR USE WITH INDUSTRIAL, FORESTRY, UTILITY, AQUATIC,
ROADSIDE AND OTHER HERBICIDE PRODUCTS.
INVADE 80 is a highly concentrated low-foam, non-ionic
spreader activator. INVADE 80 increases the activity and
Manufactured For:
effectiveness of insecticides, fungicides and herbicides by
TOWNSEND CHEMICAL DIVISION
breaking down the waxy cuticle on the leaf surface and
SELMA, INDIANA 47383
improves adhesion between the pesticide and the plant
surface.
Page 1 of 3
INVADE 80
Date of Revision: 10-11-04
Supersedes: 4-26-01
Date of Issue: 4-17-96
TOWNSEND CHEMICAL DIVISION
IN CASE OF EMERGENCY CALL
INFOTRAC: 1-800-535-5053
MATERIAL SAFETY DATA
1. PRODUCT IDENTIFICATION
TRADEMARK: INVADE 80
SYNONYMS: NONIONIC SURFACTANT
MOLECULAR FORMULA: PROPRIETARY BLEND
2. HAZARDOUS INGREDIENTS
OSHA REGULATED
COMPONENT CAS. NO WT% EXPOSURE LIMITS
Ethanol, 2, 2-oxybis 111-46-6 - Not Established
Isopropanol 67-63-0 - PEL: 400 ppm/8 hrs.
Maximum of 1 ppm Ethylene Oxide (EO) (75-21-8) May be present in the product.
The OSHA PEL and ACGIH TLV for EO is 1 ppm.
3. EFFECTS OF OVEREXPOSURE:
EYE CONTACT: May cause eye irritation.
SKIN CONTACT: Prolonged contact may cause irritation to skin with local redness on skin.
INGESTION: May cause abdominal discomfort. Aspiration may occur during swallowing, resulting in
lung damage.
INHALATION: Avoid breathing vapors or spray mist. Use respiratory protection device when handling.
4. EMERGENCY FIRST AID
Call a poison control center or doctor immediately for treatment advice.
IF SWALLOWED: Have person sip a glass of water if able to swallow. Do not induce vomiting unless
told to do so by a poison control center or doctor. Do not give anything by mouth
to an unconscious person.
IF ON SKIN OR
CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty of water for
15-20 minutes.
IF INHALED: Move person to fresh air. If person is not breathing, call 911 or an ambulance,
then give artificial respiration, preferably mouth to mouth if possible.
IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes.
Remove contact lenses if present, after the first 5 minutes, then continue rinsing
eye. Have the product container with you when calling a poison control center or
doctor, or going for treatment.
Page 2 of 3
INVADE 80
Date of Revision: 10-11-04
Supersedes: 4-26-01
Date of Issue: 4-17-96
5. REACTIVITY DATA
STABILITY: ( ) unstable (x) stable
INCOMPATIBILITY
(MATERIALS TO AVOID): Strong oxidizing agents such as hydrogen peroxide, bromine, and
chromic acid.
HAZARDOUS POLYMERIZATION: ( ) may occur (x) will not occur
CONDITIONS TO AVOID: None
6. PHYSICAL PROPERTIES
APPEARANCE AND ODOR: Clear Amber Liquid Mild
BOILING POINT: NA
SPECIFIC GRAVITY: 1.018
VAPOR DENSITY: (X ) heavier ( ) lighter than air
% VOLATILE (BY VOL): < 1%
EVAPORATION RATE: ( ) faster ( X ) slower than ether
SOLUBILITY IN WATER: Soluble
7. FIRE AND EXPLOSION HAZARD INFORMATION
DOT CATEGORY: Flammable liquid (regulated by 49 CFR 173.120)
115 掳F
FLASHPOINT:
OSHA CATEGORY: N/A
EXTINGUISHING MEDIA: Use National fire protection association Class B extinguishers (Carbon
dioxide, water fog, dry chemical or foam). Water may also be used.
SPECIAL FIRE FIGHTING
PROCEDURES: Cool fire exposed containers with water. Wear NIOSH/OSHA approved
self-contained breathing apparatus and protective clothing to prevent
contact with skin and eyes.
UNUSUAL FIRE HAZARD: None known
8. SPECIAL PRECAUTIONS
HANDLING AND STORAGE: Keep container tightly closed. Keep away from heat, sparks and flame.
Do not use with aluminum equipment at temperatures above 49 掳C
(120 掳F).
OTHER PRECAUTIONS: Do not take internally. Prevent contact with contaminated clothing.
Wash contaminated clothing before reuse.
9. SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: Not required under normal operating conditions.
VENTILATION: Where employees may be exposed, provide general dilution or local
exhaust ventilation in volume and pattern to keep level of hazardous
ingredient in Section 2 below recommended (ACGIH TLV) or regulate C
(OSHA PEL) limit. Where employees will not be exposed, keep level
below 25% of LEL in Sect. 2.
PROTECTIVE GLOVES: Wear chemically resistant gloves.
EYE PROTECTION: Safety glasses with slide shields or goggles.
OTHER PROTECTIVE EQUIP.: Avoid skin contact by use of other protective clothing. A safety shower,
an eyebath and washing facilities should be available.
Page 3 of 3
INVADE 80
Date of Revision: 10-11-04
Supersedes: 4-26-01
Date of Issue: 4-17-96
10. SPILL OR LEAK PROCEDURES
ENVIRONMENTAL RELEASES: Certain releases of any substance to the environment are prohibited by
law and may require reporting to an environmental agency Remove all
sources of ignition. Wear personal protective equipment to avoid
breathing vapors Use non-sparking tools. For small spills, dike and
absorb with inert material. Use emergency response professionals if
managing a release is beyond the capability of in-house personnel.
WASTE DISPOSAL: This material is not classified as an ignitable hazardous waste according
to federal regulations. Check with your state environmental agency to
determine if this material is regulated in any way. No disposal method
should be used which would pose an environmental or human health
threat including any which would contaminate ground or surface waters.
The recommendation for safe handling and protection procedures is believed to be generally suitable for the standard uses of this
compound. However, each user should identify his intended uses of this material and determine whether they are appropriate. All data
included in this document is released as typical values and should not be utilized to determine the suitability of this material for a
particular use or purpose. No warranty, either expressed or implied, is hereby made, nor do we give permission, inducement, or
recommendations to practice any patented invention without a license. All data is offered for consideration, investigation and verification
purposes only.
TOWNSEND CHEMICAL DIVISION
SELMA, INDIANA 47383
|