MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: F-1000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1. General Notes
This formulation is a trade secret and considered confidential and proprietary information of Team, Inc.
UND = Undetermined
NA = Not Applicable
2. Product Information
Product Part Number / Name: 902-0001 / F-1000
Chemical Family: Polytetrafluoroethylene
Product Use: Industrial Leak Sealant
Product Description: PTFE Fiber
3. Hazardous Ingredients OSHA ACGIH OSHA ACGIH
PEL TLV PEL TLV Possible
Compound CAS Number Percent (mg/m3) (mg/m3) (ppm) (ppm) Carcinogen
titanium dioxide 13463-67-7 >1 15 10
Notes
4. Physical Data
Boiling Point (F): UND. Specific Gravity (H20 = 1): 2.1 - 2.2
Vapor Pressure (mm Hg): UND. Melting Point (F): 320 - 341 C
Solubility in H20: Insoluble Evaporation Rate (Butyl Acetate = 1): UND.
Appearance and Odor: White odorless powder.
5. Fire and Explosion Hazard Information
Flash Point (Closed Cup) (F): UND.
Flammability Limits in Air (%): Low: UND. High: UND.
Extinguishing Media: N/A use media suitable for surrounding fires.
Special Fire Fighting Procedures: SCBA with full faceshield
Unusual Fire and Explosion Product will emit toxic fumes
6. Reactivity Data
Page 1 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: F-1000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Stability: Stable.
Conditions to Avoid: Heating above 750 F for prolonged periods.
Materials to Avoid: Molten alkali metals; Interhalogen compounds.
Hazardous Decomposition Products: Tetrafluoroethylene, hexafluoropropylene, perfluoroisobutylene, and
carbonyl flouride
Hazardous Polymerization: Will not occur.
7. Health Hazards
Routes of Entry:
Inhalation: Yes
Skin: Yes
Eyes: Yes
Ingestion: Yes
Acute Symtoms:
Inhalation: May cause flu like transient sickness.
Skin: Probably non-irritatating and non-absorbing.
Eyes: May cause irritation.
Ingestion: None Known..
Carcinogenicity:
National Toxicology None.
IARC Monographs: None.
OSHA Regulated: None.
Chronic Symptoms: Repeated or prolonged exposure may result in accumulation of toxins to
cause illness to the body.
Medical Conditions Aggravated: Respiratory inflammation
Page 2 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: F-1000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1st Aid Procedures:
Inhalation: Immediately remove from contaminated area to fresh air. Keep individual
quiet. In case of respiratory distress, give oxygen or give artificial
respiration. Obtain medical attention.
Skin: Thoroughly wash affected area with soap and water. Flush area with
water for 15 minutes. If irritation develops, obtain medical attention.
Eyes: Flush with water for at least 15 minutes. If irritation develops, obtain
medical attention.
Ingestion: Do not induce vomiting. Obtain medical attention.
8. Safe Handling / Disposal / Use
Releases or Spills: Sweep or pick up with industrial vacuum. Place in container for disposal.
If needed, clean with alcohol or acetone.
Disposal: Landfill or incinerate in accordance with federal, state, and local
regulations.
Ventilation: Use adequate ventilation.
Other Storage Precautions: Keep away from open flames. Avoid prolonged contact with skin.
9. Control Measures
Respiratory Protection: If ventilation is poor, an organic vapor respirator is recommended.
Ventilation: Local exhaust is usually adequate. If necessary use mechanical exhaust.
Hand Protection: Hydrocarbon resistant gloves recommended.
Eye Protection: Safety goggles or glasses.
Other: Other equipment as necessary.
Hygienic Practices: Wash hands with soap and water.
10. Hazard Ratings
Page 3 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: F-1000
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
NFPA
Health: 2
Flammability: 1
Reactivity: 0
11. Additional Information
This data is offered in good faith as typical values and not as a product specification. No warranty, is
either expressed or implied. The recommended handling procedures are believed to be generally
applicable. However, each user should review these recommendations in the specific context of the
intended use.
End of Document
Page 4 of 4
|