MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-250 KIT
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1. General Notes
This formulation is a trade secret and considered confidential and proprietary information of Team, Inc.
UND = Undetermined
NA = Not Applicable
2. Product Information
Product Part Number / Name: 907-0025A / S-250 KIT
Chemical Family: Elastomer System
Product Use: Industrial Leak Sealant
Product Description: Bonder
3. Hazardous Ingredients OSHA ACGIH OSHA ACGIH
PEL TLV PEL TLV Possible
Compound CAS Number Percent (mg/m3) (mg/m3) (ppm) (ppm) Carcinogen
quartz 14808-60-7 50 + 10 0.05 250 yes
calcium carbonate 471-34-1 >1 10
benzene 71-43-2 >0.1 1 0.5 yes
Notes
4. Physical Data
Boiling Point (F): UND. Specific Gravity (H20 = 1): 1.28
Vapor Pressure (mm Hg): LOW Melting Point (F): UND.
Solubility in H20: Negligible Evaporation Rate (Butyl Acetate = 1): UND.
Appearance and Odor: Two-component, odorless elastomeric system comprised of the part A resin (Beige)
5. Fire and Explosion Hazard Information
Flash Point (Closed Cup) (F): > 400 F
Flammability Limits in Air (%): Low: UND. High: UND.
Extinguishing Media: Water or chemical type extinguisher.
Special Fire Fighting Procedures: None known.
Page 1 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-250 KIT
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Unusual Fire and Explosion None known.
6. Reactivity Data
Stability: Stable.
Conditions to Avoid: None known.
Materials to Avoid: None known.
Hazardous Decomposition Products: None known.
Hazardous Polymerization: Will not occur.
7. Health Hazards
Routes of Entry:
Inhalation: Yes
Skin: Yes
Eyes: No
Ingestion: Yes
Acute Symtoms:
Inhalation: May cause irritation to the mucous membrane of throat and respiratory
tract.
Skin: Repeated or prolonged exposure may cause irritation.
Eyes: May cause irritation and in extreme cases, possibly blindness.
Ingestion: May cause dizziness, unconsciousness, CNS disorder (headache,
nausea, vomiting) and if ingested in large quantities, possibly death.
Carcinogenicity:
National Toxicology Yes
IARC Monographs: Yes
OSHA Regulated: Yes
Page 2 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-250 KIT
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Chronic Symptoms: Repeated or prolonged exposure may result in accumulation of toxins to
cause illness to the body and possibly death. Target organs are CNS,
kidneys, pancreas, lungs, eyes, skin and respiratory tract.
Medical Conditions Aggravated: None known.
1st Aid Procedures:
Inhalation: Immediately remove from contaminated area to fresh air. Keep individual
quiet. In case of respiratory distress, give oxygen or give artificial
respiration. Obtain medical attention.
Skin: Thoroughly wash affected area with soap and water. Flush area with
water for 15 minutes. If irritation develops, obtain medical attention.
Eyes: Flush with water for at least 15 minutes. If irritation develops, obtain
medical attention.
Ingestion: Induce vomiting. Promptly initiate gastric lavage or stomach pump. Obtain
medical attention.
8. Safe Handling / Disposal / Use
Releases or Spills: Sweep or pick up with industrial vacuum. Place in container for disposal.
If needed, clean with alcohol or acetone.
Disposal: Landfill or incinerate in accordance with federal, state, and local
regulations.
Ventilation: Use adequate ventilation.
Other Storage Precautions: Keep away from open flames. Avoid prolonged contact with skin.
9. Control Measures
Respiratory Protection: If ventilation is poor, an organic vapor respirator is recommended.
Ventilation: Local exhaust is usually adequate. If necessary use mechanical exhaust.
Hand Protection: Hydrocarbon resistant gloves recommended.
Eye Protection: Safety goggles or glasses.
Page 3 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: S-250 KIT
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Other: Other equipment as necessary.
Hygienic Practices: Wash hands with soap and water.
10. Hazard Ratings
NFPA
Health: 0
Flammability: 0
Reactivity: 0
11. Additional Information
This data is offered in good faith as typical values and not as a product specification. No warranty, is
either expressed or implied. The recommended handling procedures are believed to be generally
applicable. However, each user should review these recommendations in the specific context of the
intended use.
End of Document
Page 4 of 4
|