Page 1 of 2
TIMBERSEAL
USES:
TIMBER SEAL can be used as a first coat for the following materials.
1. All types of cork tiles.
2. Pine species - Radiata, Baltic, Cypress.
3. Particle Board
4. All species of HARDWOODS.
TIMBER SEAL may also be mixed with fine sawdust to slurry consistency, for use as a filler for timber
seams.
EDGE BONDING: As TIMBER SEAL is highly flexible, it will virtually eliminate EDGE BONDING if it
is heavily applied and worked into the seams, thereby preventing entry of the subsequent coat of
MONOTHANE. Where seams are in excess of 1mm, they can be filled with a mixture of TIMBERSEAL
and fine sanding dust forced into the seam with the edge of a steel trowel.
APPLICATION:
1. Fine sand and vacuum thoroughly.
2. Apply TIMBER SEAL with a roller, lambs wool pad, or brush. Allow 30 -40 minutes to dry. Do not
return unused material to the can.
3. Apply one or two coats of MONOTHANE. Urethane Coatings CATALYST may be added to the first
coat of MONOTHANE to accelerate curing.
NOTE: TIMBER SEAL may also be coated with DUOTHANE PART A / DUOTHANE PART B,
Page 2 of 2
DUOTHANE FAST A / DUOTHANE PART B, or TUNGSEAL.
COVERAGE: 10m虏 per litre. Thin with URETHANE COATINGS' THINNERS if required.
SHELF LIFE: This product is best if used within 12 months from manufacture (refer to batch number),
when stored in unopened containers under normal conditions of temperature and humidity.
SHAKE WELL
SAFETY DIRECTIONS: Usage of this material must be under well ventilated conditions to minimise
inhalation of vapours. Wear respirator with filters that conform with AS1716. Asthmatics, the very young,
elderly people and pets should leave the site during the first 24 hours. Prevent skin contact by wearing
impervious gloves. Breathing of vapour is harmful and may cause lung irritation and allergic respiratory
reaction. Irritates skin and eyes. Keep tin firmly lidded, as this product cures when exposed to air. In case of
spillage, absorb into dry sand or dirt. Remove from work area and cover with water for 24 hours prior to
disposal.
WARNING FLAMMABLE: Contains 550gms per litre of Aromatic Hydrocarbons. This tin contains
volatile and flammable solvents and when using contents adequate ventilation to the outside must be
provided. All potential sources of ignition (open flames, pilot lights, furnaces, spark producing electrical
switches, etc.) must be eliminated in or near the working area. DO NOT SMOKE. Keep tin closed when not
in use.
FIRST AID: If affected by inhalation of vapour, remove to fresh air. If breathing difficulty persists or
occurs later, consult a doctor and have label ready. If swallowed, do NOT induce vomiting. Give water or
milk. CONTACT DOCTOR OR POISONS INFORMATION CENTRE Australia 131126. In case of eye
contact, flush immediately with water for fifteen minutes and call a doctor. In case of skin contact, remove
contaminated clothing and wash skin first with methylated spirits, then with soap and water.
|