Page 1 of 10
MATERIAL SAFETY DATA SHEET
Section 1 Product & Company Identification
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Product Catalog No. ............... : 84322, 84332, 84337, 84342
Company Name...................... : Ridge Tool Company
Address .................................. : 400 Clark Street
: Elyria, Ohio 44036-2023
Telephone .............................. : 1-800-519-3456 (USA) (8:00 am 5:00 pm EST, M-F)
Emergency Telephone ........... : 1-440-323-5581 (USA) (24 Hours)
Issue Date .............................. : March 27, 2008
Section 2 Hazards Identification
EMERGENCY OVERVIEW:
This product is a white paste. Direct eye contact may cause short term irritation. Short
term skin exposure is not expected to be irritating. Inhalation and ingestion are not
anticipated routes of exposure during normal conditions of use.
POTENTIAL HEALTH EFFECTS AND SYMPTOMS FROM SHORT TERM / ACUTE
EXPOSURE:
Eye
This product is not expected to cause eye irritation under normal conditions of
use. Symptoms of eye irritation may result when direct contact occurs and may
include redness, tearing and burning sensation.
Skin
Short term skin contact is not expected to cause skin irritation. Prolonged or
repeated direct exposure to the skin may result in symptoms of irritation and
possibly dermatitis.
Inhalation:
Inhalation may irritate mucous membranes and nasal passages. Overexposure
may cause vomiting, diarrhea and drunk-like symptoms such as dizziness,
blurred vision, loss of balance, slurred speech and narcosis. The inhalation of
teflon vapors, fumes or dust may lead to temporary flu-like symptoms. However,
the release of teflon in this product is unlikely except when heating above 500掳F.
Page 2 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Ingestion:
Ingestion may cause vomiting, diarrhea and drunk-like symptoms such as
dizziness, blurred vision, loss of balance, slurred speech and narcosis. In
extreme cases, chronic ingestion may result in loss of consciousness and death.
Potential Chronic Health Effects
Chronic ingestion may lead to kidney or liver damage.
Medical Conditions Aggravated By Exposure:
No further data known.
Carcinogenicity:
This product is not listed as a known or suspected carcinogen by IARC, OSHA or
the NTP.
Section 3 Composition / Information On Ingredients
Components listed in this section may contribute to the potential hazards associated
with exposure to the concentrate. The product may contain additional non-hazardous or
trade secret components.
Component: CAS # % By Weight
Calcium Carbonate 1317-65-3 35 45
Hydrocarbon Oils 64742-52-5 30 40
Teflon 9002-84-0 10 20
Titanium Dioxide 13463-67-7 5 10
Clays 68953-58-2 15
CARCINOGENIC COMPONENTS:
This product contains no carcinogens.
Page 3 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Section 4 First Aid Measures
EYE CONTACT:
Upon direct eye contact, hold eyelids open and flush with a steady, gentle stream
of water for at least 15 minutes. Call a physician.
SKIN CONTACT:
Remove product from the skin by washing with a mild soap and water.
Contaminated clothing should be removed to prevent prolonged exposure. If
symptoms of exposure persist, contact a physician.
INHALATION:
If respiratory irritation or distress occurs, remove the individual to fresh air. If
breathing is difficult, give oxygen. Contact a physician or other medical
professional if irritation or distress persists.
INGESTION:
Dilute stomach contents with two glasses of water or milk. (NOTE: Do NOT give
anything by mouth to an unconscious person.) Do not induce vomiting without
medical supervision. If vomiting occurs spontaneously, keep airway clear. Seek
medical attention.
NOTE TO PHYSICIANS:
No further data known.
Section 5 Fire Fighting Measures
FIRE AND EXPLOSIVE PROPERTIES:
Flashpoint ..........................: > 300掳F
Flammability Limits ............: LEL - N/A
UEL - N/A
Page 4 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
EXTINGUISH MEDIA:
In accordance with NFPA guidance, dry chemical, foam, water or CO2 fire
extinguishers are all acceptable.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
The inhalation of teflon vapors, fumes or dust may lead to temporary flu-like
symptoms.
FIRE-FIGHTING PROCEDURES AND EQUIPMENT:
Emergency responders in the danger area should wear bunker gear and self-
contained breathing apparatus for fires beyond the incipient stage. See Section
8 of the MSDS for other PPE to be worn as conditions warrant.
Section 6 Accidental Release Measures
PERSONAL PRECAUTIONS:
Use personal protection recommended in Section 8.
ENVIRONMENTAL:
This material is a water pollutant. Do not let spilled or leaking material enter
waterways.
CLEAN-UP MEASURES:
Important: As with any spill or leak, before responding, ensure that you are
familiar with the potential hazards and recommendations of the MSDS.
Appropriate personal protective equipment must be worn.
If possible, take up with sand, earth or other absorbing material. Transfer to an
appropriate container for proper disposal.
Page 5 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Section 7 Handling And Storage
HANDLING:
As with any industrial chemical, handle the product in a manner that minimizes
exposure to practicable levels. Prior to handling, consult Section 8 of this MSDS
to evaluate personal protective equipment needs. Follow all other standard
industrial hygiene practices.
Empty containers may contain product residue. All safety precautions taken
when handling this product should also be taken when handling empty drums
and containers. Keep containers closed when not in use.
Product residue in empty containers is combustible but will not readily burn.
Note, however, that excessive heating or cutting of empty containers may create
an ignition source sufficient to start a fire.
STORAGE:
Protect product quality by storing indoors and away from extreme temperatures.
Close all containers when not in use.
SPECIAL COMMENTS:
No further data known.
Section 8 Exposure Controls / Personal Protection
EXPOSURE GUIDELINES:
Component
Calcium Carbonate ACGIH TLV: 10 mg / m3 (total dust)
OSHA PEL: 5.0 mg / m3 (respirable dust)
Hydrocarbon Oil ACGIH TLV: 5.0 / m3 (as mist)
OSHA PEL: N/A
Teflon ACGIH TLV: N/A
OSHA PEL: N/A
Titanium Dioxide ACGIH TLV: 10 mg / m3 (total dust)
OSHA PEL: N/A
Clays ACGIH TLV: .1 mg / m3 (total dust)
OSHA PEL: 30 mg / m3 (total dust)
Page 6 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
ENGINEERING CONTROLS:
Normal general ventilation is expected to be adequate. It is recommended that
ventilation be designed in all instances to maintain airborne concentrations at
lowest practicable levels. Ventilation should, at a minimum, prevent airborne
concentrations from exceeding any exposure limits.
The user may wish to refer to 29 CFR 1910.1000(d) (2) and the ACGIH
"Threshold Limit Values for Chemical Substances and Physical Agents Biological
Exposure Indices" (Appendix C) for the determination of exposure limits of
mixtures. An industrial hygienist or similar professional may be consulted to
confirm that the calculated exposure limits apply.
PERSONAL PROTECTIVE EQUIPMENT:
Selection of personal protective equipment should be based upon the anticipated
exposure and made in accordance with OSHA's Personal Protective Equipment
Standard found in 29 CFR 1910 Subpart I. The following information may be
used to assist in PPE selection.
Eye Protection
Wear eye protection appropriate to prevent eye exposure. Chemical
safety glasses with side shields are recommended.
Skin Protection
Gloves are not normally needed during normal conditions of use. If health
effects are experienced, oil or chemical resistant gloves such as butyl or
nitrile are recommended.
Respiratory Protection
No special requirements under ordinary conditions of use with adequate
ventilation. A respirator may be worn to reduce exposure to vapors, dust
or mist. Select a NIOSH/MSHA approved respirator appropriate for the
type and physical character of the airborne material. A self-contained
breathing apparatus is recommended in all situations where airborne
contaminant concentration has not been confirmed to be below safe
levels. Respirator use should comply with the OSHA Respirator
Protection Standard found in 29 CFR 1910.134.
General Hygiene Considerations
Wash thoroughly after handling.
Page 7 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Section 9 Physical And Chemical Properties
Physical Appearance:............. : White Paste
Odor. ...................................... : Mineral Oil
Physical State......................... : Paste
Water Solubility....................... : Insoluble
Specific Gravity....................... : 1.50
Section 10 Stability And Reactivity
STABILITY:
This product is stable.
CONDITIONS TO AVOID:
Do not use in lines carrying liquid oxygen. Avoid sources of ignition.
INCOMPATIBLE MATERIALS:
This product is incompatible with strong oxidizing agents.
DECOMPOSITION PRODUCTS MAY INCLUDE:
Thermal decomposition products are dependent on combustion conditions. A complex
mixture of airborne solid, liquid, particulates and gasses may evolve when the material
burns. Combustion by-products may include:
oxides of carbon
aliphatics
hydrogen fluoride
carbonyl fluoride
POSSIBILITY OF HAZARDOUS REACTIONS:
This product is not expected to polymerize
Page 8 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Section 11 Toxicological Information
EYE EFFECTS:
No further toxicological data known.
SKIN EFFECTS:
No further toxicological data known.
ORAL EFFECTS:
No further toxicological data known.
INHALATION EFFECTS:
No further toxicological data known.
OTHER:
No further toxicological data known.
Section 12 Ecological Information
ECOTOXICOLOGICAL INFORMATION:
This product has not been evaluated for ecotoxicity. As with any industrial
chemical, exposure to the environment should be prevented and minimized
wherever possible.
ENVIRONMENTAL FATE:
The degree of biodegradability and persistence of this product has not been
determined.
Page 9 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
Section 13 Disposal Consideration
WASTE DISPOSAL:
Ensure that collection, transport, treatment and disposal of waste product and
containers complies with all applicable laws and regulations. Note that use,
mixture, processing or contamination of the product may cause the material to be
classified as a hazardous waste. It is the responsibility of the product user or
owner to determine at the time of disposal whether the product is regulated as a
hazardous waste.
Section 14 Transportation Information
U.S. DOT HAZARDOUS MATERIAL INFORMATION:
Not DOT regulated.
Section 15 Regulatory Information
FEDERAL REGULATIONS:
SARA 313:
This product contains NONE of the substances subject to the reporting
requirements of Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40 CFR Part 372.
CLEAN WATER ACT:
This product contains hydrocarbon oils and is subject to regulation by
Section 311 of the Clean Water Act and the Oil Pollution Act. Releases of
the product into or leading to surface waters must be reported to the
National Response Center at 1-800-424-8802.
CERCLA REPORTABLE QUANTITY:
Any components listed below have been assigned a reportable quantity
(RQ) by the Federal EPA. Releases of the product into the environment
that exceed the RQ for a particular component must be reported to the
National Response Center at 1-800-424-8802.
None to report
Page 10 of 10
Product Name......................... : RIDGID White Thread Sealant (with Teflon)
TOXIC SUBSTANCE CONTROL ACT:
The components of this product are listed on the TSCA Inventory.
OZONE DEPLETING SUBSTANCES:
This product contains no ozone depleting substances as defined by the
Clean Air Act.
HAZARDOUS AIR POLLUTANTS:
Any components listed below are defined by the Federal EPA as
hazardous air pollutants:
None to report
CANADA
DSL:
The components of this product are listed on DSL Inventory.
Section 16 Other Information
NFPA RATING:
Health Flammability Reactivity PPE
1 0 0 X
Prepared by:. . . . . . . . . . . . Ridge Tool Company
Issue Date: . . . . . . . . . . . . . January 5, 2006
Last Revision Date: . . . . . . . May, 2004
RIDGE TOOL BELIEVES THE STATEMENTS, TECHNICAL INFORMATION AND RECOM-
MENDATIONS CONTAINED HEREIN ARE RELIABLE BUT THEY ARE GIVEN WITHOUT WARRANTY
OR GUARANTEE OF ANY KIND, EXPRESSED OR IMPLIED, AND WE ASSUME NO RESPONSIBILITY
FOR ANY LOSS, DAMAGE OR EXPENSE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THEIR
USE.
|