CPD庐 NON-SHRINK GROUT PRE-MIX
(H.E.S - High Early Strength)
DESCRIPTION APPLICATION
CPD庐 Non-Shrink Grout Pre-Mix (High Early Strength) All surfaces that will be in contact with the grout must be
is used where a rapid strength gain structural grout is clean and free of grease, oil, standing water, laitance,
required. This is a pre-blended cement based grout loose material or any other contaminant that could impair
manufactured under strict quality control standards for substrate bond. Prior to grouting, foundation concrete
consistent uniform quality. Upon setting the grout remains should be roughened, cleaned and thoroughly wetted down
volume stable for permanent long term uniform structural for 12 hours. Free standing water should be blown clear
support. just prior to grouting. Use only as much water as is
consistent with flowability required. Mix thoroughly and
place within one hour. Keep grout agitated in mixer at all
WHERE TO USE
Used for grouting of: compressors, pumps, generators, times. Vibration is acceptable but avoid excessive use of
turbines, engines, etc. requiring high strength and vibration vibrators. As soon as grout sets, cure exposed surfaces
with CPD庐 Acrylic Cure & Seal or wet burlap. Ideal
dampening. Also use for anchor bolts, sole plates, dowels,
tanks, guard rails etc., as well as, for paper machines, grouting temperature 10掳C (50掳F) to 25掳C (77掳F). Cooler
rolling mills, ball mills and for grouting industrial temperatures will retard the rate of strength gain while
equipment in general. Also, use for bridge bearing seats, higher temperatures will accelerate strength gain.
power transmission towers and structural steel columns.
Mix Designs
Flowable - 4.0L water per 25 kg (1.06 U.S. gal/55lb).
BENEFITS
鈥? easy to place consistency Note: Do not exceed 4.0L (1.06 U.S. gal) of water per 25
鈥? high early strength - high ultimate strength kg (55 lb) bag of grout. Use only potable water for mixing
鈥? no bleed - can be vibrated grout.
鈥? non-metallic/no rusting
鈥? unaffected by freeze-thaw cycling/can be used for both LIMITATIONS
interior and exterior grouting Minimum grout depth is 25mm (1"). Extension of grout
鈥? contains no chlorides or reactive aggregates with aggregate will reduce flow and is generally only
acceptable with large volume placements. Use washed
and dry pea gravel or 12mm crushed stone for extending
PROPERTIES
the grout. Aggregate size should not exceed 25% of grout
Compressive Strength (ASTM C109-91) 23掳C (73掳F)
depth.
4L/25kg.(1.06 U.S. gal/55lb) Bag (Flowable )
? do not place grout where service temperatures exceed
1 day . . . . . . . . . . . . . . . . . . . . . . 41 MPa (5,945 psi) 177掳C (350掳F).
3 days . . . . . . . . . . . . . . . . . . . . . 55 MPa (7,975 psi) ? do not place grout where exposure to strong acids or
7 days . . . . . . . . . . . . . . . . . . . . . 62 MPa (8,990 psi) alkalis is evident (see data sheet for Cipadite庐 E-500
Epoxy Grout
14 days . . . . . . . . . . . . . . . . . . . . 71 MPa (10,295 psi)
? do not place grout where temperatures are below 4.4掳C
28 days . . . . . . . . . . . . . . . . . . . . 76 MPa (11,020 psi)
(40掳F) or above 32掳C (90掳F)
Set Time: 4L/25kg (1.06 U.S. gal/55 lb)
4-5 hours @ 23掳C (73掳F)
COVERAGE
0.013 m鲁 (0.46 ft鲁) per 25 kg (55 lb) bag at the maximum
The above information is representative of actual 4L (1.06 U.S. gal) water content.
production runs. Independent test results may vary from
the above by approximately 卤 10%. STANDARDS
Formulated to comply with U.S. Corps of Engineers
CRD-C621-92 and ASTM 1107-91.
0360-03-1105
PACKAGING
25 kg. (55 lb) multi-wall bag.
STORAGE
May be stored short term anywhere under tarp on pallets
as long as the product is kept dry. Dry heated warehouse
storage is recommended for extended storage.
SHELF LIFE
One year from the date of manufacture when stored in
original, unopened package and under normal warehouse
conditions.
SAFETY PRECAUTIONS
Consult Material Safety Data Sheet ( M.S.D.S.) for
specific instructions. MSDS # 18.
WARRANTY
The recommendations made and the information herein is
based on our own and independent laboratory experience,
and is believed to be accurate under controlled conditions.
However, no warranty or guarantee of accuracy is made
because we cannot cover every possible application of
product nor anticipate every variation encountered in
weather conditions, job-conditions, methods used and
types of surfaces on which the product is applied. The
users shall make their own tests to determine the suitability
of such products for any particular purpose.
CPD庐 makes no warranties with respect to this product,
expressed or implied, without limitation, the implied
warranties of merchantability or fitness for a particular
purpose.
CPD庐鈥? liability shall be limited in all events to supplying
s
sufficient product to re-treat and/or repair the specific area
to which CPD庐 product has been applied. CPD庐 reserves
the right to have the true cause of any difficulty determined
by accepted test methods. CPD庐 shall have no other
liability, including liability for incidental, consequential or
resultant damages, however caused, whether due to breach
of warranty, negligence, or strict liability.
THIS WARRANTY MAY NOT BE MODIFIED OR
EXTENDED BY REPRESENTATIVES OF CPD庐, ITS
DISTRIBUTORS OR DEALERS.
|