Search    ENTER KEYWORD
MSDS Material Safety Data Sheet
CAS

N/A

File Name: cpd_ca---03900_latex_adhesive.asp
CPD庐 LATEX ADHESIVE
DESCRIPTION PACKAGING
CPD庐 Latex Adhesive is to be used in conjunction with 208L drums (55 U.S. gal) - 234 kg/drum (520 lbs)
18.9L pails (5 U.S. gal) - 22 kg/pail (48.5 lbs)
cement based mortars or concrete wherever exceptional
3.79L poly bottle (1 U.S. gal)-(4/carton) 18 kg/(39.6 lbs)
bond strength and durability are the prime requirements.
1L poly bottle (0.26 US gal.)-(12/carton)
Always dilute with water. Use the diluted solution as the
mixing liquid in lieu of straight water.
CLEAN UP
Clean all tools with water shortly after use and before latex
APPLICATION
dries.
SURFACE PREPARATION
Concrete or other surfaces to be topped or parged must be
STORAGE
clean and structurally sound. Remove all laitance, weak,
Keep from freezing prior to use. Discard if allowed to
loose or faulty concrete. Remove all oil, grease, asphalt or
pass through 5 freeze-thaw cycles. If frozen, stir throughly
other foreign matter. Wet down substrate concrete prior to
prior to use. Store in a heated warehouse above 5掳C (41掳F).
application of topping but leave no free standing water.
Mix only the amount which can be placed within 30
minutes.
AS A BOND COAT:
Concrete base must be saturated surface dry (SSD) prior
SHELF LIFE
to slurry bond coat application. Dilute latex 1:1 with
Two years from date of manufacture if kept in original,
potable water. Mix type 10 cement with the diluted latex
unopened containers under normal warehouse conditions.
to the consistency of pancake batter (pourable). Mix ratio
is by volume 1.75 parts cement to 1.0 part diluted latex.
SAFETY PRECAUTIONS
Slurry will have a density of approximately 2.0 Kg/L
Consult Material Safety Data Sheet (M.S.D.S.)for specific
(16.7 lbs/US gal.) Coverage will vary depending on
surface profile. At 2mm thickness coverage will be .50m虏 instructions. MSDS # 54.
/L at 80 mils (20 ft虏/U.S. Gal.) Scrub in but do not leave
WARRANTY
standing pools of bond mortar. The bond coat must
The recommendations made and the information herein is
remain tacky until the overlay is placed. If topping is not
based on our own and independent laboratory experience,
over 陆", some latex should be used as an integral part of
and is believed to be accurate under controlled conditions.
the topping as outlined below.
However, no warranty or guarantee of accuracy is made
because we cannot cover every possible application of
AS AN INTEGRAL PART OF THIN SECTION
product nor anticipate every variation encountered in
TOPPING OR PATCHING MORTAR:
weather conditions, job-conditions, methods used and types
Dilute 1:1 with water. Add the solution to the patching
of surfaces on which the product is applied. The users shall
compound to produce a workable consistency. Place
make their own tests to determine the suitability of such
mortar quickly and trowel to the desired thickness. Avoid
products for any particular purpose.
overworking the final finish.

CPD庐 makes no warranties with respect to this product,
AS AN INTEGRAL PART OF THICK SECTION
expressed or implied, without limitation, the implied
CONCRETE TOPPING OR PATCHING
warranties of merchantability or fitness for a particular
OVERLAY:
purpose.
Thicker sections will also benefit by incorporating CPD
Latex into the mixing water. A 1:2 dilution with water can
CPD庐鈥? liability shall be limited in all events to supplying
s
be used as a mixing liquid for a 1:1/2:2 concrete/sand/pea
gravel mix or CPD庐 Patching Compound. Apply over sufficient product to re-treat and/or repair the specific area
to which CPD庐product has been applied. CPD庐 reserves
surfaces previously prepared with the bond coat as
the right to have the true cause of any difficulty determined
described above.
by accepted test methods. CPD庐 shall have no other
Topping prepared using CPD庐 Latex as an integral liability, including liability for incidental, consequential or
resultant damages, however caused, whether due to breach
part of the mix do not require most curing but a
of warranty, negligence, or strict liability.
membrane type cure is suggested after initial set.



0390-02-1105
THIS WARRANTY MAY NOT BE MODIFIED OR
EXTENDED BY REPRESENTATIVES OF CPD庐, ITS
DISTRIBUTORS OR DEALERS.

Search    ENTER KEYWORD
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP
NAMECAS
cpd_ca---03150_pvc1.asp N/A
cpd_ca---03300_floorhdr.asp 0330-01-0
cpd_ca---03390_acryliccssilane.asp N/A
cpd_ca---03390_chlorrubber.asp N/A
cpd_ca---03390_clrgrncuring.asp 0339-01-1
cpd_ca---03390_clrmason&conc.asp 0339-11-1
cpd_ca---03390_cs20wb.asp N/A
cpd_ca---03390_cs21.asp N/A
cpd_ca---03390_cs25.asp N/A
cpd_ca---03390_cssolvent.asp N/A
cpd_ca---03390_hardcure.asp 0339-13-1
cpd_ca---03540_topcrete_sl.asp N/A
cpd_ca---03600_cipaditee500grout.asp N/A
cpd_ca---03600_nsdrypk.asp 0360-04-1
cpd_ca---03600_nsfibre.asp N/A
cpd_ca---03600_nshes.asp 0360-03-1
cpd_ca---03600_nspremix.asp 0360-01-1
cpd_ca---03900_cipadite35.asp N/A
cpd_ca---03900_latexconad.asp N/A
cpd_ca---03900_latex_adhesive.asp N/A
cpd_ca---03920_10minuteset.asp 0392-02-1
cpd_ca---03920_20minuteset.asp 0392-01-1
cpd_ca---03920_aquacrete.asp N/A
cpd_ca---03920_fastcretehs.asp N/A
cpd_ca---03920_fastcreteoh.asp N/A
cpd_ca---03920_fastcreteultra.asp N/A
cpd_ca---03920_rapidcrete.asp N/A
cpd_ca---03920_rapidcrete_fiber.asp 0392-09-1
cpd_ca---03920_topcrete.asp N/A
cpd_ca---03930_cipadite20.asp N/A
cpd_ca---03930_cipadite25.asp 0393-05-1
cpd_ca---03930_cipaditegel15.asp 0393-03-1
cpd_ca---03930_epoxflexltgrout.asp N/A
cpd_ca---03930_superplug.asp 0393-01-1
cpd_ca---04060_stovefurnace.asp N/A
cpd_ca---07190_cipadames40.asp N/A
cpd_ca---07190_paver.asp N/A
cpd_ca---07190_saltguard.asp 0719-02-1
cpd_ca---07190_saltultra.asp N/A
cpd_ca---07920_cipadame-13.asp N/A
cpd_ca---07920_clscellfoam.asp N/A
cpd_ca---09600_cipadeckblsystem.asp N/A
cpd_ca---09600_cipadeckmembrane100.asp N/A
cpd_ca---09600_cipadeckmembrane60lt.asp N/A
cpd_ca---09600_cipadeckmr.asp N/A
cpd_ca---09600_cipadeckt-coat.asp N/A
cpd_ca---09600_cipaditecondprimer.asp 0960-05-1
cpd_ca---09600_cipaditeprimhi.asp N/A
cpd_ca---09600_cipaditest.asp N/A
cpd_ca---09600_cipadomeconductive.asp N/A

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com | Ads link:HBCCHEM.INC