Material Safety Data Sheet
Page 1 of 6 Issue date: February 2005
M BOND A-12 (Part B)
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Davidson Measurement Pty. Ltd
ACN: 005 031 961 ABN: 29 005 031 961
Phone: 03 9580 4366
Fax: 03 9580 6499
Email: info@davidson.com.au
Web: www.davidson.com.au
Address: 1-3 Lakewood Boulevard,
Braeside, Victoria, 3195.
Product Name: M BOND A -12 (Part B)
Manufacturer's Product Code: MGM005E
Use: Two component, 100 %-solids epoxy system for general purpose stress analysis.
2. HAZARDS IDENTIFICATION
HAZARDOUS ACCORDING TO EU CRITERIA
Hazar d Category: Irritant (Xi)
Hazard Classification: HAZARDOUS SUBSTANCE, DANGEROUS GOOD
RISK PHRASES
R36/38 Irritating to eyes and skin.
R43 May cause sensitisation by skin contact.
SAFETY PHRASES
S1/2 Keep locked up and out of reach of children.
S24/25 Avoid contact with skin and eyes.
S26 In case of contact with eyes, rinse immediately with plenty of water and contact a doctor or Poisons Information
Centre.
S36/37/39 Wear suitable protective clothing, gloves and eye/face protection.
S45 In case of accident or if you feel unwell, contact a doctor or Poisons Information Centre immediately and show
this container or label.
Poison Schedule: S5 [Aust]
This material is a Scheduled (S5) Poison and must be stored, handled and used according to the appropriate regulations.
Warning Statement:
Irritating to eyes and skin, prolonged skin contact will lead to skin sensitisation.
3. COMPOSITION / INFORMATION ON INGREDIENTS
SUBSTANCE NAME Proportion CAS Number
ALUMINIUM OXIDE 30 to 60 % 1344-28-1
TRIETHYLENETETRAMINE 1 to 10 % 112-24-3
TITANIUM DIOXIDE 1 to 5 % 13463-67-7
All other ingredients not hazardous according to EU Criteria.
4. FIRST AID MEASURES
Swallowed:
If swallowed, DO NOT induce vomiting. If victim is conscious, give 1 to 2 glasses of water to drink. Urgently transport
to hospital or doctor.
Material Safety Data Sheet
Page 2 of 6 Issue date: February 2005
M BOND A-12 (Part B)
4. FIRST AID MEASURES
Eye:
If material enters eyes, flush with plenty of water for at least 15 minutes, ensuring eye lids are held open. Immediately
transport to hospital or doctor.
Skin:
If material falls onto the skin, remove any contaminated clothing and wash skin thoroughly with water and soap.
Immediately transport to hospital or doctor.
Inhaled:
Remove victim to fresh air. Administer oxygen if breathing is difficult.
First Aid Facilities:
Eye wash fountain, safety shower and normal wash room facilities.
Advice to Doctor:
Treat symptomatically.
In case of poisoning, contact Poisons Information Centre
In Australia call Tel: 131126
In New Zealand Tel: 034747000
5. FIRE-FIGHTING MEASURES
Fire/Explosion Hazard
SUITABLE EXTINGUISHING MEDIA: Use dry chemical, carbon dioxide, foam or water fog.
UNUSUAL FIRE AND EXPLOSION HAZARDS: If tanks, drums or containers of this material are heated, they may
rupture and project corrosive liquids over a wide area.
HAZARDS FROM COMBUSTION PRODUCTS: Under fire conditions, toxic and corrosive fumes are emited. On
combustion or on thermal decomposition (pyrolysis), there will be a release of oxides of carbon and oxides of ntirogen.
PRECAUTIONS FOR FIRE FIGHTERS AND SPECIAL PROTECTIVE EQUIPMENT: Self-contained
breathing apparatus (SCBA) required for fire -fighting personnel. If possible to do so safely, shut off fuel to fire. Use
water spray to spray to cool fire-exposed surfaces and to protect personnel.
Hazchem Code: 2X [Aust]
Flammability:
This material is a COMBUSTIBLE material.
Flash Point: >93.3掳C
6. ACCIDENTAL RELEASE MEASURES
Emergency Procedures:
Corrosive material. DO NOT TOUCH THE SPILL UNLESS WEARING PROTECTIVE EQUIPMENT. Keep
unnecessary people away; Isolate hazard area and deny entry. Ventilate area. Wear suitable protective equipment as
outlined under personal protection in this MSDS.
Methods and Materials for Containment and Clean Up Procedures:
Throw vermiculite or diatomaceous earth (kitty litter) onto spill. DO NOT use sawdust. Use non-sparking tools or
HEPA vacuum system to pick up. Place into labelled drum(s) for later disposal.
Emergency information(Transport):
Dangerous Goods - Initial Emergency Response Guide (SAA/SNZ HB76:1997)
For TOXIC AND/OR CORROSIVE SUBSTANCES Guide No: 36
Material Safety Data Sheet
Page 3 of 6 Issue date: February 2005
M BOND A-12 (Part B)
7. HANDLING AND STORAGE
Precautions for Safe Handling:
Do not get in eyes. Avoid direct or prolonged contact with skin. Provide adequate ventilation.
Conditions for Safe Storage:
Keep containers tightly closed, when not using the product. Store in original packages as approved by manufacturer.
Store in an area that is dry and well ventilated area and away from ignition sources. Store away from strong alkalis,
acids and oxidizing agents. For further information please refer to the Engineering Controls of this MSDS.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Standards
No exposure standards are available for this product, however, the following exposure standards have been assigned by
[NOHSC] to the following components of the product:
ALUMINIUM OXIDE
[NOHSC]
[TWA]10 mg/m3
References: H
TITANIUM DIOXIDE
[NOHSC]
[TWA]10 mg/m3
References: H
Engineering Controls
Corrosive liquid. Maintain adequate ventilation at all times. In most circumstances natural ventilation systems are
adequate.
Personal Protection Equipment
GLOVES: Neoprene or nitrile.
EYES: Chemical goggles or spectacles with side shields to protect eyes.
RESPIRATORY PROTECTION: Avoid breathing of vapours. Select and use respirators in accordance with AS/NZS
1715/1716. The use of a half-face organic vapour with combined P1 (dust/mist) respirator with replaceable filters is
recommended. Filter capacity and respirator type depends on exposure levels and type of contaminant. If entering
spaces where the airborne concentration of a contaminant is unknown then the use of a Self-contained breathing
apparatus (SCBA) with positive pressure air supply complying with AS/NZS 1715 / 1716, or any other acceptable
International Standard is recommended.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Light gray paste with amine odour.
Boiling Point: Not available.
Vapour Pressure: Not available.
Specific Gravity: > 0.97
Flash Point: > 938 C
Flammability Limits: Not available.
Solubility in Water: Insoluble.
Other Properties
Evaporation Rate (BuAc = 1): <0.001
Material Safety Data Sheet
Page 4 of 6 Issue date: February 2005
M BOND A-12 (Part B)
10. STABILITY AND REACTIVITY
CHEMICAL STABILITY:
Stable under normal conditions of use.
CONDITIONS TO AVOID:
Ignition sources and mixing with incompatibles.
INCOMPATIBLE MATERIALS:
Strong alkalis, acids and oxidizing agents.
HAZARDOUS DECOMPOSITION PRODUCTS:
Decomposes on heating emitting oxides of carbon , oxides of nitrogen and noxious smoke.
HAZARDOUS REACTIONS:
Will not occur.
11. TOXICOLOGICAL INFORMATION
No adverse health effects are expected, if the product is handled in accordance with this Material Safety Data Sheet and
the product label. Symptoms and effects that may arise if the product is mishandled and overexposure occurs are:
ACUTE HEALTH EFFECTS:
Swallowed:
May cause irritation to mouth, throat and stomach with effects including pains in the stomach, which may lead to
nausea, vomiting and diarrhoea.
Eye:
Will cause irritation to the eyes, with effects including: tearing, pain, stinging and blurred vision.
Skin:
Will cause irritation to the skin, with effects including; Redness, itchiness, and drying/defatting.
Inhaled:
Mists from the product may cause irritation to the nose, throat and respiratory system with effects including: Cough,
discomfort, difficulty breathing and shortness of breath.
Chronic:
Prolonged or repeated skin contact may lead to dermatitis. Prolonged or repeated contact with this substance will cause
sensitisation by skin contact.
Triethylenetetramine:
Oral LD50(rat): 2,500 mg/kg
Irritation:
Skin - Standard Draize Test:
Dermal LD50(rabbit): 5 mg/24H;
REACTION: Severe
Eye - Standard Draize Test:
Rabbit(Eyes): 20 mg/24 H;
REACTION: Severe
Material Safety Data Sheet
Page 5 of 6 Issue date: February 2005
M BOND A-12 (Part B)
12. ECOLOGICAL INFORMATION
No information is available for this product, however, large quantities should not be discharged to waterways, sewers or
drains.
13. DISPOSAL CONSIDERATIONS
Refer to appropriate authority in your State. Dispose of material through a licensed waste contractor. Advise corrosive
nature. If large amounts of the product enter waterways, sewers or streams, immediately contact the Environmental
Protection Agency or your Local Waste Management Authority.
14. TRANSPORT INFORMATION
Road Transport
UN Number: 3261
Proper Shipping Name: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S.(Contains
TRIETHYLENETETRAMINE)
Dangerous Goods Class: 8
Packing Group: III
Label: Corrosive (C)
Air Transport
UN Number: 3261
Proper Shipping Name: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S.(Contains
TRIETHYLENETETRAMINE)
Dangerous Goods Class: 8
Packing Group: III
Label: Corrosive (C)
Sea Transport
UN Number: 3261
Proper Shipping Name: CORROSIVE SOLID, ACIDIC, ORGANIC, N.O.S.(Contains
TRIETHYLENETETRAMINE)
Dangerous Goods Class: 8
Packing Group: III
Label: Corrosive (C)
15. REGULATORY INFORMATION
Poison Schedule: S5 [Aust]
This material is a Scheduled (S5) Poison and must be stored, handled and used according to the appropriate regulations.
Inventory Status:
Australia (AICS) Y
United States (TSCA) Y
Europe (EINECS/ELINCS) Y
Y = all ingredients are on the inventory.
Material Safety Data Sheet
Page 6 of 6 Issue date: February 2005
M BOND A-12 (Part B)
16. OTHER INFORMATION
Date of Preparation:
Issue date: February 28, 2005 Supercedes: September 17, 2004 and March 8, 2000
Reasons for Update:
nd
1. Alignment with the 2 Edition of National Code of Practice for the Preparation of Material Safety Data Sheets
[NOHSC:2001(2003)].
2. Changes and /or addition made to all sections.
Key Legend Information:
NOHSC - National Occupational Health & Safety Commission [Aust]
SUSDP - Standard for the Uniform Scheduling of Drugs and Poisons [Aust]
TWA - Time Weighted Average [Int]
STEL - Short Term Exposure Limit [Int]
AICS - Australian Inventory of Chemical Substances
EPA - Environmental Protection Agency [Int]
NIOSH - National Institute for Occupational Safety and Health [US]
AS/NZS 1715 - Selection, use and maintenance of respiratory protective devices. [Aust/NZ]
AS/NZS 1716 - Respiratory protective devices. [Aust/NZ]
(SAA/SNZ HB76:1997) - Dangerous Goods - Initial Emergency Response Guide [Aust/NZ]
AS 1940 - The Storage and Handling of Flammable and Combustible Liquids [Aust]
Hazchem Code: Designation for fire fighters [Aust]
IATA - International Aviation Transport Authority [Int]
ICAO - International Civil Aviation Organization [Int]
IMO - International Maritime Organisation. [Int]
IMDG - International Maritime Dangerous Goods [Int]
United Nations Recommendations for the Transport of Dangerous Goods and Globally Harmonized System for the
classification and labelling of Chemicals. [Int]
EU - European Union [Int]
[Aust/NZ] = Australian/New Zealand
[Int] = International
[US] = United States of America
Principal References:
Information supplied by manufacturer.
Disclaimer
To the best of our knowledge, the information provided above meets the requirements of European Union directives for
hazardous substances which have been tested as a whole. The data provided on this Material Safety Data Sheet is from
manufacturers of the original components. All animal test data has been obtained from the public domain, NO
ANIMAL TESTS have been conducted by Davidson Pty Ltd. Davidson Pty Ltd specifically disclaims any and all form
of liability and/or responsibility for the application of this product.
END of MSDS
|